Using the Reactance approach, calculate vo across the capacitor.0.5 Hm20 cos(10t+100°)1092-18

Given, The circuit diagram, The input voltage, V=20cos10t+100° V=20∠100° V

Answered: Using the Reactance approach, calculate…

Science

Physics

Using the Reactance approach, calculate v, across the capacitor. 20 cos(10t+100°) 0.5 H [mm] 1092 20 F +1

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter23: Electromagnetic Induction, Ac Circuits, And Electrical Technologies

Section: Chapter Questions

Problem 89PE: The capacitor in Figure 23.55(b) will filler high—frequency signals by shorting them to...

See similar textbooks

Related questions

Q: A gymnast is performing a floor routine. In a tumbling run she spins through the air, increasing her…

Q: The International Space Station orbits the Earth in an approximately circular orbit at the height of…

Q: ter travels through a pipe at 10.5 m/s. The pipe expands from a crossectional area of 2.4 m2 to an…

Q: Fg and F represents gravitational and ele respectively between electrons situated at a distance 10…

Q: The coefficient of heat expansion for Aluminum is 2.4 ×10-5 degrees C A 420 m bridge made of…

A: Formula for coefficent of linear expansion: ∆L=Loα∆T

Q: Block 1 (10 kg) is pulled by a rope from left to right up a ramp which is inclined 50 degrees from…

Q: A current of 9 A flows through an appliance connected to a standard 120-volt outlet. Calculate the…

Q: A race car travels with a constant tangential speed of 77.4 m/s around a circular track of radius…

A: Given data: Constant tangential speed (v) = 77.4 m/s Radius of circular path (r) = 677 m Required:…

Q: cyclist starts from rest and pedals such that the wheels of his bike have a constant angular…

Q: PROBLEM 3 Determine the motion of the guiding center of a particle with mass m and charge q in the…

A: Consider a particle of mass m, charge q and revolving around a current carrying wire. The magnetic…

Q: A 115 g granite cube slides down a 35° frictionless ramp. At the bottom, just as it exits onto a…

Q: A grandfather clock is powered by the descent of a 4.35 kg weight.(a) If the weight descends through…

A: power = mgh / t = 4.35 * 9.8 * 0.76 / ( 3.25 *24*60*60 )

Q: This time, V = 88.6 V; R1 = 106 Ohms; R2 = 86 Ohms; R3 = 121 Ohms; R4 = 167 Ohms; R5 = 123 Ohms; and…

Q: A 175.0 km long electric power line made out of copper is installed during the Spring months at an…

A: Given,The length of the electric power line made out of copper at 10.9°C = 175 kmThe coefficient of…

Q: beam of unpolarized light passes through two polarizers whose transmission axes are at an angle of…

Q: The bulldozer for the DPWH road widening project at Koronadal City has a gasoline engine that takes…

A: Introduction: Concepts of Heat Engine: It is a thermodynamic engine works on a first law of…

Q: In the deepest woods of Siberia the temperature on a cold Winter night can be as low as -55.0 °C.…

A: Given, In the first question, Temperature = - 55°C In the second question, Temperature = 128°C We…

Q: When the light illustrated in Figure P35.21 passes through the glass block, it is shifted laterally…

Q: Here, theta (the angle the incident ray makes with respect to the vertical) is 37.1 degrees. What is…

A: Given angle of incidence, θ=37.1 degreesthickness of slab, t=10 mn1=1.33n2=1.5we need to find d,

Q: The initial angular velocity and the angular acceleration of four rotating objects at the same…

Q: skateboarder starts at point A in Figure 8–27 and rises to a height of 2.64 m above the top of the…

Q: The bob of a simple pendulum has a maximum speed of v_max = 2 m/s. What would be the bob's speed…

Q: This time the sheet has charge density 5.38 x 10^-6 C, and your mass including the suit is 69.8 kg.…

Q: 4. (a 5) Power stations are normally far away from the customers. A transformer is often used to…

A: Given that- 5. (a) A TRANSFORMER TO DETERMINE THAT why do we use to high voltage to transmit the…

Q: 4. What type of particle is emitted in each nuclear reaction? a. 325i - ³2p b. 18F-180 C.…

Q: A ball is thrown horizontally at a velocity of 4.0 m/s. a) What is its final velocity after 0.75…

A: When a particle is launched obliquely toward the surface of the earth, it moves along a curved path…

Q: A rotating door is made from four rectangular glass panes, as shown in the figure. The mass of each…

Q: Calculate the energy in joules used by a 47 W appliance that is operated for 5 minutes.

A: Given data: Power (P) = 47 W Time (t) = 5 minutes Required: The energy (E) in Joules

Q: The main bone of the forearm is connected to the arm bone through the elbow joint. Two muscles, the…

Q: An ice cube is placed on top of an overturned spherical bowl of radius r, as indicated in Figure…

A: ?E = 0m g R - ½ m V² - m g R cos ? = 0m V² = 2mgR(1 - cos ?)

Q: This time, V = 93.7 V; R1 = 194 Ohms; R2 = 111 Ohms; R3 = 183 Ohms; R4 = 155 Ohms; R5 = 85 Ohms; and…

Q: If the average household in a region consumes about 5,250 kWh of energy per year. In the region, the…

A: Given Avg energy consumption in an year = 5,250 kWh Avg annual solar energy potential per year…

Q: The atoms of an FCC lattice are hard spheres touching the surfaces of the nearest neighbors. f the…

A: Given effective radius r=4.25 Angstrom= 4.25*10-10 m In FCC lattice the number of atoms per unit…

Q: The equation of motion of a simple harmonic oscillator is given by x(t) = 0.4 cos (nt/2 + 1/4). At…

A: Given the equation of motion: x(t)=0.4cosπt2+π4 we need to find the time when it will cross the…

Q: A block (mass = 1.8 kg) is hanging from a massless cord that is wrapped around a pulley (moment of…

A: Visualize the Problem:

Q: The tangential acceleration does not depend on the angular velocity. The tangential acceleration is…

Q: An alpha particle (4He) undergoes an elastic collision with a stationary uranium nucleus (235U).…

A: Introduction: Elastic Collision: A collision in which there is no loss of momentum & Kinetic…

Q: As illustrated, A flat disk with a mass of 1.387 kg slides on a horizontal frictionless surface. The…

A: Given mass , m=1.387 kginitial velocity, vA=2.673 m/schord stiffness , k=8.112 N/minitial position,…

Q: 3. Two forces, 200 N and 250 N act at the same point of an object and an angle of 30° with each…

Q: Jogger A has a mass m and a speed v, jogger B has a mass m/2 and a speed 3v, jogger C has a mass 3m…

Q: A grindstone of radius 4.0 m is initially spinning with an angular speed of 8.0 rad/s. The angular…

Q: The speed of light ?c in a vacuum is 2.997×108 m/s. a) Given that the index of refraction in…

Q: A microwave beam with a wavelength of 1.5 cm has an intensity of 28 W/m². Part A What is the…

A: Given Intensity (I) = 28 W/m2wavelength (λ) =1.5 cm

Q: Light of wavelength 625 nm falls on a double slit, and the first bright fringe of the interference…

A: Given: The wavelength of light is 625 nm. The angle is 16.6o.

Q: Now you have a nucleus with 7 protons at x = 4.1 Angstroms on the x-axis. How much work would it…

Q: A person lowers a bucket into a well by turning the hand crank, as the drawing illustrates. The…

Q: disc with a radius of 50 cm rotates on itself. At t=0, it rotates at 0.5 rad/s counterclockwise. At…

Q: Block 1 (10 kg) is pulled by a rope from left to right up a ramp which is inclined 50 degrees from…

Q: A Ferris wheel rotates at an angular velocity of 0.29 rad/s. Starting from rest, it reaches its…

Q: Review Multiple-Concept Example 7 in this chapter as an aid in solving this problem. In a fast-pitch…

Question

Using the Reactance approach, calculate vo across the capacitor.
0.5 H
m
20 cos(10t+100°)
1092
-18

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The capacitor in Figure 23.55(b) will filler high—frequency signals by shorting them to earth/ground. (a) What capacitance is needed to produce a reactance of 10-0 m for a 5.00 kHz signal? (b) What would its reactance be at 3.00 Hz? (c) Discuss the implications of your answers to (a) and (b).
The voltage across a parallel-plate capacitor with area A=800cm2 and separation d = 2 mm varies sinusoidally as V = (15 mV) cos (150t), where t is in seconds. Find the displacement current between the plates.
Q2.A) Calculate Vo for a ladder non- inverting R-2R DAC if the i/p digital word was [1011]( R=D1K ohm , Vref= 5V)
> If we use 5000 µF, we can get a very low ripple voltage. But this is so bad and this a disadvantage, why?
1. Determine what capacitance should be used to produce a 2.4 M2 reactance at 68 Hz. Capacitance, C: VnF
Q-8 Determine the Thévenin equivalent at the output terminals a-b with a signal vs = cos(10,000t + 53.1°). 3i/2 2Ω a 200 μΗ Us 25 μF b
Phase Angle. An LRC circuit has the following parameters: X₁ = 5N, Xc = 3N, and R= 20. Which of the following diagrams best represents the phasors of the current and source voltage of the LRC circuit at a certain point in time? V V V 45° A 90° с O A. Voltage leads current by 45° B. Current leads voltage by 45° C. Voltage leads current by 90° D. Current leads voltage by 90° 45° B 90° D V
For an AM envelope with maximum peak a voltage of 52 V and minimum peak to a peak voltage of 24 determine the ff. a. Percent modulation Blank 1 b. Peak voltages of the carrier and side frequenciesBlank 2 Maximum positive to negative с. envelope voltage Blank 3
Q.7: Reactance of capacitor of capacitance C AC frequency 400/t Hz is 25 Q. The value of C is (CET-2002) (a) 50 µF (b) 25 µF (c)100 uF (d) 75 uF
a) The voltage across a 20µF capacitance is v. = 50 sin( at – 80°) volts and Frequency equal to 100 Hz. Determine the current through the capacitor iç and sketch its waveform. b) Define phasor
Now that you un X atv Apple TV+ xM Inbox (410) - ralk x Bb Labs-2020SP_F X Bb EGR 1 av/pid-11233572-dt-content-rid-64302866_1/courses/2020_SP EGR_150_1013/Spring%202020%20-% 2. Calculate the voltage difference between the power supply of circuit 1 and circuit 2 shown below in the circuit diagrams. Both circuits have the identical quantity of current in amps. ENGINEERING METHOD BELOW. What is your calculated answer most closely to? MUST SHOW a. 0.5 volt b. 1 volt c. 5 volts d. 10 volts R1 = 1.5 k2 6 V Find: R2 = 250 2 Given: R1 = 0.911 kO %3D R3 9.3 k2 Solution: R2= 4.1 kQ R= 175 2 MacBook Air F9 F8 F5 F6 F7 F4 & 2$ 4 * 00
ook aring /session.masteringphysics.com/myct/temview?assignment ProblemiD=195605... 2 Fon Q A A radio can be tuned into a particular station frequency by adjusting the capacitance in an L-C circuit. Suppose that the minimum capacitance of a variable capacitor in a radio is 4.13 pF Z C 2 W S x H command Mak 201 2 3 E D 13.0 с 4 R F 96 5 V T I FS G ▼ Part A 6 What is the inductance L of a coil connected to this capacitor if the oscillation frequency of the L-C circuit is 1.69 MHz corresponding to one end of the AM radio broadcast band, when the capacitor is set to its minimum capacitance? Express your answer in henrys to three significant figures. ▸ View Available Hint(s) B L= Submit Part B Cax Provide Feedback Submit 15] ΑΣΦΑ The frequency at the other end of the broadcast band is 0.533 MHz. What is the maximum capacitance Cax of the capacitor if the oscillation frequency is adjustable over the range of the broadcast band? Express your answer in farads to three significant figures. View…