The minimum speed needed for the meteoroid not to collide with the earth.

Question

Want to see the full answer?

Answer 1

Question

Chapter 11, Problem 46P

To determine

The minimum speed needed for the meteoroid not to collide with the earth.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

While standing on the surface of a spherical asteriod of mass M and radius R., and astronaut thows a small rock straight upward away from the center. What is the minimum speed she must give to the rock to reach a height h above the surface. Assume that h is not small compared to R. The asteriod has no atmosphere and take the rock's mass to be small compared to M.

The radius Rh of a black hole is the radius of a mathematical sphere, called the event horizon, that is centered on the black hole. Information from events inside the event horizon cannot reach the outside world. According to Einstein's general theory of relativity, Rh = 2GM/c2, where M is the mass of the black hole and c is the speed of light. Suppose that you wish to study a black hole near it, at a radial distance of 48Rh. However, you do not want the difference in gravitational acceleration between your feet and your head to exceed 10 m/s2 when you are feet down (or head down) toward the black hole. (a) Take your height to be 1.5 m. What is the limit to the mass of the black hole you can tolerate at the given radial distance? Give the ratio of this mass to the mass MS of our Sun. (b) Is the ratio an upper limit estimate or a lower limit estimate?

In a faraway galaxy, a meteoroid is moving along a straight line that will pass a planet at a distance of 5RP from the planet's center, where RP is the planet's radius. What minimum speed must the meteoroid have if it is not to collide with the planet? (Assume the meteorite is detected when it is very far from the planet. Use the following as necessary: RP, MP for the mass of the planet, and G. Note that the P subscripts are uppercase. Write an expression in terms of v=)