Chemistry & Chemical Reactivity
10th Edition
ISBN: 9781337399074
Author: John C. Kotz, Paul M. Treichel, John Townsend, David Treichel
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Textbook Question
Chapter 20, Problem 3PS
In the discussion on the composition of air, mention is made of the fact that water vapor may have a concentration as high as 40,000 ppm. Calculate the partial pressure exerted by water vapor at this concentration. Assume that this represents a situation with 100% humidity. What temperature would be needed to achieve this value? (See Appendix G.)
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
Humidity is the percentage of partial pressure of water in air over the total possible water in the air. On the first day of the spring semester the humidity was 72%, but it did not feel humid outside. Calculate the partial pressure of water in air at this time and justify why it did not feel humid. You may find it helpful to compare the first day of the spring semester to the first day of the fall semester, where the humidity was 89% on the first day of class.
The decomposition of 30.354 g of potassium chlorate yields solid potassium chloride and oxygen gas that is collected at 27.05°C and a pressure of 1.075 atm. The value for the gas constant, R, is 0.08206 L•atm/mol•K.
Write a balanced equation for the reaction.
What volume of oxygen gas is collected in this decomposition reaction?
What mass of potassium chlorate needs to decompose in order to produce 11.889 L of oxygen gas collected at the same temperature and pressure as the original experiment?
The atmosphere is a highly complex gaseous mixture that sustains life on Earth. Approximately 99% of the air is composed of nitrogen (N2) and oxygen (O2). The remaining 1% is made up of a variety of other gases, including carbon monoxide (CO), hydrogen (H2), and ammonia (NH3), among many others. Because most of the gases that comprise the atmosphere are present at very low levels (<0.002%), their quantities are often expressed in parts per million (ppm) or parts per billion (ppb) rather than as a percent.
Ozone (O3) is found in the troposphere at 2.5×10−6%. Convert this value to parts per million.
[O3]= _______ ppm
The atmosphere contains 2.9×10−7%2.9×10−7% nitrogen dioxide (NO2). Convert this value to parts per billion.
[NO2]= _______ ppb
Atmospheric methane (CH4) is present at 1983 ppb. Convert this value to a percentage.
[CH4]= _______ %
Chapter 20 Solutions
Chemistry & Chemical Reactivity
Ch. 20.7 - Prob. 1.1ACPCh. 20.7 - Prob. 1.2ACPCh. 20.7 - Prob. 1.3ACPCh. 20.7 - Prob. 1.4ACPCh. 20.7 - Prob. 1.5ACPCh. 20.7 - Assume that a sample of hard water contains 50....Ch. 20.7 - One way to remove the calcium carbonate residue in...Ch. 20 - Prob. 1PSCh. 20 - Prob. 2PSCh. 20 - In the discussion on the composition of air,...
Ch. 20 - Prob. 4PSCh. 20 - Prob. 5PSCh. 20 - Prob. 6PSCh. 20 - Prob. 7PSCh. 20 - Prob. 8PSCh. 20 - Prob. 11PSCh. 20 - Although there are a number of...Ch. 20 - Prob. 14PSCh. 20 - Prob. 15PSCh. 20 - Prob. 16PSCh. 20 - Which of the following is a renewable energy...Ch. 20 - Prob. 18PSCh. 20 - Prob. 19PSCh. 20 - Prob. 21PSCh. 20 - The enthalpy of combustion of isooctane (C8H18),...Ch. 20 - Energy consumption in the United States amounts to...Ch. 20 - Prob. 24PSCh. 20 - Prob. 25PSCh. 20 - Prob. 27PSCh. 20 - Prob. 30PSCh. 20 - In methane hydrate the methane molecule is trapped...Ch. 20 - Prob. 32PSCh. 20 - Prob. 33PSCh. 20 - Prob. 34PSCh. 20 - Prob. 35PSCh. 20 - Prob. 36PSCh. 20 - Prob. 37PSCh. 20 - Prob. 38PSCh. 20 - Dinitrogen monoxide, N2O (commonly called nitrous...Ch. 20 - Prob. 40PSCh. 20 - Prob. 41PSCh. 20 - Prob. 42PSCh. 20 - Prob. 43GQCh. 20 - Prob. 44GQCh. 20 - Prob. 45GQCh. 20 - Prob. 46GQCh. 20 - Prob. 47GQCh. 20 - Prob. 48GQCh. 20 - Prob. 49ILCh. 20 - Prob. 50ILCh. 20 - Define the terms renewable and nonrenewable as...Ch. 20 - Prob. 52SCQCh. 20 - Prob. 53SCQCh. 20 - Prob. 54SCQCh. 20 - Prob. 55SCQCh. 20 - What is the likelihood that hydrogen (H2) will...Ch. 20 - Prob. 57SCQCh. 20 - Which sulfur compounds are atmospheric pollutants?...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.Similar questions
- How does hydraulic fracturing differ from previously used techniques for the recovery of natural gas from the earth?arrow_forwardWhat possible uses exist for the natural gas liquids that are removed from natural gas during its processing?arrow_forwardOzone depletion at mid-latitudes may be caused by the denitrification of cold sulphuric acid droplets. Is this correct?please explain the reason.arrow_forward
- Each sketch below shows a flask with some gas and a pool of mercury in it. The gas is at a pressure of 1 atm. A J-shaped tube is connected to the bottom of the flask, and the mercury can freely flow in or out of this tube. (You can assume that there is so much more mercury in the pool than can fit into the tube that even if the J-tube is completely filled, the level of mercury in the pool won't change.) Notice also that in the left sketch the J-tube is open at its other end, so that air from the atmosphere can freely flow. On the other hand, in the right sketch the J-tube is closed at its other end, and you should assume there is no gas between the mercury and the closed end of the tube. To answer this question, you must decide what the mercury level will be when the mercury finally stops flowing in or out of the tube. By moving the sliders back and forth, you'll see different levels of mercury in the J-tube. Select the final correct level for each sketch. 1 1 2 I Don't Know open tube…arrow_forwardEach sketch below shows a flask with some gas and a pool of mercury in it. The gas is at a pressure of 0.5 atm. A J-shaped tube is connected to the bottom of the flask, and the mercury can freely flow in or out of this tube. (You can assume that there is so much more mercury in the pool than can fit into the tube that even if the J-tube is completely filled, the level of mercury in the pool won't change.) Notice also that in the left sketch the J-tube is open at its other end, so that air from the atmosphere can freely flow. On the other hand, in the right sketch the J-tube is closed at its other end, and you should assume there is no gas between the mercury and the closed end of the tube. To answer this question, you must decide what the mercury level will be when the mercury finally stops flowing in or out of the tube. By moving the sliders back and forth, you'll see different levels of mercury in the J-tube. Select the final correct level for each sketch. A open tube closed tube -…arrow_forwardGiven the following reaction of Ca(s) in HCl(aq): Ca(s) + 2 HCl(aq) --> CaCl2(aq) + H2(g) If 32.7g of calcium solid are placed in this reaction and at the end of the experiment, hydrogen gas is produced at 25.000C and with a pressure of 790. mmHg. Calculate the volume of hydrogen gas produced.arrow_forward
- The atmosphere of Mars is 96% CO2, with a pressure of approximately 6 * 10−3 atm at the surface. Based on measurements taken over a period of several years by the Rover Environmental Monitoring Station (REMS), the average daytime temperature at the REMS location on Mars is –5.7 °C (22 °F), while the average nighttime temperature is –79 °C (–109 °F). This daily variation in temperature is much larger than what we experience on Earth. What factor plays the largest role in this wide temperature variation, the composition or the density of the atmosphere?arrow_forwardWhen limestone (solid CaCO₂) is heated, it decomposes into time (solid CaO) and carbon dioxide gas. This is an extremely useful industrial process of great antiquity, because powdered lime mixed with water is the basis for mortar and concrete - the lime absorbs CO₂ from the air and turns back into hard, durable limestone. Suppose some calcium carbonate is sealed into a limekiln of volume 500. L and heated to 520.0 °C. When the amount of CaCO, has topped changing, it is found that 7.69 kg have disappeared. Calculate the pressure equilibrium constant K, this experiment suggests for the equilibrium between CaCO, and CaO at 520.0 °C. Round your answer to 2 significant digits. Note for advanced students: it's possible there was some error in this experiment, and the value it suggests for K does not match the accepted value. Xarrow_forwardWhen solid calcium carbonate is reacted with aqueous hydrochloric acid, the products of the reaction include aqueous calcium chloride, liquid water, and gaseous carbon dioxide. Calculate the volume of CO₂ gas (in L) collected over water at 25.0 °C when 25.1 g of calcium carbonate is added to excess hydrochloric acid if the total pressure is 911.0 mmHg. The vapor pressure of water at 25.0 °C is 23.8 mmHg.arrow_forward
- The composition of air is shown in the table below. Substance Composition of Dry Air Nitrogen 78.1% Oxygen 20.9% Argon 0.93% Carbon Dioxide 0.035% 13. A sample of air in a closed container is heated. (a) Would the total pressure of the air in the container increase, decrease, or remain unchanged? Explain your reasoning. (b) Would the percentage of oxygen in the air in the container increase, decrease, or remain unchanged? Explain your reasoning. (c) Would the partial pressure of oxygen in the container increase, decrease, or remain unchanged? Explain your reasoning. (d) What would be the partial pressure of nitrogen, PN,in a room in which the total air pressure was 0.987 atm?arrow_forwardTo prevent tank rupture during deep-space travel, an engineering team is studying the effect of temperature on gases confined to small volumes. What is the pressure of 2.00 molmol of gas DD measured at 251 ∘C∘C in a 1.75-LL container assuming ideal behavior?arrow_forwardWhen solid calcium carbonate is reacted with aqueous hydrochloric acid, the products of the reaction include aqueous calcium chloride, liquid water, and gaseous carbon dioxide. Calculate the volume of CO2 gas (in L) collected over water at 25.0 °C when 35.5 g of calcium carbonate is added to excess hydrochloric acid if the total pressure is 911.0 mmHg. The vapor pressure of water at 25.0 °C is 23.8 mmHg. Larrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Chemistry & Chemical ReactivityChemistryISBN:9781337399074Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage LearningChemistry & Chemical ReactivityChemistryISBN:9781133949640Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage LearningChemistry: The Molecular ScienceChemistryISBN:9781285199047Author:John W. Moore, Conrad L. StanitskiPublisher:Cengage Learning
- Chemistry for Engineering StudentsChemistryISBN:9781337398909Author:Lawrence S. Brown, Tom HolmePublisher:Cengage Learning
Chemistry & Chemical Reactivity
Chemistry
ISBN:9781337399074
Author:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel
Publisher:Cengage Learning
Chemistry & Chemical Reactivity
Chemistry
ISBN:9781133949640
Author:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel
Publisher:Cengage Learning
Chemistry: The Molecular Science
Chemistry
ISBN:9781285199047
Author:John W. Moore, Conrad L. Stanitski
Publisher:Cengage Learning
Chemistry for Engineering Students
Chemistry
ISBN:9781337398909
Author:Lawrence S. Brown, Tom Holme
Publisher:Cengage Learning
DISTINCTION BETWEEN ADSORPTION AND ABSORPTION; Author: 7activestudio;https://www.youtube.com/watch?v=vbWRuSk-BhE;License: Standard YouTube License, CC-BY
Difference Between Absorption and Adsorption - Surface Chemistry - Chemistry Class 11; Author: Ekeeda;https://www.youtube.com/watch?v=e7Ql2ZElgc0;License: Standard Youtube License