Answered: What is current in a 50 µF capacitor if…

What is current in a 50 µF capacitor if the source voltage is 100sin(100t) V? O -500cos(100t) mA -500sin(100t+90°) mA O 500sin(100t-90°) mA O 500cos(100t) mA

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter8: Basic Electric Motors

Section: Chapter Questions

Problem 25RQ: List the five capacitor replacement rules.

See similar textbooks

Related questions

Q: METOWCT OS Q: the circuid in Fiq Fo Eig 4 VE 10 e-4t V (a) Find R and C (b) Deteimine the time…

A: Ohm's Law can be used to find the resistance in the circuit. according to ohm's law, the resistance…

Q: A semiconductor Hall device at T=300 K has th and L=10' cm. The following parameters are meas

Q: The resistor R, a capacitor C, a switch S and a battery are in series (Figure 1). When the switch is…

A: Given circuit is =

Q: The switch in the circuit in (Figure 1) has been in the left position for a long time. At t = 0, it…

A: According to question we have to calculate The initial voltage drop across the capacitor. Initial…

Q: The switch is kept in position (1) for a long time and then suddenly moved to position (2). What is…

Q: An inductor has an inductance of 1H. It is connected in series with a resistance of 23Ω. It is fed…

A: This question belongs to circuit theory . It is based on the concept of transient analysis in RL…

Q: Identify which measurement this oscilloscope time difference reading is useful for. Ociloscope-XSC1…

A: Given, T1= 250us T2= 1.261ms T2-T1= 1.011ms Scale: On x-axis: 200us/Div On y-axis: 100V/Div

Q: A 20 µF capacitor is connected in series with a 50 kQ resistor and the circuit is connected to a 20V…

A: In this question, Resistance and capacitance are connected in the series with DC supply 20v.…

Q: An uncharge capacitor in series with a 120 volt voltmeter of 10,000 ohms resistance is suddenly…

Q: A 17.0 mH inductor, an 7.00 Ω resistor, and a 6.00 V battery are connected in series. The switch is…

A: Given data L= 17 mH R = 7.00Ω Current I=0.999 Imax

Q: inductor has an inductance of 3H. It is connected in series with a resistance of 1Ω. It is fed from…

A: We need to find out the time constant for given circuit

Q: Una tensión de 6e2 00 V aparece entre las terminales de una combinación de un capacitor de 100 mF y…

Q: .A series circuit is comprised of 2 resistors R1 = 500 ohms and R2 = 1000 ohms and a capacitor fC =…

Q: 1. A 2F capacitor is connected in series with a diode and a 60 resistor. The voltage of the battery…

Q: A 25 A electrodynamic ammeter is controlled by a spring having a constant of 5.7295x 10-6 Nm/rad.…

A: The solution is given below

Q: 5μF capacitor is charged so that the p.d. between its plates is 500 V. Calculate how long in sec the…

A: In this question we will find time required by capacitor for average discharge current...

Q: For the given circuit, the switched is closed for a long time and the switched is opened at t=0. R =…

Q: The current in the circuit in the following figure is known to be i= Bje 2000 cosl1500t + Bze 000…

A: (a&b) Write the given expression for current. it=B1e-2000tcos500t+B2e-2000tsin1500t

Q: One capacitor C, = 3 µF is charged up using a V, = 3 volt battery, then %3D disconnect from the…

A: For C1 =3 micro Farad, It is charged upto 3 volts. So charge on these capacitors will be , from…

Q: ssume that the switch has been in position B for a long time and is then moved to position A. If the…

A: Find the value of capacitor C. Time t= 0 switch move at position A. At time t= 4s voltage across…

Q: There is no load on the top terminal of the circuit element below for t < 0. At t = 0, a current…

A: The current for the given periods of time is expressed as: i(t)=0…

Q: 7. Determine the time dependence of the current through the capacitor switching at the time when…

Q: For the given circuit, the switched is closed for a long time and the switched is opened at t=0. R=…

A: Given circuit, R= 12 kΩ c = 8μF I= 9 mA t= 0.2 sec

Q: 8. a). What are the values of the inductor voltage and current and the capacitor voltage and current…

A: Given data, Circuit diagram is given as,

Q: 20μF capacitor is connected in series with a 40 kΩ resistor and the circuit is connected to a 30V…

Q: 23. Determine the potential difference across a 4µF capacitor when charged with 5 mC. a. 1250 kV b.…

A: In this question we need to choose a correct option.

Q: Bt 0 42 8V 2H 10V Part I: For the above circuit, the switch has been in position A for a very long…

A: To find the inductor current equation iL(t) for all time t

Q: 12 uF 3 µF 11 F 6 uF

A: The capacitor is a charge storing electrical element. when the capacitor is connected across the…

Q: In the circuit of the image, the capacitor is initially discharged, with the switch open. Values are…

A: In the circuit of the image, the capacitor is initially discharged, with the switch open. Therefore,…

Q: What is the voltage across a 50 mH inductor if it takes a current of 100sin(100t) mA? -500cos(100t)…

Q: A supercapacitor is connected to a DC voltage source through a resistor. The initial capacitor…

A: A parallel placed plate capacitor can hold a limited value of electric energy before a collapse…

Q: a 100-uF capacitor is i(t)=50sin(120πt)50sin(120πt) mA. Calculate the voltage across it at t=1ms and…

Q: how long will it take to charge a 1000μF capacitor through 1 KQ resistor to full 16V source voltage?…

A: Since you have posted the multiple questions so we are supposed to answer the 1st one.

Q: Uniform quantization is more suitable for: a. None of the mentioned b. Strong signals c. Weak…

A: Ans. Strong signal

Q: a C: The switch in the circuit above has been in position a for a long time. The variables in the…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: 2A(1 5Ω > t = 0 C mF: t = 0 1 A 1092 xt = tx IR = tx ms 20 V LmH Assume that all switches have been…

A: Solution- t=∞ capacitor open, inductor short circuitVc0+ =Vc0- - for capacitoriL0+=iL0- - for…

Q: An electric circuit contains an 8 ohm resistor in series with an inductor of 0.50 henries and a…

A: Given parameters are: L=0.5H, At t=0, I=0 E=8te-16t The circuit can be drawn as:

Q: The network shown below sits in position 1 10 minutes before the switch is moved to position 2. How…

Q: A 25 A electrodynamic ammeter is controlled by a spring having a constant of 5.7295x 10 Nm/rad. The…

A: In this question we need to find

Q: In the circuit, V is a 3.4 V battery, C is a 71.3 μC capacitor, L is a 29.6 mH coil (with no…

A: Initially t<0, switch will be open. So, In steady state VC0-=0V,IL0-=0A Now, when switch will…

Q: What is current in a 50 µF capacitor if the source voltage is 100sin(100t) V? 500cos(100t) mA…

A: Given data, Capacitance is given,C=50 μF Source voltage is given, Vs=100sin100t V

Q: 古 Or For the given circuit, the switched is closed for a long time and the switched is opened at…

Q: Calculate the ratio iC2/iT. Enter your answer rounded to 2 decimal places. All capacitors were…

A: By current division rule for Capacitor Ic2 = iT C2/(C1+C2) iC2/ iT = C2/(C1+ C2)

Q: A 20μF capacitor is connected in series with a 40 kΩ resistor and the circuit is connected to a 30V…

Q: C2 The next two questions refer to the following figure. The switch is initially open and both…

A: The storage elements such as inductors and capacitors have the property to store energy across them.…

Q: (A) 0.25 uF 10V 2uF 4uF (B) Figure 3: 3. In Figure 3 the capacitors were discharged before being…

A: NOTE: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Concept explainers

Code Conversion

The method or technique used to convert code from one format to another is termed code conversion. Code conversions are most commonly used in computers, digital electronics, microprocessors, etc.

Question

Please provide a clear and complete solution. Use stored values to lessen round-off errors. Maintain answers to 3 decimal places. Please answer fast for I have 30 minutes left. Thank you.

What is current in a 50 µF capacitor if the source voltage is 100sin(100t) V?
-500cos(100t) mA
-500sin(100t+90°) mA
500sin(100t-90°) mA
500cos(100t) mA

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Arithmetic Operation and Code Conversion in Number System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
Two capacitors having values of 80 F and 60 F are connected in series. What is the total capacitance?
What is the unit of measurement for the strength of a capacitor? microamp microtorque microfarad microwatt
List the five capacitor replacement rules.
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
Three capacitors having values of 2.2 F, 280 F, and 470 pF are connected in parallel. What is the total capacitance?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?