Write a MIPSZY program to load 2 ordered pairs of integers from memory, the compute delta y and delta x. Data Memory Beginning at address 5020 and the 4 words following, you will find the following information: Value 1 x1 Value 2 y1 Value 3 x2 Value 4 y2 Delta Y (Change in Y) should be stored in 5000 Delta X (Change in X) should be stored in 5004

Q: write a program that compare two blocks of 64 consecutive bytes, the first block starting at address…

A: the solution is given below

Q: Write a program that adds 250 unmarked 8-bit numbers stored in consecutive SRAM cells from the…

A: SRAM: Static RAM, memory contents do not need periodic refreshing, SRAM cell is typically…

Q: Write a program for 8085 microprocessor to swap nibbles (upper four bits and lower four bits) of ten…

A: 8085 is an 8-bit microprocessor as it operates on 8 bits at a time and is created with N-MOS…

Q: Q1/ write a program that compare two blocks of 64 consecutive bytes, the first block starting at…

A: The answer is given below:-

Q: Suppose we have an array of signed shorts (each short value is 2-byte long) S with a base address in…

A: Step 1:- It is given that there is an array whose store the integer value and the size of each…

Q: Q2. (30%) Write a commented 8085 assembly language program to replace the already stored 05…

A: Question :-

Q: H.W 2: Write a piece of assembly code that can program PPI 8255 as port A as I/P,Port B as O/P,port…

A: Answer :

Q: H.W 2: Write a piece of assembly code that can program PPI 8255 as port A as I/P,Port B as O/P,port…

A: let A7 is connected to Chip Select pin of 8255 then PORT A address is 80 PORT B Address is 81 PORT C…

Q: H.W 2: Write a piece of assembly code that can program PPI 8255 as port A as I/P,Port B as O/P,port…

A: Port A-input Port B-output Port C lower-Input Port C Upper-Output By default the Mode 0 is selected.…

Q: H.W 2: Write a piece of assembly code that can program PPI 8255 as port A as I/P,Port B as O/P,port…

A:

Q: 3. The following program is an example of MIPS PC-relative addressing whore is translated from C++:…

A: Answer: I have given answer in the own written format

Q: Solve the 8085 Write a program to load twenty memory locations starting from 8005H, where each…

A: Algorithm – Take a count equal to 4 Store the starting address of both blocks in 2 different…

Q: Write a short program that uses the XLAT instruction to convert the BCD numbers 0–9 into ASCII-coded…

A:

Q: Write an assembly language program to test the contents of 5 memory locations start at (2000) If…

A: It is defined as low-level programming language for a computer or other programmable device specific…

Q: Write a program to compute S value from following series by using subroutine. (X-5)6 (X-7)° (X-9)10…

A: For the given program, to calculate S using subroutine: A for loop from I=6 to N, with step count…

Q: Using matalab H.W 2: Write a piece of assembly code that can program PPI 8255 as port A as I/P,Port…

A: the answer is given below :

Q: Using matalab H.W 2: Write a piece of assembly code that can program PPI 8255 as port A as I/P,Port…

A:

Q: The index registers are the(a) AX, BX, CX, DX (b) SP, BP, IP (c) DI, SI (d) CS, DS, .2 ES, SS What…

A: I have given an answer in step 2.

Q: Write a piece of code that transfers a block of 100 bytes stored at locations starting at 440OOH to…

A: MOV AX , 4000HMOV DS , AXMOV ES , AXMOV SI , 4000HMOV DI , 7000HMOV CX , 100HCLD NEXT: MOVSBLOOP…

Q: Consider the following y86-64 program: .pos 0x0 irmovq $128,%rdx irmovq $3,%rcx rmmovq %rcx,…

A: It is defined as a type of program which has a lot more instructions. IA32 has a lot of quirks. Y86…

Q: Write a program to multiply the contents of the PINC by 10 and store the lower byte at the RAM…

A: 1) LDI R16, 0x00 3rd line) LDI R16, 0xFF 4th line) IN DDRD,R16  5th line) LDS R10, PINC

Q: Write a program that transfers 6 bytes of data from memory locations with offset of 0010H to memory…

A: It is defined as a low-level programming language for a computer or other programmable device…

Q: Write an assembly program to set R0=1 if there's a 5 in one of ten memory locations, starting at…

A: Assembly Level Programming : The assembly level programming 8086 depends on the memory registers. A…

Q: Write a program to set in 8060 (bit 7) and clear (bit 0) of a byte wide number stored in address…

A: Solution: For setting the msb bit we first use the bitwise operator OR ,that is OR with 80 since AX…

Q: Suppose we have two arrays A[10] and B[10]. Write a MIPS code that does the following: It compares…

A: Please find below the MIPS code for swap numbers with given condition:         swapElements(int*,…

Q: Write a program to set (bit 7) and clear (bit 0) of a byte wide number stored in address 0200-2460H,…

A: Actually, assembly program is a low level programming language.

Q: How long is the delay generated by the following code(in seconds)? Assume th the Dealy subroutine…

A:

Q: Write an assembly language program for MC68000 mieroprocessor that will compute the following…

A: Solution:--   1)The given question has required for the solution to be provided with the help of the…

Q: Write a program to set (bit 7) and clear (bit 0) of a byte wide number stored in address 0200-2460H,…

A: The answer is given below:-

Q: How long is the delay generated by the following code(in seconds)? Assume that the Dealy subroutine…

A: Delay routine calculation Given instructions MOV R1,#5L2:   MOV A, R1         RL AMOV R2, AL1:…

Q: H.W: < Write a piece of code to find the number of odd integers in an array of size 1024 byte stored…

A: Note: As per the bartlebey policy we can answer single question at a time so i am answering the…

Q: Here is an LC-3 assembly language program: .ORIG X3ees A LD R7, C LD R7, E LD R7, B LD R7, A E LD…

A: .orig x3005 tells us the address of the first instruction. 3005     A      LD R7, C 3006     B…

Q: Write an assembly language program to do the following: 1- Set SI to the value 200H. MOV SI, 200H 2-…

A: we need to provide assembly code for given instructions..

Q: 1. Determine the output of the following program: Note : %p used to print the address in hexadecimal…

A: Note : since part2 is incomplete we are providing solution to part1 only.   #include &lt;stdio.h&gt;…

Q: How long is the delay generated by the following code(in seconds)? Assume that the Dealy subroutine…

A:

Q: How long is the delay generated by the following code(in seconds)? Assume that the Dealy subroutine…

A:

Q: Homework 1. Write a machine program to add data at 5005H & 5006H memory location and store the…

A: Given: Write a machine program to add data at 5005H &amp; 5006H memory location and store the result…

Q: Consider the program given below. RETMON EQU OFO00H EQU OFOH ORG 100H START MOV A,#35H MOV R1,#46H…

A: Explanation;- MOV A, #35H =&gt; A &lt;- 0x35 MOV R1, #46H =&gt; R1 &lt;- 0x46 ORL A, R1 =&gt; A…

Q: Using the LC3, write a machine language program that steps through 3 values, stored consecutively…

A: Lets see the solution in the next steps

Q: What will be the value stored in address 0007H when the given code is executed. Given value at…

A: Required:- What will be the value stored in address 0007H when the given code is executed. given…

Q: Assume that the followings are the outputs of ps and jobs commands and answer the following…

A: Given:

Q: Logic XOR operation of (11101010)2 & (10101010)2 has a result of"? Explain your answer. A page…

A: Logical XOR operation of the following :   11101010 10101010 ------------------   01000000…

Q: What will be the value of AX (in Hexadecimal) after execution of the following instructions: STC…

A: What will be the value of AX (in Hexadecimal) after execution of the following instructions: STC MOV…

Q: Assume that the following are concurrent VHDL statements: (a) L <= P nand Q after 10 ns; (b) M <=…

A: The given statements can be represented by a circuit as shown below.     Statement (a) is the first…

Q: s) Write an assembly program to implement the following. sum = 0 i = 0 j = 12 varl = 3 var2 = 3 var3…

A: ANSWER:-

Q: Consider two integer arrays B and D of 100 elements. Let X2 and X3 contain the base address of array…

A:

Q: Memory address Data According to the memory view given below, if RO = Ox20008002 then LDRSB r1, [ro,…

A: Lets see the solution.

Q: Write an Assembly program that realizes the followings... Load R8 with 0H Increment R8 till it is…

A: Given: Write an Assembly program that realizes the followings... Load R8 with 0H Increment R8 till…

Q: a) *Write a program to load the value 0XAA into memory locations 0x20000030- 0x20000038.

A: According to the Bartleby guideline we are allowed to answer only 1 question at a time ,So please…

Q: Write a program to transfer 50 bytes of data from 1KB SRAM of DS89C4x0 to P1 one byte at a time…

A: Assembly language: Assembly language is used to tell directly the computer what to do. The computer…