LRC circuit contains a parallel-plate capacitor with plates of area 16.34 m^2, separated by 1.29 mm and completely filled with dielectric (dielectric constant k= 2.85), 39.85 Ohm resistor and toroidal solenoid inductor with 1,971.02 turns of wire, a cros-sectional area of 3.47 cm^2, and mean radius of 4.32 cm. The components are connected in series to an emf source operating with a 88.45 V amplitude at 115.25 Hz. What is resonance angular frequency (rad/s?

LRC circuit contains a parallel-plate capacitor with plates of area 16.34 m^2, separated by 1.29 mm and completely filled with dielectric (dielectric constant k= 2.85), 39.85 Ohm resistor and toroidal solenoid inductor with 1,971.02 turns of wire, a cros-sectional area of 3.47 cm^2, and mean radius of 4.32 cm. The components are connected in series to an emf source operating with a 88.45 V amplitude at 115.25 Hz. What is resonance angular frequency (rad/s?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 3RQ: A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted...

See similar textbooks

Similar questions

(6) A parallel-plates capacitor with plate area of 100 cm? has a separation of 3mm between the pates. The separation is divided into three slabs, where each slab has 1 mm distance. The first slab is filled by air and has a constant of 1. The second slab is filled by polystyrene and has a constant of 2.5, while the third slab is filled by silicon dioxide and has a constant of 4. Compute the capacitance of the system. Note: for parallel slabs; Conductor 1 E = T 1 Air E1 83 Material A Material 3 Conductor Ans. C = 54 pF
re, Zi,Zo,Av =? With CE Capacitance and Without CE Capacitance.
For 3-phase unsymmetrical spacing shown in figure (the diameter is 1 cm).: Find the capacitance per phase per km. 9m 12m
#2 A capacitor with a capacitance of 4.023567436209E-10 pF is a parallel-plate capacitor. Each plate has an area of 0.0935m ^ 2 and a dielectric thickness of 0.0823 m. How many parallel sections are there if the dielectric constant of the material is 8?
Q14. An air filled parallel plate capacitor is arranged such that the upper plate carries surface charge density 2C/m2 and lower plate carries surface charge density -2C/m as shown in figure. The electric field intensity under the bottom plate will be -2a/ɛ0 -a,/ɛ0 None of these ロロ

1- A capacitor of parallel plates has a dielectric material of relative permittivity of 1.9 and the distance between the plates is 2.5X10° m. If the spacing is changed to 3.5 mm and the capacitance is to be unchanged, what is dielectric constant of a new material have to be replaced.
distance between plate is o 6 Mm and the dielectric 3.The capacitor having a plate area of o.lm the air.w hich of the fallowing is the capacitance of capacitor.
When is the capacitive reactance (Xc) greater? a) If the capacitance is higher and the supply frequency is lower b) If the capacitance and supply frequency are lower C)If the capacitance and supply frequency are higher d) If the capacitance and supply frequency are higher
The plates of a parallel-plate capacitor are square and have the length of one side. 20 cm and the distance between the plates is 0.5 cm. The material between the plates is air.What is the capacitance of a parallel plate capacitor in farads?
.i. In a parallel plate capacitor, the cross sectional area of the plates are doubled and all other parameters remains the same. The ratio of Final capacitance to initial capacitance is found to be:
Determine the capacitance of the given spherical cross section as shown in figure belowwith the following specifications: a =1 mm, b = 3 mm, c= 2 m, εr 1=2.5∧εr2=3.5.
Determine the z-tranform and ROC. Show full solution.