Answered: What is the output power of the steam…

What is the output power of the steam generator with 70 percent efficiency if the coupled turbine has output power of 900kW. d) 630kW

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 8RQ

See similar textbooks

Related questions

Q: Question 5 Determine the impedance Z, for the maximum average power transfer and the value of the…

Q: Find the Norton equivalent circuit for the circuit given below, at terminals a-b 10V 322 4A ΤΩ ΦΩ Θα…

Q: y Design a buck converter to convert 114 V dc supply voltage to -45 V output voltage across a 21 ohm…

A: DC supply, Output voltage,Load Resistor,

Q: For the circuit shown in Figure Q2, determine the following: i) equivalent capacitance for the…

A: AS PER OUR GUIDELINES WE CAN SOLVE ONLY ONE QUESTION WITH THREE SUBPARTS.KINDLY REPOST OTHER…

Q: For T = 0.5 sec, write the element of the discrete sequence corresponding to the function f(t) = t2…

A: Sampling: It is the process of converting an analog signal into a discrete-time signal.For sampling,…

Q: A balanced 3-phase Y-connected source 866V, 60Hz, feeds a A-connected loads (Zph=177- j2460) via a…

A: Given Data:A balanced three-phase circuit with,Star connected supply having,Line voltage…

Q: How to Sketch the AC equivalent of a given BJT circuit

A: Need to brief the procedure to get the AC equivalent of the BJT circuit.

Q: Describe whether the following statements are (True) or (False) CX704 4- When the zero adding to the…

A: We need to check whether the following statements are TRUE or FALSE.1. When the zero adding to the…

Q: Assume that the voltage applied to a load is V = 208Z -30° V and the current flowing through the…

Q: E7.6 Consider the network in Fig. E7.6. If the switch opens at t = 0), find the output voltage v (1)…

Q: Ri= 42 حمد 123=101 VL R2 =21 um ++ t EV P4= In &V Rs = Sn

A: it is asked to find the currents through each load resistors

Q: Given the network in Fig. P8.52, determine the magnitude of the Vo phasor if Vs = 11V, R1 = 40, and…

A: Given Data:An AC circuit with,Input RMS voltage To Find:The magnitude of the output voltage

Q: (100 V DC serial motor has a starting current value of 50 A. Total armature resistance (Ra) value is…

A: The above question is based on DC series motor.

Q: Find the current across the resistor R. =3 2 while the switch S is open for long time. A) 1.2 (A) B)…

Q: When measuring the resistance of a resistor using a digital multimeter, which of the following is…

A: it is asked to select the correct answer from given multiple choice question

Q: In a discrete linear system the response to the impulse signal is_h[n] = 2"U[-n-1]. Chair output of…

A: A discrete system impulse signal is h(n)=2nu(-n-1) output x(n)=(3)-nu(n) We need to find x(n) , ROC…

Q: A 1000 kVA, 2300 V, 60 Hz, six pole, Y connected synchronous generator has a synchronous reactance…

A: Synchronous generator:It is a device that converts mechanical energy into electrical energy. It…

Q: Find the current across the resistor 5 22 while the switch S is open for a long time. A) (A) B) (A)…

A: given circuit is to find the current through the resistance 5 ohms.

Q: About to supply a load of 200W at an average voltage of 80V from 25V pure direct voltage source A…

A: Load(P0) = 200 WAverage Voltage(V0) = 80 VDirect Voltage(Vi) = 25 Vf = 100 KHZL1 = 1200 L2 = 1500

Q: Consider the sequential circuit shown, ting of a 4 bit binary up counter, logic gates, and F. Assume…

Q: Calculate the 5th roots of the complex number z = −16+ j16 √//3. 1. What is the magnitude r of all…

A: The complex number is

Q: (a) Compare the lighter doping concentration (N₁) and cross-sectional area (A) of each different…

A: (a)(b)

Q: Determine the current in the following circuit

A: It is given that:

Q: V1 V2, V3 1k 2k 5k 10k Vo

Q: Find the f(t) for the function below where f(0) = 0, by using Laplace transform. df dt = 1

Q: Consider the circuit shown below. Leq 1140 L L 1. Assume that I = 35mH. Using the concept of…

A: It is the passive electronic component, which stores energy in the form of magnetic energy. The…

Q: V₁ R₁ V₂ R₂ R3 V3 R4 V₁=10V, V₂ =9V, V3 −IV, R₁=59, R2 =10 Q₂ R3=50, R4=5 Q Calculate the power…

Q: Q4. Use a Karnaugh map to minimize the following standard ABC + ABC + ABC + ABC + ABC Q5. Plot the…

Q: What is the purpose of a rectifier circuit? Describe the operation of a half-wave rectifier and a…

Q: Q7. Choose the letter of correct answer 7(i) The maximum efficiency of a synchronous generator is…

Q: A 550-V ac source supplies an industrial plant consisting of a motor drawing 90 kW at 0.8 pf…

A: Since multiple questions have been asked here, only the first (question 3) has been answered with 3…

Q: Q2. An infinitely long solid conductor of radius a is placed along the z-axis. The conductor carries…

A: We can apply Ampere's law. Since the conductor is infinitely long and carries a current I in the +z…

Q: 15 v ЗЛ un 61 LOV зл

A: Given Circuit:To determine:Maximum power transfer using source transformation

Q: 20 k he voltage gain? 25 25 + 20 k 10 k 20 k 20 k + 10

Q: When computing values of voltage and current for a three-phase transformer, should the line values…

A: When computing values of voltage and current for a three-phase transformer, should the line values…

Q: The following Design an analog Butterworth filter with properties. Find the transfer function. Ap =…

A: Analog Butterworth filterIt is designed to process continuous analog signals. It is known for its…

Q: For the circuit shown, determine the current I flowing and its phase relative to the applied voltage…

A: Asked to find current I and phase angle with respective to voltage

Q: Closed loop speed control of a direct current motor is shown in the block diagram below. Design a…

A: The forward path transfer function of a unity negative feedback sysetm isWe need to design a PI…

Q: In which of the following options is the expression VA / Vin given correctly in the circuit given in…

A: Here we need to calculate the transfer function of the system.note: In the diagram, terminals Z and…

Q: > A series-connected circuit has R=2 2 and L=1 mH, C=400 nF, vS(t) = 20sinwt V. Determine amplitude…

A: Given data are:L=1mHC=400nFVs(t)= 20sint VThus maximum Voltage Vm=20V.

Q: design a 5 KW off-grid and on-grid energy solar system.(prepare energy budgets , components of the…

A: Designing a 5 kW off-grid and on-grid solar energy system requires careful consideration of energy…

Q: Draw the schematic arrangement of diesel power plant

A: solution:Find:Here Draw schematic arrangement of diesel power plant.

Q: Resistor is used as load in the circuit below. T1 and T4 thyristor is triggered at 30 degrees, T2…

Q: a) The power dissipated in the transistor with no load b) The total power from the power supply with…

Q: Find the current passing through the 4-ohm resistor in the given circuit.

Q: An analog signal x(t)= 6.35cos (27 8oot) is quantized at 49.6 mV step size resolution, What should…

A: Analog signal is given as,Step size = 49.6 mV.

Q: The open-loop system transfer function is given by Ks (s + a)(s² + 14s + 49) G(s) = = The frequency…

A: The Bode plot of the systemThe transfer function of the system ishere

Q: Ξε E₂ HUH Es [ Lún 8. In the figure to the left, the ideal batteries have emfs 8₁ = 20.0 V, 8₂ =…

A: 8. Given Data:A DC resistive circuit with,Battery EMF of,To Find:Values and directions of .Ammeter…

Q: The current (amperes) through the 6-2 resistor is most nearly:

A: It is given that:

Q: The voltage gain of the following circuit is 0.88 where λ=0, then gm = VDD=1.8 V RG 50 KQ Vino M₁ 1…

Concept explainers

DC Generator

An electromechanical machine which converts input mechanical energy to respective output electric energy is called a generator.

Question

What is the output power of the steam generator
with 70 percent efficiency if the coupled turbine
has output power of 900kW.
d) 630kW
c) 500kW
b) 9000kW
a) 8000kW

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data :

VIEW

Step 2: Calculation :

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A mini-hydroelectric power plant is under a head of 275 feet. The turbine efficiency is 0.85 and the generator efficiency is 0.80. If the turbine speed is limited to 450 rpm, calculate the generator kW output.
What is the KW rating of a three phase 975 KVA generator at A) unity power factor B) 80% power factor C) 50% power factor
A 12 V generator has an internal resistance of 0.05 ohm. Two loads are connected in parallel to its terminals, one drawing a 12 A current and the other dissipating energy at the rate of 200 W. What is the terminal voltage of the generator with this load? Ans. 0.82 volts
Three coils each having resistance of 17 Q are connected in star across 437 V, 50 Hz supply. Then the total power consumed is O 6485.84 W O 33700.41 w O 660.83 W O 756.93 W When the load on a series generator is decreased, then the flux produced will be decreased in direct proportion. Select one: O True OMIEE21 O False
10 kW, 230 V, d.c shunt generator is operating at rated condition with 80% efficiency. Input power and the total loss are respectively
Two 800kW alternators A and B operating in parallel. The speed regulation of A is 100% to 103% from full load to no-load and that of B is 100% to 104%. Determine the kW share of A if the total load is 1200kW.
An 8.2kW seriesd generator has an armature resistance is 0.25 ohms with a generated voltage equal to 4212.43 V. Determine the series field resistance should be installed in this machine in order to supply a load at 400V.
The maximum efficiency of 10Kw D.C generator is 98% and occurs at 80% of full load. Find the total copper losses at rated load
For a 3 phase 975 KVA generator.... if the voltage rating is 2400V what is the current rating at each power factor? 1. Unity power factor 2. 80% power factor 3. 50% power factor
Explain the types of generators used in wind turbines with a neat diagram and also discuss the grid-connected issues related to it
In the system given below, each generator is 0.25pu. The reactances are 0.4pu. SB = 50MVA. Calculate the short circuit power at the K point.
5-Synchronous generator ,50 HZ have induced emf of 1.2 pu is connected to an infinite bus of 1 pu voltage .The maximum power that can be transferred if the reactance of generator is 0.2 pu and the rest of the system have a reactance of 0.4 pu is. a) 3pu b) 2pu c) Ipu d) 4pu