Interpretation:
The balanced equation for the given reaction has to be written and the amount of carbon needed to produce
Explanation of Solution
The balanced equation for the given reaction is,
The amount of carbon needed to produce
Substitute the given values in above equation to get moles of
From the above balanced equation, 1 mole carbon produced 1 mole
Hence,
The enthalpy change of the reaction is calculated by using Hess’s law,
Substitute the standard values in above equation to get enthalpy change of the reaction.
Enthalpy change of the reaction is
Entropy change of reaction is,
Gibbs free energy change of the reaction is,
The minimum temperature needed to make this reaction spontaneous at standard-state conditions
Hence,
Want to see more full solutions like this?
Chapter 19 Solutions
Chemistry: Principles and Practice
- Data are given in Appendix 1 for white phosphorus, P4(s). P4(g) has the following thermodynamic values: Hf=58.9kJ/mol , S=280.0J/kmol . What is the temperature at which white phosphorus sublimes at 1 atm pressure?arrow_forwardUse data from Appendix J to calculate the enthalpy change and the Gibbs free energy change for the reduction of chromium(III) oxide by aluminum.arrow_forwardUnder standard conditions, what reaction occurs, if any, when each of the following operations is performed? a. Crystals of I2 are added to a solution of NaCl. b. Cl2 gas is bubbled into a solution of NaI. c. A silver wire is placed in a solution of CuCl2 d. An acidic solution of FeSO4 is exposed to air. For the reactions that occur, write a balanced equation and calculate ,G, and K at 25C.arrow_forward
- Calcium metal can be obtained by the direct electrolysis of molten CaCl2, at a voltage of 3.2 V. (a) How many joules of electrical energy are required to obtain 12.0 1b of calcium? (b) What is the cost of the electrical energy obtained in (a) if electrical energy is sold at the rate of nine cents per kilowatt hour?arrow_forwardUse the standard free energy of formation data in Appendix G to determine the free energy change for each of the following reactions, which are run under standard state conditions and 25 C. Identify each as either spontaneous or nonspontaneous at these conditions. (a) MnO2(s)Mn(s)+O2(g) (b) H2(g)+Br2(l)2HBr(g) (c) Cu(s)+S(g)CuS(s) (d) 2LiOH(s)+CO2(g)Li2CO3(s)+H2O(g) (e) CH4(g)+O2(g)C(s,graphite)+2H2O(g) (f) CS2(g)+3Cl2(g)CCl4(g)+S2Cl2(g)arrow_forwardThe amount of sodium hypochlorite in a bleach solution can be determined by using a given volume of bleach to oxidize excess iodide ion to iodine; ClO- is reduced to Cl-. The amount of iodine produced by the redox reaction is determined by titration with sodium thiosulfate, Na2S2O3; I2 is reduced to I-. The sodium thiosulfate is oxidized to sodium tetrathionate, Na2S4O6. In this analysis, potassium iodide was added in excess to 5.00 mL of bleach (d=1.00g/cm3) . If 25.00 mL of 0.0700 M Na2S2O3 was required to reduce all the iodine produced by the bleach back to iodide, what is the mass percent of NaClO in the bleach?arrow_forward
- Chemistry: Principles and PracticeChemistryISBN:9780534420123Author:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward MercerPublisher:Cengage LearningChemistry by OpenStax (2015-05-04)ChemistryISBN:9781938168390Author:Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark BlaserPublisher:OpenStaxChemistry: An Atoms First ApproachChemistryISBN:9781305079243Author:Steven S. Zumdahl, Susan A. ZumdahlPublisher:Cengage Learning
- ChemistryChemistryISBN:9781305957404Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCostePublisher:Cengage LearningChemistry & Chemical ReactivityChemistryISBN:9781337399074Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage Learning