B- Water flows steadily through a 4-cm diameter pipe that is 10-m long. The pipe wall is porous, leading to a small flow through the pipe wall. The inlet velocity is 10 m/s, and the exit velocity is 9 m/s. Find the average velocity of the water that is passing through the porous Porous wall 4 cm V- 10 m/s 10 m V=9 m/s surface.

B- Water flows steadily through a 4-cm diameter pipe that is 10-m long. The pipe wall is porous, leading to a small flow through the pipe wall. The inlet velocity is 10 m/s, and the exit velocity is 9 m/s. Find the average velocity of the water that is passing through the porous Porous wall 4 cm V- 10 m/s 10 m V=9 m/s surface.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The calculation of power from moving fluid has the following parameters:Volume flow rate = 10 +/- 0.154 m3/sDensity of Water = 1025 kg/m3Head of water = 150m +/- 10cmDetermine the range of values the power will be calculated.
A water supplying pipe of diameter 14 cm, is used to pump the water to the house in the Tanuf hill at the height of 60 m above the ground. The flowrate at the end of the pipe is 180 lit/s. The pressure gauge is connected at the inlet of the pipe in the ground and measured as 35.5 N/cm2. Find the following: (i) The kinetic energy per unit weight at the entry of pipe (in m) (ii) Pressure head at the inlet (in m) (iii) Total available energy per unit weight of the water at the pipe entry (unit in m)
A pipe of diameter 14 cm, is used to pump the water to the house in the Hamra hill at the height of 80 m than the ground. The discharge at the end of the pipe is 140 lit/s. The pressure gauge is fitted at the entry of the pipe in the ground is 34 N/cm. Find the following: O The velocity head at the entry of pipe (in m) (m Pressure head at the inlet (in m) (m) Total available energy per unit weight of the water at the pipe inlet (unit in m) (Enter only the values by referring to the units given in brackets & DO NOT write the unit & do not send the handwritten answers to my mail id.) velocity head at the entry of the pipe is = (unit in m) pressure head at inlet = (unit in m) Total available energy per unit weight of the water at inlet of the pipe (unit in m)
A pipe with diameter 30 cm carries oil of sp.gr. 0.95 at a velocity of 4 m/s .at another section the diameter change to 20 cm. Find the velocity at this section and also find the mass flow . rate of oil A- V=8.5m/s , m= 270 kg/s B- v=9m/s, m= 300 kg/s O C- v=9 m/s , m=269.8 kg/s D- v= 9.5 m/s, m= 280 kg/s O
Consider using a venturi tube to messure the flow rate of water (280C^O) through a pipe 5cm in diameter, the narrowest point is 1 cm in diameter. The pressure measured betweenthe two points is 3OkPa. Calculate the volume flow rate of water?
A fluid flowing in a pipe 30cm in diameter has a uniform velocity of 4m/s. The pressure at the center of the pipe is 40kpa, and the elevation of the pipe's centerline above an asumed is 4.5m. Compute the total energy per unit weight of the flowing fluid if it is (a) oil,sg=0.80 and (b) gas gamma=8.50n/m^3
A horizontal pipe of diameter 350 mm converges to a diameter of 200 mm. The pipeconveys water with a density of 1 g/cm3. The pressure at the inlet and outlet are 550kPa and270 kPa respectively. Assuming the flow is incompressible and frictionless, estimate themass flow rate through the pipeline, stating the velocity at both the inlet and outlet.
A pipe of diameter 12 cm, is used to pump the water to the house in the Hamra hill at the height of 60 m than the ground. The discharge at the end of the pipe is 200 lit/s. The pressure gauge is fitted at the entry of the pipe in the ground is 34 N/cm?. Find the following: (i) The velocity head at the entry of pipe (in m) (ii) Pressure head at the inlet (in m) (iii) Total available energy per unit weight of the water at the pipe inlet (unit in m) (Enter only the values by referring to the units given in brackets & DO NOT write the unit & do not send the handwritten answers to my mail id...) velocity head at the entry of the pipe is = (unit in m) pressure head at inlet = (unit in m) Total available energy per unit weight of the water at inlet of the pipe
estion 05 sib mm 00S Water from a large reservoir is discharged to atmosphere through a 100 mm diameter pipe 450 m long. The entry from the reservoir to the pipe is sharp and outlet is 12 m below the surface level in the reservoir. Takingf=0.01 in the Darcy formula, calculate the discharge.
A pipe of diameter 18 cm, is used to pump the water to the house in the Hamra hill at the height of 50 m than the ground. The discharge at the end of the pipe is 220 lit/s. The pressure gauge is fitted at the entry of the pipe in the ground is 35 N/cm². Find the following: (i) The velocity head at the entry of pipe (in m) (ii) Pressure head at the inlet (in m) (iii) Total available energy per unit weight of the water at the pipe inlet (unit in m) (Enter only the values by referring to the units given in brackets & DO NOT write the unit & do not send the handwritten answers to my mail id....) velocity head at the entry of the pipe is = (unit in m) pressure head at inlet = (unit in m) Total available energy per unit weight of the water at inlet of the pipe (unit in m) ,
Show that the kinetic energy of oil flowing through a pipe is 1.2961 ft-lbf/s given the folowwing: diameter of pipe = 2 in Flow rate = 40 gal/min SG = 0.90 water density = 62.3 lb/ft3
6) Through the pipeline system in the figure, calculate the flow velocity and flow rate at B, if Pa = 10 mwl. Ignore energy losses. 5 14.89 m A 15 m 15 m Mercury 2. 1 15 m 3 7 B