QUESTION 2 There are 30 ticket vending machines to service an hourly passenger demand of 8,750. How quickly must the process of purchasing tickets occur? Tickets are mandatory for all passengers. Provide your response to the nearest tenth of a second.
Q: 3. Calculate the moment of inertia of the shaded area about the x and y axes. 100 100 50 50 75…
A:
Q: The diameter and height of a right circular cylinder are 3 cm and 4 cm, respectively. The absolute…
A:
Q: 2 Plot the given points on the grid and draw the view. + + 4 + Point A B с D E F G H I J K L X 0 0…
A: To plot the points and to draw the view
Q: PROBLEM 3 Calculate the shearing stress of the clevis shown and the bearing stress of the yoke. The…
A:
Q: A floor has to carry a load of 12 kN/m². The floor is supported on rectangular joists each 100 mm…
A: Given data- Load w=12 kN/m2, Rectangular joists 100 mm wide, 300 mm deep and 4 m long, Maximum…
Q: Determine the force in each member of the loaded truss shown using methods of joints.
A:
Q: There is no service flow rate for level of service F. O True O False
A: Level F had a congested flow with breakdown of flow capacity drops hence has the quality of service…
Q: H.W.7 For a rectangular beam of 250*500 mm, 5020 mm for main steel reinforcement and $10 mm for…
A: Given: Rectangular beam=250×500 mm To find: Maximum spacing between bars
Q: 3 m 2 m 2m 4 m Ground surface Clay layer Water table A Sand layer Clay layer 71 = 16.15 kN/m³ 22=…
A:
Q: W 1 -L/2 -L/2 W Figure 20.4 Fixed-end moment expressions wL²/12+ Pab²/L² wL²/20 zobac 23wL²/960…
A:
Q: If the water table was found in the interface of clay and sand instead (at 5m depth), graph the…
A:
Q: Two steel plates (A572, Fy = 50 ksi) are welded together to form an inverted T-beam. Determine the…
A:
Q: QUESTION 9 One lane of a uniform section of highway has an optimum density of 70 vehicles per mile…
A:
Q: Calculate K for the soil tested in the figure. Assume the cross-sectional area of the sample is 14…
A:
Q: 1. Three forces are applied to the bar shown. Calculate principal stresses and maximum shearing…
A: Solution:- Given data:- P = 50 kips, Vx = 6 kips Vz = 2 kips MX = (10.5-2)(6) = 51 kips.in MZ =…
Q: Q8. Determine the deflection of point B on the steel beam with 1 = 80x106 mm4 and E = 200 GPa. [Ans.…
A: Given data: I=80×106 mm4E=200 GPa
Q: The cross-section of the rough-cut timber beam shown is loaded with (W) over six feet of the span.…
A:
Q: Find the maximum live load (P₁) applied on the beam shown below if f = 25 MPa and = 400 MPa. fy 1.5…
A: Given: fc = 25 MPa fy = 400 MPa b = 300 mm h = 500 mm stirrups = 10 mm Main bars = 2-#16 mm and…
Q: QUESTION 3 If the free flow speed is measured in the field, you do not estimate fi BFFS and…
A: If the free flow speed is measured in field it requires estimation from BFFS and adjustment for lane…
Q: QUESTION 7 An old divided 6-lane (3 lanes each direction) highway has 11 ft lanes and obstructions…
A: Given data: 6-Lane divided highway (3 lanes in each direction) Lane width, w=11 ft Right side…
Q: A cylindrical tank 10 ft. high and 4 ft in diameter placed so that its axis is horizontal. It is…
A:
Q: What is the service flow rate (pcphpl) for a freeway segment that has a free flow speed of 55 mph if…
A:
Q: How would you graph this on V (shear) linear graph and moment graph parabolic?
A:
Q: Calculate the pressure difference between points A and B. The specific gravity of the oil is 0.85
A: Given Data Specific gravity of oil (Goil) = 0.85 Find pressure difference between point A and B.…
Q: Determine the deflection at the point of application of the concentrated load. Determine the…
A: Given Data a. Determine the deflection at the point of application of the concentrated load. b.…
Q: 3. A lot boundary was measured from point A to B with a bearing of N 30°35' E. Compute for the…
A:
Q: What is the seepage rate for hte following flow net if k=2.5 X 10-5m/s . See below. A. 2.1 X…
A: Data given Find: seepage rate for the following flow net
Q: 3. A lot boundary was measured from point A to B with a bearing of N 30°35' E. Compute for the…
A:
Q: 3' ******* 100 lb/ft 3' ……...... 4' ... 2' 100 lb
A:
Q: b. Determine the spacing of pipe drain from following data. Annual rainfall = 1000mm Drainage…
A: Pipe Drain: A pipe drain or a drainage pipe is used to transfer the wastewater collected from the…
Q: The construction features of a cantilever truss bridge are shown in Fig. Here it can be seen that…
A:
Q: What is the force for the first story for column line A (kips , tension = positive) What is the…
A: Given: Line A, B, C To find: Force
Q: Compute L, T, E, M, LC, R, and stations of the PC and PT for the highway curve with Da = 6 ∘00′, I…
A: Highway Curve: The two lines on a roadway are connected with an arc. This connected arc of two…
Q: Beam 9: (P = 26 KN - L = 2.0 metres) For the given cross section of the beam, find the magnitude of…
A:
Q: Find the vertical deflection of the joint C in a two-member truss as shown in Fig. 2. The area of…
A: Given: Two member truss Area of BC is 1600 and of AC is 2000mm² Required: Vertical deflection of…
Q: Oil with a free-stream velocity of 2 m/s flows over a thin plate 2 m wide and 2 m long. Calculate…
A:
Q: L The acceleration of at 30 m/s On a boat produces an 10 m/s². If the boat is travelling motor is…
A:
Q: Determine the y-coordinate (y-bar) of the centroid of the shaded area. (Use 3 decimal places) P=136…
A:
Q: A load of 2100 N is dropped axially on a closed-coiled helical spring from a height of 240 mm. The…
A: Given data:- The given value of load is, P=2100 N The given number of coils, n=22 The given mean…
Q: The discharge through a weir is 1.5 m³/s. Find the discharge through the model of the weir if the…
A: Given- Discharge through weir(prototype) Qp=1.5 m3/s, Horizontal dimension of model =150 of…
Q: 1.56 2.56 y -26 -26 26 b -36 26
A:
Q: An AISI 4142 steel bar, Q&T at 800°F exhibits Syt = 235 kpsi, Syc = 285 kpsi, and &f= 0.07. Given:…
A: Given-
Q: A concrete column reinforced with steel rods has a square section of 250 mm by 250 mm and can…
A: Given data:- The given square section is, 250 mm×250 mm The given support of a load is, 700 kN the…
Q: Depth (ft) 0-10.0 10.0-16.5 16.5-35.0 35.0-65.0 Soil classification Silty sand (SM) Sandy silt (ML)…
A: Given: Depth=15 ft To find: Qcb
Q: A- An experimental setup in the laboratory is shown. Two 50 mm diameter soil samples A and B are…
A: Given data: kA=2kB Diameter = 50 mm Volume of water collected = 200 ml Time (t) = 5 min
Q: QUESTION 5 Based on a linear speed-density model, with a jam density of 120 vpmpl and a free flow…
A:
Q: A sample of silty clay has a volume of 14.88 cm³, a total mass of 28.81 gm, a dry mass of 24.83 gm…
A: Given: Volume, VT=14.88 cm3 Total mass, MT=28.81 gm Dry mass, Md=Ms=24.83 gm Specific gravity of…
Q: 18m 10KN 20KN 22kN 28kN 2m 3m 3m 2. Solve for the absolute maximum moment and absolute maximum shear…
A:
Q: Determine the equivalent state of stress on an element at the same point oriented 60° clockwise with…
A: Given : Determine the equivalent state of stress on the element ?
Q: QUESTION 2 طار How many diverging conflicts are present at a 4-leg intersection where each leg is a…
A: The 4-leg intersection where each leg is a single lane approach has 4 diverging conflicts.
Step by step
Solved in 2 steps with 2 images
- There are 30 ticket vending machines to service an hourly passenger demand of 8,750. How quickly must the process of purchasing tickets occur? Tickets are mandatory for all passengers. Provide your response to the nearest tenth of a second.Pls help me answer all the questions and show neat and whole solution. I hope you can help me I have only one remaining ticket left.Multinomial Logit Model - Sample Problem Let the number of trips from zone i to zone j is 5000, and two modes are available which has the characteristics given in below. Compute the trips made by the three modes and the fare required to travel by each mode. coefficient car bus train ti twalk tij Fij 0.03 0.04 0.06 0.1 20 18 30 6 12 5 10 3 2 Pij 0.1 Cij = a₁tij + a₂tij + asti; +astnij + a5 Fij + a60j + d
- Admission tickets to a theatre were P60 for adults and P25 for children.Receipts for the day showed that 28 persons attended and P1400 wascollected. How many children attended the day?what is the hotels estimate of no shows plus cancellations and early departures, which is determined by taking the historical no-show and cancellation information that is being tracked by the hotel and comparing it to the current booking pace activity a) overbooking analysis b) wash factor c) walking d) displacement analysis e) none of the answersTwo one-man barber shops sit side by side in DunkirkSquare. Each can hold a maximum of 4 people, and anypotential customer who finds a shop full will not wait for ahaircut. Barber 1 charges $11 per haircut and takes anaverage of 12 minutes to complete a haircut. Barber 2charges $5 per haircut and takes an average of 6 minutes tocomplete a haircut. An average of 10 potential customersper hour arrive at each barber shop. Of course, a potentialcustomer becomes an actual customer only if he finds thatthe shop is not full. Assuming that interarrival times andhaircut times are exponential, which barber will earn moremoney?
- The total number of trips from ABC to XYC is 4500. All of the trips are made using car. The government proposed two alternatives, a train or a bus. The utility is given by the equation: U = -0.05(TT) - 0.04(WT) - 0.07(W) - 0.2(F) - 0.2(P) TT = in-vehicle travel time WT - walking time to terminal W - waiting time F- fare P- parking cost The travel time for private car is 30 minutes, 35 for bus and 17 for train. Walking time for different terminals for bus and train is 8 and 14 minutes respectively. The waiting time is 6 and 5 minutes for bus and train respectively, and the fare for car, bus and train is at $22, $8 and $6 dollars respectively. Parking cost for car is $6.Given: A stationary container system (mechanically loaded), 3.5 collection trips/wk, 8hrs/day, 3.22 h/trip (pick up time), at site time 1h/trip, round trip = 10miles, a=.018 h/trip. b= .020h/trip, productive time = 85% Note: Even though a partial trip (3.5 collection trips), a full trip (4) will have to be mad to the disposal area. Find: Time required per week.How many ticket vending machines will be needed if the hourly passenger demand is expected to be 8,750 and it takes each passenger 8 seconds to retrieve a ticket? Tickets are mandatory for all passengers. Round up your answer to the nearest integer (i.e. ticket vending machine).
- Given the following transportation network with travel time in minutes: 3 2 2. 3 4 3 The trip production from TAZ 3 is 1,000. The trip attractions from TAZ 3 to all other zones are shown below: From/To 1 500 2 300 4 Trip Attraction 300 The minimum path from zone 3 to zone 1 is: Links 3-4, 4-1 5 min Links 3-2, 2-1 Link 3-1Buses are to be charted for an excursion. The bus company charges $20.00 per ticket if not more than 200 passengers go with the trip. However, the company agrees to reduce the price of every ticket $0.05 for each passenger in excess of 200 passengers. What number of passengers will produce the maximum gross income?Define the following terms: (a) home-based work (HBW) trips, (b) home-based other (HBO) trips, (c) non-home-based (NHB) trips, (d) production, (e) attractions, (f) origin, and (g) destination.