Which of the following steps MUST be done prior to titration of an analyte? I. Prepare a standardized solution II. Wash the burette with a standardized solution III. Fill the burette to the 50-mL mark IV. Prepare a contrast paper to determine burette volume and titration endpoint O I, Il and IV only O I, III and IV only O II, III and IV only 1, II, and III only

Which of the following steps MUST be done prior to titration of an analyte? I. Prepare a standardized solution II. Wash the burette with a standardized solution III. Fill the burette to the 50-mL mark IV. Prepare a contrast paper to determine burette volume and titration endpoint O I, Il and IV only O I, III and IV only O II, III and IV only 1, II, and III only

Chemistry for Today: General, Organic, and Biochemistry

9th Edition

ISBN:9781305960060

Author:Spencer L. Seager, Michael R. Slabaugh, Maren S. Hansen

Publisher:Spencer L. Seager, Michael R. Slabaugh, Maren S. Hansen

Chapter9: Acids, Bases, And Salts

Section: Chapter Questions

Problem 9.90E

See similar textbooks

Similar questions

Describe how the amount of sodium hydroxide in a mixture can be determined by titration with hydrochloric acid of known molarity.
What acid-base indicators, shown in Figure 18.24 would be suitable for the neutralization reaction whose titration curve is shown in Figure 18.30?Why?
An acid is titrated with NaOH. The following beakers are illustrations of the contents of the beaker at various times during the titration. These are presented out of order. Note: Counter-ions and water molecules have been omitted from the illustrations for clarity. (a) (b) (c) (d) (e) a. Is the acid a weak or strong acid? How can you tell? b. Arrange the beakers in order of what the contents would look like as the titration progresses. c. For which beaker would pH = pKa? Explain your answer. d. Which beaker represents the equivalence point of the titration? Explain your answer. e. For which beaker would the Ka value for the acid not be necessary to determine the pH? Explain your answer.
Potassium hydrogen phthalate is a solid, monoprotic acid frequently used in the laboratory as a primary standard. It has the formula KHC8H4O4. This is often written in the short-hand notation as KHP. If 25.0mL of a potassium hydroxide solution are needed to neutralize 2.26g of KHP, what is the molarity of the potassium hydroxide solution? Potassium hydrogen phthalate sometimes called potassium biphthalate, as shown on this bottle is an acid that is convenient to store and use because it is a solid.
Explain how to choose the appropriate acid-base indicator for the titration of a weak base with a strong acid.
A sample of solid calcium hydroxide, Ca(OH)2, is allowed to stand in water until a saturated solution is formed. A titration of 75.00 mL of this solution with 5.00102M HCl requires 36.6 mL of the acid to reach the end point. Ca(OH)2(aq)+2HCl(aq)CaCl2(aq)+2H2O(l) What is the molarity?
Nickel(II) formate [Ni(HCO2)2] is widely used as a catalyst precursor and to make metallic nickel. It can be prepared in the general chemistry laboratory by treating nickel(II) acetate with formic acid (HCO2H). Ni(CH3CO2)2(aq) + 2 HCO2H(aq) Ni(HCO2)2(aq) + 2 CH3CO2H(aq) Green crystalline Ni(HCO2)2 is precipitated after adding ethanol to the solution. (a) What is the theoretical yield of nickel(II) formate from 0.500 g of nickel(II) acetate and excess formic acid? (b) Is nickel(II) formate paramagnetic or diamagnetic? If it is paramagnetic, how many unpaired electrons would you expect? (c) If nickel(II) formate is heated to 300 C in the absence of air for 30 minutes, the salt decomposes to form pure nickel powder. What mass of nickel powder should be produced by heating 253 mg of nickel(II) formate? Are nickel atoms paramagnetic?
A bottle of concentrated hydroiodic acid is 57% HI by weight and has a density of 1.70 g/mL. A solution of this strong and corrosive acid is made by adding exactly 10.0 mL to some water and diluting to 250.0 mL. If the information on the label is correct, what volume of 0.988 M NaOH is needed to neutralize the HI solution? Suggest an indicator for the titration.