A wastowater sample of 100 ml. was filtered through the filter paper and the filtered wator was collected in a beaker. Based on the informationprovided in Table 1, calculato total solids, suspended solids, dissolved solids in wastowater (mg/1.).Table 1:DescriptionWeight of filter paper (gm)Weight of tilter paper +solids (gm) after oven dry at 105 'CWeight of filter paper +solids (gm) after oven dry at 105 CWeight of beaker (gm)Weight of beaker + water after oven-dried at 105 "C (qm)Weight0.050.17.765051.5O Suspended solids - 76.6 mg/; dissolved solids 15 mg/ and Total solids 91.6 mg/Suspended solids 86.6 mg/L; dissolved solids - 15 mg/L and Total solids - 101.6 mg/Suspended solids - 76.6 mg/L; dissolved solids = 10 mg/L and Total solids - 86.6 mg/LSuspended solids 70.6 mg/L; dissolved solids = 25 mg/L and Total solids = 95.6 mgt.

Suspended Solids=Weight of residueVolumeWeight of residue=7.76-0.1=7.66gmsSuspended…

Answered: A wastewater sample of 100 ml was…

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

In standardization, 10.00 mL of Naz C2 04 solution required 39.17 mL of KMN04. Find the molarity of KMNO,. The unknown required 14.44 mL of MnO,. Find Ca in the urine. (Answer: 1.086 x 10 M, 7.840 x 10 M)
The Volume of NaOH (0.01N) when use ph.ph indicator is 12.4mL and 3mL when use methyl Orange (M.O) and the Volume of Sample is 30mL, Calculate the Total Acidity as mg (CaCO3)/L. (EW for CaCO3 is 50)
The following test results (Table Ql-2) were obtained from a raw water sample. All of the tests were performed using a sample volume of 50 mL. Table Q1-2 Weight (g) Mass of residue after drying at 105 ỏC Mass of residue after ignition at 550 ¿C Mass of residue on Whatman GF/C filter paper after drying at 0.7148 0.3818 0.3571 105 'C Mass of residue on Whatman GF/C filter paper after ignition at 550 'C 0.1418 Calculate the concentration (mg/L) of : (i) total solids. (ii) total volatile solids. (iii) total suspended solids. (iv) total dissolved solids.
Il Consider the capability of a process that puts pressurized grease in an aerosol can. The design specification calls for an average of 50 pounds per square inch (psi) of pressure in each can with an upper tolerance limit of 56psi and a lower tolerance limit of 46psi. A sample is taken from production, and it is found that the cans average 51psi with a standard deviation of 2psi. Find the following unknowns. 1. Capability Index (Cpk) 2. Is the process capable at the 30 level? 3. What is the probability of producing a defect? Hind: use the standard normal table as seen below.
A sample is diluted to perHorm test 295 mL distilled water are added to 5mL sample to fill 300ML BOD bottle. Inifial dissolved oxygen concentration is 7.9 mg/L in the bottle After mcubating 5 days, dissal ved oxygen carcentvation 1s 45 mg/L- Determine 5-day BOD OF the wastewae- Deoryge nation rate Constant, k, is C.013 day- Evaluate ultimate BOD Of the wastewCHer.
A 50 mL of wastewater sample was brought to the lab and filtered out to measure the solids concentration. The weights of filter paper before, and after filtration (with solids) are 0.182 g and 0.197 g, respectively. The weights of aluminum cup tare before, and after dry (with solids on filter paper) are 100.08 g and 100.76 g, respectively. What is the total suspended solids concentration (TSS), in mg/L or grams/liter (or, other units)? Show your math-work.
MPN of effluent is 10/100 ml and it reduces to 102/100 ml after chlorination. Find percentage removal (%R) and log removal (logR) of MPN.
A sample of wet aggregate 297.2 N. After drying in an oven, this sample weighed 281.5. The absorption of this aggregates is 2.5%. Calculate the percent of free water in the original wet sample. Weight of the wet aggregates (Wwet) = 297.2 N Weight of the dry aggregates (Wdry) = 281.5 N
7. A formula calls for 0.6 mL of a coloring solution. Using a 10-mL graduate calibrated from 2 to 10 mL in 1-mL units, how could you obtain the desired quantity of the coloring solution by the aliquot method? U se water as the diluent.
Calculate the BOD concentration based on the data below. DOinitial (mg/L) 7 DO final (mg/L 3.5 Vol. sample (ml) 15 Vol. dilution (ml) 285 BOD (mg/L) ?
(0 Awastewater sample is being analyzed to determine its BOD content. The sample is diluted in order to perform the test: 295 ml. of distilled water are added to 5 ml of sample to fill the 300 ml BOD bottie. The bottle has an initial dissolved oxygen concentration of 7.9 mg/L After incubating 5 days, the dissolved oxygen concentration is 45 mg/L a. What is the S-day BOD of the wastewater? h. The deoxygenation rate constant, k. is 0.013 day What is the ultin BOD of the wastewater? ) A community normally levies a sewer charge of 20 cents/m' (S0.20/m).
20. 1 ml droplet of distilled water is dropped onto each material "A" and "B" as shown below. Which material is more hydrophilic ? Justify your answer. (7p)

SEE MORE QUESTIONS

Recommended textbooks for you

Structural Analysis

Civil Engineering

ISBN:

9781337630931

Author:

KASSIMALI, Aslam.

Publisher:

Cengage,

Structural Analysis (10th Edition)

Civil Engineering

ISBN:

9780134610672

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Structural Analysis

Civil Engineering

ISBN:

9781337630931

Author:

KASSIMALI, Aslam.

Publisher:

Cengage,

Structural Analysis (10th Edition)

Civil Engineering

ISBN:

9780134610672

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Fundamentals of Structural Analysis

Civil Engineering

ISBN:

9780073398006

Author:

Kenneth M. Leet Emeritus, Chia-Ming Uang, Joel Lanning

Publisher:

McGraw-Hill Education

Sustainable Energy

Civil Engineering

ISBN:

9781337551663

Author:

DUNLAP, Richard A.

Publisher:

Cengage,

Traffic and Highway Engineering

Civil Engineering

ISBN:

9781305156241

Author:

Garber, Nicholas J.

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

A wastewater sample of 100 ml was filtered through the filter paper and the filtered water was collected in a beaker. Based on the information provided in Table 1, calculate total solids, suspended solids, dissolved solids in wastewater (mg/.).