Using the Engineering Scale 1" = 20', what is the red dimension below to the nearest foot? 20 20 0 1 2 3 4 5 6

Draw the Orthographic Projections ( Top View, Front View, Side View) For the Shapes Shown Below, Using Scale ( 2:1) $25 23 40 30 42 75

Build the following part. Report the volume in mm^3. Assume all dimensions are in mm. A=52 B=19 Your answer should have 0 decimal places needed. Ex: 76,440 10 - 30 B

In which of the following type of dimensioning, the dimensions are arranged only in a straight line? Staggered Dimension Parallel dimension Combined dimension O Aligned dimension

Using the diagram, determine the minimum diameter for DIA B, in inches. Tin la Gallery 1 H DIAA 00000" 00016 BASIC DIMENSIONS DIA A 14230 DIA E# 14208 DIA B 00016 0.0000

52 What is the distance between the center of circle A and the corner at B? R3 03 Start a new drawing based on Mech-Millimeters.dwt. Draw the object shown in Figure A-1, starting with the center of the Ø3 circle at point 5,5. Draw only the object, not the dimensions and then answer the following questions: O 186794 198628 193132 171870 R1.0 TYP. 18 8 2 2 1 10

6. On an engineering drawing a dimension is laid out as 1.760 + 0.005 A note on the drawing states that all dimensions are in inches. Give numerical values for (a) The nominal dimension (b) The upper limit (c) The tolerance (d) The bilateral tolerance

Question 1: Draw the front view and top view for the given drawing with the dimensions. Use suitable scale. Mark all the dimensions given in the drawing. 30 10 Į Top 26 80 46 Front 07 OL

Show the tolerance zone created by each of the given tolerance specfication. Superimpose the tolerance zone on the given drawing.

Draw back the drawing given  with the scale 1:1 on the new drawing paper using all the method on geometric construction. Dimension must be included. all dimension in mm