What are the disadvantages of incubator
Q: ) Explain the Voltmeter PMMC instrument and the Ammeter PMMC instrument in AC
A: We are authorized to answer one question at a time, since you have not mentioned which question you…
Q: Identify and explain the different notational methods for describing the behavior of gases and…
A: Gates: It is an electronic circuit and has logical decisions based on applied input.
Q: A. explain method of locating reactors-bus bar reactors.
A: Note- As per given in the question, solving the first question, if required post other question as…
Q: I need a diagram of a circuit by the transform and rectification block, using the bridge rectifier…
A:
Q: Discuss whether NEC provides the maximum requirements or minimum requirements.
A: NEC is the acronym of National Electrical Code.
Q: 4 Explain the operation of thermochemical energy storage system.
A: Thermochemical energy storage systems are basically the energy stored from the sun in the form of…
Q: design a controlled single phase rectifier
A: Controlled single phase rectifier.
Q: Answer in Sentence/Paragraph form. Maximum of 5 sentences each. Lesson: Electronics: HALF-WAVE…
A: As per the guidelines of Bartley we supposed to answer first three subpart only
Q: ckt diagram of refrigerator
A: In refrigerator, split single phase induction motor is used to run the compressor unit. Compressor…
Q: A DC generator or AC generator with rectifier having the same output voltage produced, which is…
A: Generator is a machine which takes mechanical input and gives electrical output. DC generator will…
Q: What is transient stability in power system
A: It is defined as when a large disturbance take place in power system if the rotor position return to…
Q: 3. Write any four differences between NC and CNC machines.
A: Ans. Given below
Q: What are the incubator parts
A: Incubator - An incubator is used to provide safe and controlled space for infants to live while…
Q: 1 Determine the state table and state flow diagram for the following ckt. D D D' D' clock
A:
Q: 1.List the three steps of nuclear fuel fabrication processes. Also sketch a schematic diagram and…
A: Different energy sources are required in day to day life. These energy sources can be renewable or…
Q: Describe the Charging a Compressed Air Storage System.
A: Describe the Charging a Compressed Air Storage System.
Q: Explain isolated operation of solar PV system
A: Solar PV system A photovoltaic system, also known as a PV system or solar power system, is an…
Q: With the help of a well labelled schematic diagram, explain the design and operation of a regulated…
A:
Q: design a uncontrolled and controlled single phase rectifier
A: Rectifier is device that convert an two direction AC to single DC . it is used in power application…
Q: i) Draw the circuit diagram of the single phase full wave controlled rectifier (RL load) with…
A:
Q: State and explain the two parameters that characterise the design core thermal performance of a…
A: It is asked to state two parameters that characterize the design core thermal performance of a power…
Q: a) It is important to manage heat dissipation for power control components such as Thyristor. Draw a…
A: Since you have asked multiple questions, we will solve the first question for you. If you want any…
Q: With a neat diagram ,explain about the working of Dual Slope ADC.
A:
Q: explain the binary cycle plants in geothermal energy conversion system
A: Binary cycle geothermal power plant:
Q: The average value of the output voltage of a half wave rectifier is greater than the average value…
A: In this question we need to verify the given statement is true or false
Q: What do you understand by Safety factor, puncture and Flashover of Insulator
A: The part section of a pin type insulator is shown in the figure below:
Q: Comparing the performance with controlled rectifier circuit which one of the following statement is…
A: Ans. small filter are required
Q: Suppose line voltage may be as low as 105 Vrms or as high as 125 Vrms in a half-wave rectifier. With…
A: In this question, line voltage may be as low as 105 Vrms or as high as 125 Vrms in a half-wave…
Q: Both ripple factor and harmonic factor should be unity for ideal controlled rectifier. Select one:…
A: ripple factor and harmonic factor Ripple factor =√(FF2-1) should be unity for ideal controlled…
Q: Draw the equivalent circuits of Class E chopper for the different quadrant operation and write its…
A:
Q: 2.Why do you use filters in Rectifier circuit ?
A: Different loads require different voltages, either AC or DC. Supply present naturally is AC supply,…
Q: (i) Draw the circuit diagram of the single phase full wave controlled rectifier (RL load) with…
A: Answer(1) The rectifier circuit which uses only diodes are called uncontrolled rectifiers and the…
Q: In a base 2 numeration system what will be the largest number you can get?
A: In a base 2 numeration system what will be the largest number you can get?
Q: State three points of difference between continuous process and batch process
A: A batch process is one that comprises a set of stages that must be completed in a certain order. The…
Q: design a uncontrolled three phase rectifier
A: Uncontrolled three-phase rectifier: Rectifier is used to convert the AC signal into DC signal. When…
Q: design a controlled three phase rectifier
A: CONTROLLED THREE PHASE RECTIFIER: 1. Uncontrolled three-phase rectification employs diodes to…
Q: Please send the Design of the tank as photo or PDF file the Design sketch of the tank is require…
A: The diagram of the tank is presented in the following section.
Q: stability
A:
Q: incubator working principle
A: Incubator : It's an electronic device which grow and maintain cell culture .
Q: 4. Explain the operation of thermochemical energy storage system.
A: Thermal energy storage (TES) is an advanced method to store thermal energy and facilitate more…
Q: Using the mean value theorem, calculate the mean value of the output voltage for the half-wave,…
A:
Q: Figure 1 shows the circuit diagram for a simple d.c. power supply. a. Identify the type of rectifier…
A: A:
Q: Which is better and why, dc generator or ac generator including rectifier, both ac and dc generators…
A: In this question we discuss which generator is better for DC output AC generator with rectifier or…
Q: c) clarify the advantages and limitations of GMAW process. d) discuss the function of shielding gas…
A: Advantages of GMAW: It can be completely automatic, bringing about higher usefulness. It can be…
Q: Give some application examples of Single-Acting Linear actuators
A: A linear actuator changes the rotational motion of a motor into a straight line. Single action is a…
Q: esign a uncontrolled single phase rectifier
A: Rectifier circuit is build up of diodes as the rectifier circuits converts the AC to DC
Q: b) The maximum mean output voltage of a three-phase controlled full-wave rectifier is 540.2 V whilst…
A: Given Parameters of a full wave rectifier we need to find the ripple factor of full wave and half…
Step by step
Solved in 2 steps
- With a neat diagram ,explain about the working of Dual Slope ADC.transformer ac line 120 V (ms) 60 Hz Diode rectifier Voltage regulator Filter Load Block diagram of the rectifier circuit is given above. Create a block diagram for audio amplifier system with at least 5 blocks (Add physical equivalent of the input and output). Indicate all the input and output signals and voltage levels approximately on the diagram. Explain briefly the design steps of the audio amplifier with your own words. Comment about the most critical parts to be considered in designing process.2. a) Explain briefly the physical principle/mechanism generating thermal noise with an example b) What is shot noise? Give an example.
- A 3 phase fully controlled rectifier has a 3 phase line to line supply voltage of 410 V rms at 50 Hz for 12 ohm and 1 H load. If the firing angle a = 50, then the average output voltage is V. By comparing the performance of DC -DC chopper with controlled rectifier circuit which one of the following statement is wrong ? a. Efficiency is better in chopper circuit b. Regenerative braking process is very slow in chopper circuit O . small filters are required in chopper circuit O d. Switching frequency is responsible for output ripples in chopper circuit3. A firing angle controlled triac is feeding a R-L load with L=16 mH and R=12 ohm.The triac input voltage is 220 V rms and 50 Hz. a) Calculate the minimum firing angle at which triac can be fired. b) If firing angle is 27 degress find the angle B at which zero current occurs. c) Find the current 5 msec after firing.What are the Suitable sensors for design and appropriate actuators for design
- Give example with aid of diagrams and explain the usage of capacitive transducer as: i) Pressure sensor ii) Displacement sensor and What are the advantages of piezoelectric compare to capacitive transducers? Provide an example of electronic device that uses piezoelectricity and explain its concept based on the type of piezoelectric effect.Subject Linear Control I need answer for MCQwhat is a demagnetizing factor and what is it used for? does it have any dimensions or units? what does it depend on?
- a- What is the diffusion Process? Why it is used? b- Explain in your own words the meaning of in integrated circuits.Question 1 A controlled full-wave bridge rectifier as shown in the Figure; has a source of (120 V rms) at 60 Hz, with RL load where (R = 10 and L = 100 mH). The delay angle is 60 degree and L is larger find: (a) Verify that the load current is continuous. (b) Determine the DC (average) and the RMS of the current. (c) Determine the power absorbed from source by the load and the PF2. A full wave rectifier is used to convert 400 Hz ac todc Design a full-wave rectifier power supply that will deliver a dc outpuvoltages 15V and the load current is 1A. RSIT