Given a variable resistor R of unknown resistance connected in parallel with an inductive reactance X = j10 ohms. The parallel combination is connected in series with a capacitive impedance Xc = -j4 ohms and supplied by 100 volts, 60 Hz AC source. %3D b. Solve for the current of the circuit if R = 5 ohms.

Given a variable resistor R of unknown resistance connected in parallel with an inductive reactance X = j10 ohms. The parallel combination is connected in series with a capacitive impedance Xc = -j4 ohms and supplied by 100 volts, 60 Hz AC source. %3D b. Solve for the current of the circuit if R = 5 ohms.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.61P

See similar textbooks

Similar questions

Task 3 A three phase, four wire star connected load consisting of: ZR: a resistor of 9500 in series with a 3H inductor ZB: a resistor of 1950 ZY: a resistor of 1950 in series with a 4µF capacitor Using the equipment available in the power lab (Room T017), connect the given load to a three-phase supply available in the lab and: 3.1. Determine the current of each line and the neutral current and measure the total power supplied by the source. 3.2. Analytically, calculate all currents and the total power and compare with those obtained in measurements. 3.3. Device a method and measure the waveform of the neutral current. Discuss the obtained waveform and the reason for any distortion in the waveform 3.4. Validate your calculations using computer simulation
An inductive reactance of 6 ohm is connected in series with a parallel combination of a variable resistor R and a capacitive reactance of 15 ohm across 100V , 50 hz supply. a. Solve for the frequency so that the magnitude of the inductive reactance is 2 times the magnitude of capacitive reactance. b. Solve for the value of R so that the total current I will be maximum.
Based on Figures la,1b and 1c and RLC elements, write a discussion on voltage-current relations and power factor.
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. Now what is the minimum AC voltage rating of each capacitor?
Use 3 decimal places and box the final answer. A 4-ohm resistor is in series with a 7.96-mH inductor connected across a 110-V 60-Hz source. Determine : a) the impedance b) the input current c) the voltage across the resistor and the inductor d) Draw the phasor diagram showing the current and the voltages. e) The power factor and the power input to the circuit.
A resistor of 5 ohms is connected in parallel with an inductive reactance of 10 ohms, then connected in series with a capacitive reactance of 5 ohms. If the entire combination is connected across a 100 V, 60 Hz ac source, find the voltage across the resistor.
For figure (1)draw and calculate the voltages waveform across each half of secondary winding and across load when 100sin2π60t applied across the primary, then find PIV.
The values of the circuit elements are given below.Accordingly |I| What is its value (the maximum value of its current)? V=110 phase 40 VR1=10 ohmsR2=12 ohmsR3=14 ohmsL1=j15 ohmsL2=j8 ohmsM=j15 ohmsC1=-j5 ohmsC2=-j12 ohms
An inductor and resistor are connected in parallel to a 120-V, 60-Hz line. The resistor has a resistance of 50 ohms, and the inductor has an inductance of 0.2 H. How many degrees out of phase are the current and voltage?
Figure 2 shows three "LC" circuits, two of them with capacitors of capacitance "C" and the three with inductance coils "L", the three circuits are coupled by means of two capacitors "Cc" capacitors. inductance "L", the three circuits are coupled by means of two capacitors of capacitance "Cc". The currents circulating through each mesh are those indicated in the figure: "I1", "I2" and "I3". Using Kirchhoff's law for voltages and taking into account the definition of current I = -dQ/dt, find the system of coupled equations of the system and then find the angular normal frequencies of the system.
Please show you detailed solution Number 10 A voltage of 250 volts at 50 Hz is impressed on a circuit having a 60-ohm resistor, 35-?F capacitor, and a 0.25-henry inductor in series. Determine power factor. A. 0.979 C. 0.924 B. 0.862 D. 0.707
a. Using Ohm’s Law, compute the voltage and current for eachcomponent. Use the formula Z = Vt / It. b. Compute and record the magnitude and phase angle of the impedanceusing the equation Z= R + RL + jXL – JXC. Use 3uF for the value of C,1.006H for the value of L and for the resistance is computed based onthe specification of the lamp. c. Compute and record for the total power using the formula: Pcomputed = Scosθ d. Compute and record the reactive power and apparent power using theformula Scomputed = V2/ZQcomputed = √S2 − P2 e. Compute for the reactive power (measure) and apparent power(measured) using the formula.Q = PtanθS = P/ cos θ f. Compute the percent difference between the measure and the computedvalue of the impedance.