Q: Morphine should be extracted from a urine sample using solid extraction (SPE). Suggest a suitable…
A: To suggest a suitable SPE column that can be used for the extraction of morphine.
Q: Calculate the theoretical weight of sodium borohydride needed to reduce 50mg of benzil
A: Now for this consider this reaction between them and as a result calculations are as follows
Q: The chromatographic purification of 1 g of (-)-ethyl lactate with an ee of 85% yields the optically…
A:
Q: A mixture of compounds is dissolved in ether, and extracted with 10% NaHCO3 solution. The aqueous…
A: If the mixture contain amines, then it will be at the bottom layer of second extraction.
Q: Finding Molecular Weights from Experimental Data a. Endgroup analysis by titration: 9.8 mols of…
A:
Q: Explain the differences observed in the T, and Tm values for each pair of polymers: (a) polyester A…
A: Given that, a)
Q: Explain why, when a small amount of glycerol is added to the reaction mixture of…
A: When a small amount of glycerol is added to the reaction mixture of toluene-2,6-diisocyanate and…
Q: Assuming molecular weights are similar, place them in order of predicted highest Ry to lowest Ry…
A: Rf value is the retention factor .It is the distance traveled by spot divided by distance traveled…
Q: What proportion of benzoic acid should be used with an equimolar mixture of adipic acid and…
A:
Q: what is the acetaldehyde test with 2,4-Dinitrophenylhydrazine Write down the reaction mechanism for…
A: in this reaction, 1st reaction is confirmation test of carbonyl group, loss of water molecule as…
Q: >Glyptal is a highly cross-linked thermosetting resin produced by heating glycerol and phthalic…
A: The monomer units of Glyptal are glycerol and phthalic anhydride. The structures of monomer units…
Q: The melting point of Borneo is 206-209oC and 212-214oC for isoborneol. What could we predict for the…
A: During the reduction of Camphor using NaBH4 as a reducing agent leads to formation of two products,…
Q: IF A MIXTURE OF 44.7 MG OF BENZOIC ACID, 50.8 MG OF ETHYL 4-AMINOBENZOATE AND 53.3 MG OF…
A: Given: Mass of 9-FLUORENONE recovered = 39.4 mg. And the mass of 9-FLUORENONE used in the mixture =…
Q: You started with 84g of aniline and 28 ml of acetic anhydride. Give % yield of acetanilide.
A: When aniline reacts with acetic anhydride then acetanilide is formed. Ph-NH2 + Ac2O = PhNHCOCH3 +…
Q: Why is it possible to separate nonanthocyaninic flavonoids from anthocyanins by the extraction with…
A:
Q: Determine the theoretical yield of 3-nitrobenzamide based on starting with 0.50 g of 3-nitrobenzoic…
A: We have given that reaction : 3-Nitrobenzoic acid to 3-Nitrobenzamide so we have given that mass…
Q: Twenty grams of tea leaves was extracted with 250.0 mL water. The aqueous extract was then subjected…
A: Part a. The distribution coefficient of caffeine between dichloromethane and water (Kd) = 8.35 Now,…
Q: Measure the weight of acetylsalicylic in aspirin. note: % of acetylsalicylic acid in aspirin is 5%…
A:
Q: 2. Gyuri performed the synthesis of ester X. Liquid-liquid extraction is needed to extract compound…
A: Since you have asked a question with subparts, we will answer 3 subparts for you. In order to get…
Q: What would the product have been like if 2,6-dimethylaniline and diethylamine had been added in the…
A: Organic reactions are the chemical reactions that are involved organic compounds. The bonds are…
Q: Calculate the weight of nitrobenzene that codistills (bp 99°C) with each gram of water during a…
A: When two mutually immisicible liquids are mixed to give a heterogeneous mixture, each exerts its own…
Q: Please report the following: a) Volume of aniline? b) Volume of acetic anhydride? c) Mass of pure…
A: From the given data the recovery acetanilide mass is 6.592gm
Q: Given that Grignard reaction used 1.4555 g of phenyl bromide 10 g of carbon dioxide , 0.5734 g of…
A: Answer Theoretical yield = 1.1321 g Percent yield = 50.61 % Given: Mass of Phenyl bromide…
Q: The polyester can be mixed with additional phthalic anhydride (0.5 mole of phthalic anhydride for…
A: Given reaction is,
Q: What would happen to the your Kc values if you used an absorptivity constant of 6000 M-1, when the…
A:
Q: What impurity was likely removed during the recrystallization necessary and was it effective and why…
A: Recrystallization is the most important method of purifying nonvolatile organic solids.…
Q: 2-Methylethylpropanoate is condensed with phenylbenzanoate in an alkaline medium
A:
Q: Multistep synthesis of Lidocaine Lab 1) How many grams of starting material do you need? It is…
A: Answer of 1):- 1 mole of any compound corresponds to its molecular weight. To convert the given mole…
Q: Can acetyl chloride be used in place of acetic anhydride in the synthesis of acetanilide with…
A: Aniline reacts with acetic anhydride to form acetanilide.
Q: if 54.9% of ethenol is in the distillate what would be the sloute and the solvent in the mixture?…
A: Given that, % of ethanol = 54.9% then,
Q: In preparation of p-Nitroaniline, Starting material is 50g of p-nitroacetanilide, 22ml of HCI, 20g…
A: Given: mass of p-nitroacetanilide used = 50 g Mass of p-nitroaniline obtained = 20 g
Q: Draw the structure of the trichloroethanol modified tryptophan that is made when you expose your…
A: Given that : We have to draw the structure of the trichloroethanol modified tryptophan that is made…
Q: If you had performed the extraction with dichloromethane (d 1.33 g/mL) as the organic solvent and…
A: Given: Density of dichloromethane = 1.33 g/mL Density of water = 1.00 g/mL Three starting compounds…
Q: Suppose you have an organic sample X that is somewhat soluble in water, even though it issomewhat…
A:
Q: WHAT FACTORS CAN AFFECT THE YIELD OF BENZOIN CONDENSATION?
A: The solution is shown below.
Q: We want to extract terpenoids from an aqueous sample by continuous liquid-liquid extraction. Which…
A: The solution is given below -
Q: In the Isolation of caffeine from tea leaves experiment, both solid/liquid and liquid/liquid…
A: We Will Choose Correct option
Q: What is procedures in extraction of lycopene from watermelon.
A: Lycopene from watermelon can be extracted as follows:
Q: MW (mg/mmol) Density (mg/uL) Amount used vanillin 152.15 XXXXX 400.0 mg acetic anhydride 102.09 1.08…
A: Number of millimoles=Amount/MW Amount of acetic anhydride=500 mg (since, 1ul=1mg) MW of acetic…
Q: In the procedure of the separation of Phensuprin using Acid-Base extraction, the bicarbonate…
A:
Q: Upon screening with TLC (made of silica gel) chromatography using hexane/chloroform (3:1) as eluting…
A: The thin layer chromatography can be described as the procedure that is used to the recognition of…
Q: pon screening with TLC (made of silica gel) chromatography using hexane/chloroform (3:1) as eluting…
A: The components on the chromatography paper moves according to their polarity. The spot of the most…
Q: TRUE OR FALSE 2. The turbidity in the Lucas test is attributed to the resulting alkyl halide. 3.…
A: Here we are required to find th statement is true or false.
Q: Explain how you would separate a mixture of 4-phenylbenzoic acid, 4-phenylphenol and biphenyl using…
A:
Q: Give the reactions of the ff. to phthalic anhydride (upon heating with H2SO4). 1. Resorcinol 2.…
A:
Q: Given a sample of anise oil for its phenol (anethol) content determination, 10 ml was used as sample…
A: Percent composition of an compound is defined as the amount of the that compound divided by the…
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 1 images
- You started with 84g of aniline and 28 ml of acetic anhydride. Give % yield of acetanilide. 653 AM 10/22/2021 B 62PF A D)how to analyse alkaloids using Acid dye colorimetry method and HPLC method? Discuss atleast 5 sentences each0.2 gm of ethanol was acetylated with acetic anhydride in presence of pyridine (1:3), neutralization of the resulted solution required 20 ml of 0.1 N NaOH, while the blank titration reqiuered 40ml of NaOH. Calculate the percentage of hydroxyl group in this sample ?
- A mixture of compounds is dissolved in ether, and extracted with 10% NaHCO3 solution. The aqueous extract is treated with 6M HCI solution, and extracted with dichloromethane. If the mixture contains an amine, where is it? The bottom layer of the first extraction O The top layer of the second extraction The top layer of the first extraction The bottom layer of the second extractionYou started with 84g of aniline and 28 ml of acetic anhydride. Give % yield of acetanilide. 12:04 PM 10/23/2021 白how to prepare phenylmethanamine from benzene ?
- 34. Pentan-1-amine vs. Pentanamide When comparing pentanal and pentan-3-one: 1. How do the amount of peaks differ? 2. Compare the range of PPM 3. Are there any other differences or similarities? Which carbon would be present at 173 В. NH2 4. С. Е. ppm? Spectra for pentane Spectra for pentanamide 10 20 PPM 35 30 25 15 180 160 120 40 34 100 PPM 140 80 60 20Illustrate the Separation of cyclohexanamine and cyclohexanol by an extraction procedure ?Define Separation of benzoic acid and cyclohexanol by an extractionprocedure ?
- Give at least four identity tests for sulfanilamide with chemical reaction and stepsMultistep synthesis of Lidocaine Lab 1) How many grams of starting material do you need? It is given in moles below but how many grams? 2) How to calculate theoretical yield? Part One Method A. Preparation of alpha-Chloro-2,6-dimethylacetanilideCombine 0.033 mol of 2,6-dimethylaniline with 25 mL of glacial acetic acid (or ethyl acetateor THF) and 0.033 mol of alpha-chloroacetyl chloride, in that order, in an appropriately sized Erlenmeyer flask. With the aid of a hot water bath, warm the solution to 40-50°C, remove the flask from the bath, and add a solution of 5 g of sodium acetate trihydrate dissolved in 100 mL of water.Which compound, benzopinacol or benzopinacolone, is more soluble in EtOH.