Please show the full steps, thanks. Remove the 50 Q resistor in the given circuit and assume an operating frequency of 50 Hz and a load of100 Q connected between terminals a and b. In the given circuit x=8.000° A.160 Ωellww50 ΩIxw80 Ωа-obCompute the instantaneous power absorbed by the inductance at t = 2 ms. (Round the final answer to three decimal places.)The instantaneous power absorbed by the inductance at t= 2 ms is 1171.819 × W.

Answered: Image /qna-images/answer/66b59936-3d97-45fe-afc4-d5cc0bc11eb8.jpg

Answered: Remove the 50 Q resistor in the given…

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter3: Magnetic Starters

Section: Chapter Questions

Problem 30SQ

See similar textbooks

Similar questions

QUESTION 11 An inductor is connected in parallel with a 6540 resistor and a function generator. The applied voltage is 42V RMS and the total current is 67mA RMS. Find the magnitude of the current through the inductor. Enter your answer in the space provided. Round your answer to one decimal place. Your answer should be in mA but do not enter the unit.
7. In a pure inductive circuit, the phase angle between the voltage waveform and current waveform will havephase shift * 180 deg O deg 45 deg O 90 deg 8. Why do we say the "voltage across" or "the voltage with respect to?" Why can't we just say voltage? * Voltage is a measure of electric potential difference between two electrical points. O It's an electrical cliche. The other point could be negative or positive. None of the above.
2, In a circuit, the capacitance of a capacitor is 3.2 microfarads and the rms voltage of the generator is 50 volts. Frequency (a) 100 Hz and (b) what is the rms current in the circuit when it is 1000 Hz?
5) Find the reactance the inductance and impedance of the circuit. Calculate the current of this circuit and the sketch waveform of current and voltage. V1 10 V 60 Hz R1 m 100kQ 12 Vrms 1000 Hz 0° 6) Find the reactance the inductance and impedance of the circuit. Calculate the currents of this circuit R www 502 L L1 106mH eee 10 mH
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. Now what is the minimum AC voltage rating of each capacitor?
An rms voltage of 22.2 V with a frequencyof 1.00 kHz is applied to a 0.290-mH inductor. (a) What is the rmscurrent in this circuit? (b) By what factor does the current changeif the frequency of the voltage is doubled? (c) Calculate the current for a frequency of 2.00 kHz
1 Calculate average and RMS value of the voltage waveform given in Figure. 4V %3D t(ms)- 4V
Problem 5 Find the equivalent inductance Leg for the network shown below. 72 mH oooo Leg 49 mH elle elle 313 mH elle 64 mH elle 80 mH
Define the term Capacitance and Inductance? Capacitance: It is the amount of charge that is stored inside a capacitor at a given voltage. Inductance: It is defined as the property of a coil to resist any changes in electric current flowing through it. Mutual inductance happens when a secondary coil opposes current change in the primary coil. Mention what is the difference between generator and alternator? Both generator and alternator work on the same principle they convert mechanical energy into electrical energy. Generator: It converts induced emf (Electro Motive Force) into direct current, where it based on stationary magnetic field and revolving conductor which rolls on the armatures with slip rings and brushes riding against each other. Alternator: It has rotating magnetic and stationary armature for high voltage and stationary magnetic field and a rotating armature for low voltage
a)For the inductive element of Figure 1 , the current in phasor form is B) the voltage in phasor form for figure 1 is C)the impedance of the inductor for figure 1 is
2. Refer to the Figure 2. a) Determine the total impedance of the circuit in polar form. b) Determine the voltage v(t) and current i(t) sinusoidal forms. Sketch one cycle of the waveforms in the same x-axis. Clearly indicating the peak value and the period of each waveform and the phase difference (in milliseconds) between the two waveforms. c) Determine the values of resistance R and inductance L. d) Determine the phasors V,, VR and Vc. e) Sketch the phasor diagram showing Vs, Vr, Vr, Vc and I.
An inductor of value 5.6 H is connected across 240 V, 109 Hz supply. Then the value of inductive reactance is ohms. 7666.62 1220.80 1916.66 3836.80

SEE MORE QUESTIONS

Recommended textbooks for you

Electric Motor Control

Electrical Engineering

ISBN:

9781133702818

Author:

Herman

Publisher:

CENGAGE L

Electric Motor Control

Electrical Engineering

ISBN:

9781133702818

Author:

Herman

Publisher:

CENGAGE L

SEE MORE TEXTBOOKS