What is the smallest square box that will accommodate four No. 12 conductors and four No. 10 conductors if a. These conductors are pulled through without a splice? b. These conductors are all spliced in the box?

What is the smallest square box that will accommodate four No. 12 conductors and four No. 10 conductors if a. These conductors are pulled through without a splice? b. These conductors are all spliced in the box?

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter4: Conductor Sizes And Types, Wiring Methods, Wire Connections, Voltage Drop, And Neutral Conductor Sizing For Services

Section: Chapter Questions

Problem 29R: Wire connectors marked AL/CU are suitable for use with _____, _____, and _____ conductors.

See similar textbooks

Related questions

Q: Identify and discuss the factors that affect the resistance of a conductor. Based on these factors,…

A: Resistance is of a conductor is given by, R=ρlA Here, ρ is resistivity of conductor, A is cross…

Q: In terminating the coaxial cable, if the present procedure is to cut part of the braided shield and…

A: In this question we need to find what is the next procedure is to

Q: What is the smallest square box that will accommodate four No. 12 conductors and four No. 10…

A: conductor A conductor is any piece of material that easily allows heat or electricity to pass…

Q: Six 1/0 aluminum conductors are to be run in a conduit. Each conductor has type THWN insulation's,…

Q: what are Class 2 conductors made of?

A: Conductors are made up of metallic wires. Based on the number of strands present inside the…

Q: A cable wire maybe coaxial or twisted. Coaxial costs 25 centavos per meter while twisted wire costs…

A: Given, cost of coaxial wire = 25 centavos/metercost of twisted wire = 18 centavos/metersoldering…

Q: A load is located 100 ft from a 230V power supply and is wired with 4 AWG aluminum conductors. What…

A: Given Length L =100 ft V0ltage V =230 V

Q: Which of the following property the insulating material should possess to resist the flow of current…

A: Dielectric strength is defined as the electrical strength of an insulting material. In strong…

Q: What is the diameter in inches of a no. 26 AWG wire?

A: 26AWG = 0.0159 inches diameter wire .

Q: Justify: Mention and explain any 4 the differences between conducting and Non-conducting wires

Q: An aluminum bus bar conductor is 25 inches long, 6 inches width and 0.14 inches thick. If the…

A: Given: Aluminum bus bar conductor having Length, l=25 inches Width, W=6 inches Thickness, T=0.14…

Q: XLPE insulated high voltage underground cable will be installed along a street. The cable will then…

A: Given: XLPE insulated high voltage underground cable will be installed along a street. The cable…

Q: Fiber cable sheath is removed by a. Wire Stripper b. Jacket Stripper c. Miller Stripper d. Round…

A: The solution is given Answer is option b

Q: Calculate the resistance of 1 km long cable composed of 38 stands of similar copper conductors, each…

A: Given that, length L=1 km=1000 m Number of strands = 38 diameter D=1.32 mm =0.00132 m change in…

Q: 5.0 Question 5.1 5.2 Define the terms of electrical conductors? Define the term of cable insulator?

A: 5.1 Electrical conductors: In electrical engineering or in physics, an electrical conductor is a…

Q: Name two types of conductor insulation designed to be underground

Q: Name and explain the process to join any electrical component on strip board.

A: Stripboard: it is a circuit board that contains the parallel strips of the copper material on the…

Q: 4. What is the effect of laid cables in proximity to each other?

A: The effect of laid cables in proximity also called as proximity effect which means the interaction…

Q: 3. A two conductor main A B, 500 m in length is fed from both ends at 250 volts. Loads of 50 A, 60…

A: The solution can be achieved as follows.

Q: central outer conductor- -insulation Figure 6

A: For the domestic electric cable, the conductor must be metal while the insulator must be capable…

Q: What is the mean of wiring

A: Wiring is the term used for the supply system design, connection, and protection schemes employed…

Q: Give the raceway size required for each of the following conductor combinations: 1. Five, 10 AWG,…

A: Given information, Number of conductors=5. Type of insulation is THW. Size of wire=10 AWG. Raceway…

Q: What should be the CPC cable size for a line conductor of sizes up to 16mm² Same size 35 mm2 Half…

A: CPC cable size for the given line conductor of different sizes is given in accordance with table…

Q: QI/B: For underground cables, what is the purpose of using insulation part?

A: Given : In the question they want to know the purpose of the insulation part of the cables which…

Q: Mention any two factors that can influence the resistance of a metal conductor and explain how each…

A: The factors affecting the resistance of a metal conductor are 1. Conductivity 2. Length of the…

Q: Assuming copper, standard wire type, and normal temperature rating, what is the typical conductor…

A: There is a standard table to know the conductor size (in AWG) in American Wire Gauge, which gives…

Q: A 10 AWG copper conductor with type THW insulation is to be run in free air. What is the maximum…

Q: 3. A two conductor main A B, 500 m in length is fed from both ends at 250 volts. Loads of 50 A, 60…

A: From the given data in the question, A=1 cm2ρ=1.7×10-6Ωcm And the current flowing is,…

Q: What's the maximum number of 400 kcmil THHN conductors that can be installed in a 6 in. x 6 in.…

A: Given 400 Kcmil conductors Size of wire way = 6 in.× 6 in.

Q: 2-Conductors which exhibit similar properties in all conditions are referred to as

A: The explanation is as follows.

Q: What do you call device/tool used for measuring the galvanization or coating of grounding and tower…

A: These instruments square measure referred to as coating thickness gauge or gaussmeter. they're of…

Q: Per the NEC, which material must conductors be composed of, unless otherwise specified?

A: Conductor material

Q: Identify and describe the step-by-step procedure that is used to draw cable, as well as the…

A: It is asked to describe the step-by-step procedure that is used to draw cable and to install cable…

Q: Seven 8 AWG copper conductors are run in conduit. Each conductor has type THHN insulation. The…

A: Given Copper wire AWG =8 total number of copper wires =7 Type of insulation THHN Ambient temperature…

Q: How can lighting fixture be ground and what size of the conductor can be used

A: There are so many things that come in our mind which is related to light. It may be an artificial…

Q: A 10 AWG copper conductor with Type THW insulation is to rum in free air. What is the maximum…

A: The ampacity of a copper conductor with type THW insulation in free air is, The correction factor…

Q: Consider the three wires below, labelled X, Y. and Z, carrying various currents as indicated.…

Q: 3. A two conductor main A B, 500 m in length is fed from both ends at 250 volts. Loads of 50 A, 60…

A: Solution Given data, R1 = ρLA, Where A=1…

Q: what is the largest size conductor allowed to be used with a wirenut

A: Wire nut is an electrical connector used to connect two or more than two wire together. largest…

Q: A single core cable has a conductor diameter of 1 cm and insulation thickness of 0.4 cm. If the…

Q: Twenty-two 14 AWG copper conductors are run in conduit. Each conductor has type THHN insulation. the…

A: The given information is:

Q: When selecting conductors, from where is the motor full - load ampere rating to be taken

A: During the selection of the conductors, the motor full-load ampere rating is taken in the squirrel…

Q: Three 10 AWG, type THW conductors are to be installed between poles on individual insulators. What…

A: The conductor installed on the poles are mostly made up of aluminium. Ampacity is the maximum…

Q: NEC Article 800.44 states that where communication cables enter buildings, they shall_______. A.…

A: The correct option based on NEC Article 800.44 has been given in the following section:

Q: What layer is used to smoothen the irregularity of the surface of the conductors of Underground…

Q: Describe the various methods of laying underground cables. What are the relative advantages and…

A: Proper laying and attachment of fittings decide the reliability of underground cables. The fittings…

Q: Give a full presentation on types of insulating materials for cable?

Q: From time to time, depending on the conductor size, an electrician has to re-identify a conductor as…

A: The grounding conductor wrapped with green electrical tape provides a grounded connection to all the…

Q: Terminals of switches and receptacles marked CO/ALR are suitable for use with _______________,…

A: The term CO/ALR is abbreviated as Copper Aluminium Revised. The switches are rated as 15 A and…

Question

Electrical Engineering
What is the smallest square box that will
accommodate four No. 12 conductors and
four No. 10 conductors if a. These
conductors are pulled through without a
splice? b. These conductors are all spliced in
the box?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the smallest square box that will accommodate four No. 12 conductors and four No. 10 conductors if a. These conductors are pulled through without a splice? b. These conductors are all spliced in the box?
State the main constituent elements of electrical cables, as well as the materials from which they may be made. Describe the following designations: H05VV-U 1G4 mm? and LSXAV 3x16 mm?.
What size ungrounded conductors do we need for the 60 amp load? All conductors have typeTHHN insulation.
5. What is the resistance of a copper bus-bar with the dimensions shown figure below.
8. Parallel conductors must be installed in sizes no smaller thanA. 1/0.B. 2/0.C. 750 kcmil.D. 4/0.
12 - Due to the effect of the resistance of the cable connected to RTD, two-wire cables up to ……. meters and three-wire cables up to ……... meters are used in standard designs. A) 10-150B) 40-500C) 50-195D) 30-230E) 200-1000
2. A cable one mile long and 0.50 inch in diameter is composed of a steel core 0.25 inch in diameter and the is Ps and Pa 57.4 and 17.5 ohm Cmil/ft, outside shell is aluminum. The resistance of the cable is respectively a. 0.447 ohm c. 0.625 ohm b. 0.893 ohm d. 5.3 ohms
1. What should be the minimum cross-sectional area of each conductor in a two-core cable 100 m long to limit the total voltage drop to 4% of the declared voltage of 250V when the conductors carry 60A ? The resistivity of the conductor is 2·845 µΩ cm. ANS IS [0·34 cm2]
Why do metals make the best conductors?
RESEARCH ON THE FOLLOWING: 1. Electrical Conductors & Insulators 2. Wiring Methods include a reference:
Most residential general lighting circuits are wired with 14-AWG copper conductors and are protected by 15-amp circuit breakers. However, there are many electricians who install 12-AWG copper conductors and protect them with 20-amp circuit breakers. How will you know which conductor size and which circuit breaker size will be used for the general lighting branch circuits in the house you are wiring?
Find voltage drop and R total of a 2-wire circuit loaded to a 200 A, run in conduit between two panelboards 175 feet apart; supply is 240 V and conductors are 250 - KCMIL.