Answered: Due to the effect of the resistance of…

Due to the effect of the resistance of the cable connected to RTD, two-wire cables up to ……. meters and three-wire cables up to ……... meters are used in standard designs.

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter20: Special-purpose Outlets For Ranges, Counter-mounted Cooking Unit , And Wall-mounted Oven

Section20.2: Wall-mounted Oven Circuit And Free-standing Range

Problem 12R

See similar textbooks

Related questions

Q: The conductor diameter of a single-core underground cable is 1.0 cm and the insulation thickness is…

Q: A two conductor main A B, 500 m in length is fed from both ends at 250 volts. Loads of 50 A, 60 A,…

A: Given data, The value of area is A = 1 cm2. The value of resistivity for double conductor is ρL =…

Q: 3)- a)- What are the differences between doping and alloying? b)- What is the importance of lattice…

A: Here I have solved it.

Q: Explain the importance of high insulation resistance in high voltage systems. And also, Explain how…

A: Insulation resistance:The insulation resistance is the resistance in ohms or kilo-ohms of wires,…

Q: What is the meaning of the acronym, XLPE? A. EXTRA LOW POLYESTER EQUIPMENT B. CROSS-LINED POLYETHYL…

A: In this we will write about XLPE....

Q: Identify and describe the step-by-step process used to pull cable and also describe the step-by-step…

A: According to the question we have to Identify and describe the step-by-step process used to pull…

Q: What is the general equation for length of the cable S? e. What are the boundary conditions for…

Q: Sort out the materials (Insulation over the conductors) used in Low Voltage, Medium Voltage and High…

A: The satisfactory operation of a cable depends to a great extent upon the characteristic of…

Q: The figure below shows a ring distributor with interconnector BD. The supply is given at point A.…

Q: 4. Give the application of gases and gas mixtures as insulating medium in (a) High-Voltage…

A: The properties of gases and gas mixture like electronegative nature, non flammable, Thermally…

Q: A-) Explain with the help of diagrams the structure and operation of Hybrid (Magic) Tee

A: A tee in microwave use to connect a section of waveguide in series or parallel to the main…

Q: -advantages and disadvantages of Series and parallel connections of solar cell ? B-Which of the…

A: Series: S.NO Advantages Disadvantages 1 Voltage rating can be increased If any cell gets…

Q: Q2(b) Sketch and analyse the various methods to improve the string efficiency for an overhead line…

A: sketch and analyze the various methods to improve the string efficiency for an overhead line having…

Q: 4. What is the effect of laid cables in proximity to each other?

A: The effect of laid cables in proximity also called as proximity effect which means the interaction…

Q: 3. A two conductor main A B, 500 m in length is fed from both ends at 250 volts. Loads of 50 A, 60…

A: The solution can be achieved as follows.

Q: 1. Identify and describe the step-by-step process used to pull cable and also describe the…

A: The step-by-step process used to pull cable STEP 1: Check the Cable Width and Pipeline to make sure…

Q: You have an underground buried cable, suppose the cable is defected (open circuit) somewhere along…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: 2y what is Cofe and cladding? cloading?

Q: Estimate the relative error in measuring the unknown resistor when are using the Ammeter- Voltmeter…

A: Ammeter Voltmeter Method- The instruments required for this test are usually available in the…

Q: A- Discuss the following claimed arguments: 1- Guard rings are recommended in low voltage as…

A: 1) Guard ring Figure shows electrical equivalent circuit of insulator discs connected at tower.…

Q: What is the resistance of a copper bus-bar,as used in the power distribution panel of a high-rise…

A: To solve above problem, one should know about resistance calculation of a material. The resistance…

Q: What is the application and rating for extra super tension

A: Extra super voltage cables: These are used for applications with voltage requirement above 132 kV

Q: Predictive maintenance is to be applied to an industrial conveying system. a) Discuss and illustrate…

A: “Since you have asked multiple questions, we will solve the first question for you. If youwant any…

Q: Identify and describe the step-by-step process used to pull cable and also describe the step-by-step…

A: According to question we have to Identify and describe the step-by-step process used to pull cable…

Q: Discuss the method of reducing to an economically and operationally acceptable level the cost and…

Q: wire size no.12 awg

A: AWG or American Wire Gauge is the US standard measure for the diameter of electrical conductors AWG…

Q: List the minimum trade size of Type EMT for each of the following applications. Assume the use of…

A: Given, following applications Six 14 AWG ______ Six 12 AWG ______ Three 10 AWG ______ Four 8 AWG…

Q: 5. A 2-wire DC ring distributor is 375m long and is fed with 300V at point A. At point B, 200m from…

Q: Q1:- Estimate the relative error in measuring the unknown resistor when are using the…

Q: 2-Conductors which exhibit similar properties in all conditions are referred to as

A: The explanation is as follows.

Q: find the following parameters for the arcust below

Q: 2) You have an underground buried cable, suppose the cable is defected (open circuit) somewhere…

A: Cable: This is used to transfer the power for the purpose of the distribution. This is made of the…

Q: Identify and describe the step-by-step procedure that is used to draw cable, as well as the…

A: It is asked to describe the step-by-step procedure that is used to draw cable and to install cable…

Q: The conductor diameter of a single-core underground cable is 1.0 cm and the insulation thickness is…

A: The solution for the given is, ρ=5×104 Ω-cmρ=5×104×10-2 Ω-mρ=5×102 Ω-ml=2 Kml=2000 md=1…

Q: Determine the diameter in inches and in millimeters of circular cables having cross-sectional areas…

A: Since there are 4 sub-parts (a, b, c, d), as per the guidelines, in the following section, only the…

Q: Identify and describe the step-by-step process used to pull cable and the step-by-step process used…

A: 1. The first step is to to lay electrical conduction of 2mm thick and 25 mm in size for the PVC…

Q: 3. A two conductor main A B, 500 m in length is fed from both ends at 250 volts. Loads of 50 A, 60…

A: Solution Given data, R1 = ρLA, Where A=1…

Q: A single core cable has a conductor diameter of 1 cm and insulation thickness of 0.4 cm. If the…

Q: What is meant by a 4-wire 3-∅ system? What advantage does it possess

A: In this question we will write about 3 phase 4 wire system....

Q: Explain what it means to install "conductors in parallel," and give five conditions that must be…

A: Conductors in parallel have same voltage across each other. Conductors in parallel is installed to…

Q: Introduction about cables that related to voltage and application of thes

A: A power cable is an electrical cable that is made up of one or more electrical conductors that are…

Q: -Explain the importance of high insulation resistance in high voltage systems. And also, Explain how…

A: The high insulation resistance is crucial for installing the new equipment because it provides…

Q: A single core cable has a conductor diameter of 1 cm and insulation thickness of 0.4 cm. If the…

A: Given a single core cable has a conductor, Diameter, d1 = 1 cm Inner radius, r1 = 0.5 cm Insulation…

Q: what do you mean by super conductor

A: A superconductor is a material that does not offer any resistance when the current flows through it…

Q: The amount of heat generated in a conductor or other electrical equipment is a matter of how much…

A: From the Joule's law- Heat generated in the conductor- Heat generated g=I2Rt .....(a) where…

Q: 1. A wire used for wiring electric ranges, hot water heaters, stoves and hairdryers where both heat…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: What are the differences between wrinkle method vs DO meter (advantages vs disadvantages)?

A: Different energy sources are required in day to day life. These energy sources can be renewable or…

Concept explainers

Methods of Wiring

Electrical wiring is the way of integrating cables and wires to interconnected equipment such as fuses, switches, sockets, lights, fans, and so on to the main distribution board, which is a specific structure attached to the utility pole that ensures a constant power supply.

Question

12 - Due to the effect of the resistance of the cable connected to RTD, two-wire cables up to ……. meters and three-wire cables up to ……... meters are used in standard designs.
A) 10-150

B) 40-500

C) 50-195

D) 30-230

E) 200-1000

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Most residential general lighting circuits are wired with 14-AWG copper conductors and are protected by 15-amp circuit breakers. However, there are many electricians who install 12-AWG copper conductors and protect them with 20-amp circuit breakers. How will you know which conductor size and which circuit breaker size will be used for the general lighting branch circuits in the house you are wiring?
3. The zero sequence current is times the current in neutral wire.
what is the introduction for MEASUREMENT USING DC BRIDGES
The three bus-bar conductors in an outdoor sub-station are supplied by units of post insulators. Each unit consists of a stack of 3-pin insulators fixed one on the top of the other. The voltage across the lowest insulator is 8-45 kV and that across the next is 7-25 kV. Find the bus-bar voltage of the station.
SCR is the example of, power semi conductor devices. a. fully controlled O b. un controlled Oc. half controlled d. continuous
8. Parallel conductors must be installed in sizes no smaller thanA. 1/0.B. 2/0.C. 750 kcmil.D. 4/0.
A. Discuss the arcing phenomenon in a circuit breaker. B. Discuss the types of oil circuit breakers. With references
Can we select components voltage references randomly in order to write KVL? Why?
Calculate the following. a) Expected voltage at “A” with switch SW1 open. b) Expected voltage at “A” with switch SW1 closed.
3. The three bus-bar conductors in an outdoor sub-station are supplied by units ofpost insulators. Each unit consists of a stack of 3-pin insulators fixed one on the top of the other. The voltage across the lowest insulator is 8-45 kV and that across the next is 7-25 kV. Find the bus-bar voltage of the station. [38-8 kV]
Electrical Engineering What is the smallest square box that will accommodate four No. 12 conductors and four No. 10 conductors if a. These conductors are pulled through without a splice? b. These conductors are all spliced in the box?
Load in Figure 1 needs to be connected to Mains Switch Board (MSB) using multicore PVC cable. As a maintenance engineer, you need to proposed cable size for the load, Determine the following issues. 1) Calculate current demand for the circuit. 1) Detemine suitable MCCB (Model and nominal current rating) should be used to protect the load against over-current. im Propose suitable cable size for the load in Figure 1. iv) Calculate voltage drop of the proposed cable WITHOUT consider the cable reactance and voltage drop correction due to higher cable operating temperature v) Calculate voltage drop of the proposed cable BY consider the cable reactance and voltage drop correction due to higher cable operatıng temperature vi) If the multicore PVC eable is change into 3 single core PVC cables, what the suitable cable size. All other multicore cables not available. (25 + variable x) m (A) 30 m (B) (15 + variable b) m (C) Multicore PVC cable MCCB 95 kW. (400 + variable y) V. 0.85 p.f. Load MSB…