An rms voltage of 22.2 V with a frequencyof 1.00 kHz is applied to a 0.290-mH inductor. (a) What is the rmscurrent in this circuit? (b) By what factor does the current changeif the frequency of the voltage is doubled? (c) Calculate the current for a frequency of 2.00 kHz

An rms voltage of 22.2 V with a frequencyof 1.00 kHz is applied to a 0.290-mH inductor. (a) What is the rmscurrent in this circuit? (b) By what factor does the current changeif the frequency of the voltage is doubled? (c) Calculate the current for a frequency of 2.00 kHz

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 7RQ: An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a...

See similar textbooks

Related questions

Q: The voltmeters in the figure measure RMS voltages. If V, = 23 V and V, = 14.5V what is V3? R V V3 23…

Q: resistor of 20Ω, an inductor of 0.012H, and a capacitor of 90 μF are connected in series with a…

A: In this question we will find phase between v and I in series RLC circuit..

Q: Inductance does not change with AC frequency. Select one: True O False

A: An inductor is basically an energy storing device, which stores energy in the magnetic field. Let us…

Q: Calculate (a) the rms voltage drop across the capacitor, (b) the rms voltage drop across he inductor…

A: The given circuit has two sources-one DC source and one AC source. We will apply superposition rule…

Q: An inductor and a resistor are connected in series with a function generator. The voltage across the…

A: In series circuit of resistor and inductor, the expression for magnitude of RMS voltage supplied…

Q: Determine the resistance, inductance and capacitance in series for each of the following impedances…

A: we need to find out resistance, inductance and capacitance for given impedances.

Q: he waveform displayed on an oscilloscope is as shown in Figure . Determine: i) amplitude of waveform…

Q: The waveform displayed on an oscilloscope is as shown in Figure . Determine: (1) amplitude of…

Q: connected in parallel. This combination is then placed in series with a capacitance. Compute the…

Q: QUESTION 3 An inductor, a capacitor, and a resistor are connected in parallel with a function…

Q: An alternating current is given by the expression i = 200 sin (314t + T/6) amperes. The maximum…

A: Given: Expression for alternating current i=200sin314t+π/6 amperes

Q: The waveform displayed on an oscilloscope is as shown in Figure . Determine: (i) amplitude of…

Q: Calculate the rms value of A.C. as shown in the figure. 13 2A- -2A 12

A: we need to find out rms value of of given A.C.

Q: Calculate the voltage vo(t) across the capacitor and the current i(t) through the capacitor as shown…

A: To solve above problem, one should have basic idea about working of AC circuits. Above given circuit…

Q: A series circuit has 99.0 Ω of resistance and 88.0 Ω of inductive reactance. An ac rms voltage of…

A: find explanation below

Q: An RC series circuit is connected to a 240-V, 60-Hz power source. An ammeter indicates a current of…

A: An RC series circuit is connected to a 240-V, 60-Hz power source. An ammeter indicates a current of…

Q: A pure sinusoidal current is being rectified. For the given maximum value of half wave rectified…

A: Given: Half wave rectified current is 50 A i.e. for half wave rectification Irms=50 A

Q: Find the RMS value.

Q: An AC source has an output rms voltage of 78V at a frequency of 80Hz. If the source is connected…

Q: A series RL combination in an AC circuit has R = 100 and X = 120. A capacitor is connected across…

Q: S Two sinusoidal voltages of maximum values 120 V and 80 V, respectively but differing in phase by…

A: We need to find out the equivalent voltage for given voltages .

Q: 6. A resistance of 30 ohm is in series with an inductance of 30 mH. What is the frequency in Hz so…

A: As per our company guidelines we are supposed to answer only first question kindly repost other…

Q: What is value of RMS current if voltage is 10sin(100t) Volt and load is 10mH inductor.

A: v(t)= 10sin (100t) Volt XL=jωL XL=j(100)(0.01) Ω XL=j1 Ω

Q: Example: prove that the average value of the sinusoidal current shown below: Im Is equale to 21m/ A…

Q: QUESTION 3 An inductor, a capacitor, and a resistor are connected in series with a function…

Q: A 50µF capacitor is connected across a 230V, 50 Hz supply. Calculate the RMS value of the current…

Q: Given A = 10 cos (5t+60). Find i)the peak value of A ii) the A frequency in Hz iii) the A in sin…

Q: An AC series circuit has a load of 100 ohms, 0.5 henry and 10 millifarad and being supplied by a…

A: Given R = 100 ohm, L = 0.5 H, C = 10 mF

Q: When a load is connected to a power line with a frequency of 230V (rms) 50 Hz, it draws 4250 W of…

A: Given Vs=230V f=50Hz PL=4250 watt power factor,cosφ=0.85 → φ=31.78° So reactive power of load,…

Q: 5. A capacitor of 80 microfarad is connected to a 120 V, 75 Hz source. Determine (a) the capacitive…

Q: A 120V adjustable frequency ac source is connected in series with a resistor, an inductor, and a…

Q: where x= RMS value of the signal to be quantized x. 2x max 2

Q: 4. The capacitance required to correct the power factor to unity.

A: Power triangle is given as ; From triangle , Therefore initial power factor is 0.833

Q: QUESTION 24 An inductor of inductance 40 ohms in series with a 30-ohm resistor is connected to an AC…

A: For Questions number 14 to 17, kindly mention the "previous question". Here we are solving question…

Q: The waveform displayed on an oscilloscope is as shown in Figure . Determine: (i) amplitude of…

Q: 3. Replace the DC source by an ac source with an rms value of 12 V. Connect it across the same bulb.…

Q: QUESTION 4 A resistor, a capacitor, and an inductor are connected in series with a function…

Q: Calculate the r.m.s. value of a sinusoidal current of maximum value 20 A.

A: Given, Maximum value of sinusoidal current (Im)= 20 Amp

Q: 13. A 200mH inductor and an 80 ohm resistor are connected in parallel across a 100 V rms, 60 Hz…

Q: 169sin 377t a) What is the RMS value? b) What is the Average value?

A: Given: Let V=169sin 377t

Q: Below are two voltage patterns measured from an oscilloscope. The voltage stage of the CHI probe is…

Q: When a load is connected to a power line with a frequency of 230V (rms) 50 Hz, it draws 4500 W at a…

A: We will find out reactive power ,from reactive power we will find capacitance .

Q: Choose the correct statement for pure capacitor connected across single phase AC supply. O a. None…

A: Pure capacitor

Q: Resistor R and a resistanceless coil L1 = 83.8 mH are connected in series to an AC source with…

A: The given circuit is the RL circuit: The current I can be calculated as: Irms=VrmsR2+XL2

Q: For the current waveform that shown in Figure below Find:- 1). Average value 2). R.M.S value 3).…

Q: 3. Replace the DC source by an ac source with an rms value of 12 V. Connect it across the same bulb.…

A: Vrms=12V f=60Hz Rlamp=12 ohms.

Q: Due to mutual inductance between two coils, there is an induced emf in one coil due to a change in…

A: Answer:True

Q: A-coil has a resistance of 30Ω and an inductance of 0.5H. If the current flowing through the coil is…

Q: A load connected to a 210 V rms 50 Hz power line It draws 7 kW of power with a back power factor of…

Concept explainers

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.

Question

An rms voltage of 22.2 V with a frequency
of 1.00 kHz is applied to a 0.290-mH inductor. (a) What is the rms
current in this circuit? (b) By what factor does the current change
if the frequency of the voltage is doubled? (c) Calculate the current for a frequency of 2.00 kHz

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

Step 8

Trending now

This is a popular solution!

Step by step

Solved in 8 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
60. Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V de voltage source. 61 Datermine the volto in the girRuit F Figura 1 1?
The maximum value of sinusoidal voltage is given by Vm= 1 V, What is the value of Peak to Peak voltage?
Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…
In an experiment, the function generator is adjusted to generate a square voltage at a certain frequency. This voltage is displayed on an oscilloscope and the reading is 16 V peak-to-peak. The rms value of this voltage is .What will be the rms value of this voltage if the frequency is doubled? Select one: O 16 Vrms 32 Vrms O 8 Vrms . 8 Vrms ..... O 5.657 Vrms 5.657 Vrms ....... O 8 Vrms . 16 Vrms O 16 Vrms 8 Vrms ......
QUESTION 3 An inductor, a capacitor, and a resistor are connected in parallel with a function generator. The inductor draws 100mA RMS, the capacitor draws 150mA RMS, and the resistor draws 200mA RMS. Find the magnitude of the total current. O 450mA RMS O 544mA RMS O 352mA RMS O 206mA RMS
Find the RMS current from 30⁰ to 180⁰ at Im = 10 Amperes
A pure sinusoidal current is being rectified. For the given maximum value of half wave rectified current is 50 A, then the rms value of full wave rectification will be 50 (a) 100 (b) - - (c) 100 A (d) 70.7 A
The peak to peak distance of a sinusoidal waveform displayed on a C.R.O. screen is 9 cm and the 'volts/cm' switch is on 25 V/cm. The peak voltage is given by O 2.78 V O 159.07 V O 112.50 V O 225.00 V
4) Determine the value of voltage across resistor and capacitor5) Convert in rms values
Determine the rms voltage across each resistor and the rms current. Make sure to graph the rms voltage and current.
What is the ripple factor of a DC signal having ripple voltage of 2 V and a DC voltage of 50 V? Answer in percentage % O 8% O 1.2% O 2.83% O 4.0%