Concept explainers
A good quality camera “lens” is actually a system of lenses, rather than a single lens, but a side effect is that a reflection from the surface of one lens can bounce around many times within the system, creating artifacts in the photograph. To counteract this problem, one of the lenses in such a system is coated with a thin layer of material
Want to see the full answer?
Check out a sample textbook solutionChapter 3 Solutions
University Physics Volume 3
Additional Science Textbook Solutions
College Physics
Essential University Physics: Volume 2 (3rd Edition)
University Physics Volume 2
College Physics: A Strategic Approach (3rd Edition)
University Physics with Modern Physics (14th Edition)
Physics: Principles with Applications
- Figure P36.95 shows a thin converging lens for which the radii of curvature of its surfaces have magnitudes of 9.00 cm and 11.0 cm. The lens is in front of a concave spherical mirror with the radius of curvature R = 8.00 cm. Assume the focal points F1 and F2 of the lens are 5.00 cm from the center of the lens, (a) Determine the index of refraction of the lens material. The lens and mirror are 20.0 cm apart, and an object is placed 8.00 cm to the left of the lens. Determine (b) the position of the filial image and (c) its magnification as seen by the eye in the figure. (d) Is the final image inverted or upright? Explain.arrow_forwardCurved glassair interfaces like those observed in an empty shot glass make it possible for total internal reflection to occur at the shot glasss internal surface. Consider a glass cylinder (n = 1.54) with an outer radius of 2.50 cm and an inner radius of 2.00 cm as shown in Figure P38.105. Find the minimum angle i such that there is total internal reflection at the inner surface of the shot glass. FIGURE P38.105 Problems 105 and 106.arrow_forwardFigure P26.72 shows a thin converging lens for which the radii of curvature of its surfaces have magnitudes of 9.00 cm and 11.0 cm. The lens is in front of a concave spherical mirror with the radius of curvature R = 8.00 cm. Assume the focal points F1 and F2 of the lens are 5.00 cm from the center of the lens. (a) Determine the index of refraction of the lens material. The lens and mirror are 20.0 cm apart, and an object is placed 8.00 cm to the left of the lens. Determine (b) the position of the final image and (c) its magnification as seen by the eye in the figure. (d) Is the final image inverted or upright? Explain.arrow_forward
- The index of refraction for water is about 43. What happens as a beam of light travels from air into water? (a) Its speed increases to 43c, and its frequency decreases. (b) Its speed decreases to 34c, and its wavelength decreases by a factor of 34. (c) Its speed decreases to 34c, and its wavelength increases by a factor of 43. (d) Its speed and frequency remain the same. (e) Its speed decreases to 34c, and its frequency increases.arrow_forwardIn an experiment to monitor the Moon’s surface with a light beam, pulsed radiation from a ruby laser (wave = 0.69 mm) was directed to the Moon through a reflecting telescope with a mirror radius of 1.3 m. A reflector on the Moon behaved like a circular flat mirror with radius 10 cm, reflecting the light directly back toward the telescope on Earth.The reflected light was then detected after being brought to a focus by this telescope. Approximately what fraction of the original light energy was picked up by the detector? Assume that for each direction of travel all the energy is in the central diffraction peak.arrow_forwardAn optical cable in air is orientated horizontally. The cable has a core and a cladding layer. The index of refraction for the core is 1.3 and the index of refraction for the cladding layer is 1.2. A light ray enters the center of the cable with an incident angle ß=58°. The ray is subsequently refracted at the core-cladding interface and the cladding-air interface. The angle between the exit ray and the cable wall is a. What is the angle a? The index of refraction of air is 1. ←cladding -corearrow_forward
- White light is incident from air onto a triangular prism at a 45.0° angle with respect to the normal. It refracts into the prism then back into air as it exits the prism. From there, it enters a thick glass plate. The prism has an index of refraction of 1.49 for red light and 1.52 for violet light. The glass has an index of refraction of 1.61 for red light and 1.64 for violet light. What is the angular separation (dispersion angle) of the two noted colors while in the glass slab? Take nair = 1.00 for all wavelengths. white light 45 air prism 45 90 air 60 degrees violet light Glass red light angular separationarrow_forwardThe index of refraction of a certain glass is (1.44x10^0). What is the critical angle for total internal reflection at the glass-air interface? Express your result in degrees with three significant figures.arrow_forwardA ray of light strikes a flat glass block at an incidence angle of ?1 = 34.4°. The glass is 2.00 cm thick and has an index of refraction that equals ng = 1.20. A light ray incident on a glass block of thickness 2.00 cm is shown. The ray travels down and to the right and is incident to the top of the block at an angle ?1 to the normal of the surface. The ray inside the block moves down and to the right but at a steeper slope than the incident ray, making an angle of ?2 with the vertical. It is incident on the bottom surface of the block, making an angle of ?3 with the vertical, and exits moving down and to the right, at a less steep slope, making an angle of ?4 with the vertical. A dashed line extends from the original path of the ray down in the block and is shown to be a distance d from the ray that exits the glass block. d) The distance d separates the twice-bent ray from the path it would have taken without the glass in the way. What is this distance (in cm)? cm (e) At…arrow_forward
- A ray of light strikes a flat glass block at an incidence angle of ?1 = 34.4°. The glass is 2.00 cm thick and has an index of refraction that equals ng = 1.20. A light ray incident on a glass block of thickness 2.00 cm is shown. The ray travels down and to the right and is incident to the top of the block at an angle ?1 to the normal of the surface. The ray inside the block moves down and to the right but at a steeper slope than the incident ray, making an angle of ?2 with the vertical. It is incident on the bottom surface of the block, making an angle of ?3 with the vertical, and exits moving down and to the right, at a less steep slope, making an angle of ?4 with the vertical. A dashed line extends from the original path of the ray down in the block and is shown to be a distance d from the ray that exits the glass block. (a) What is the angle of refraction, ?2, that describes the light ray after it enters the glass from above? (Enter your answer in degrees to at least 2…arrow_forwardA fiber optic line is composed of a core with an index of refraction of 1.47 and cladding with an index of 1.36. Which one of the relations best describes angles of incidence q that will result in total internal reflection within the fiber optic line?arrow_forwardA light ray travels from air into glass (nG = 1.5). The ray strikes the glass at an angle of 30.0o. The angle the ray makes in glass is: Material x has an index of refraction of n = 2.0. The critical angle for this material for light going into air is:arrow_forward
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
- Physics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning