The voltage, V, (in volts) across a circuit is given by Ohm's law: V = IR, where I is the current (in amps) flowing through the circuitand Ris the resistance (in ohms). If we place two circuits, with resistance Ri and R2, in parallel, then their combined resistance, R, is1.1given by -RSuppose the current is 5 amps and increasing at 10-2 amp/sec and Ry is 6 ohms and increasing at 0.6%3DR' R2ohm/sec, while R2 is 7 ohms and decreasing at 0.5 ohm/sec. Calculate the rate at which the voltage is changing.Round your answer to three decimal places.volts/sec

Answered: Image /qna-images/answer/2645fba2-ea80-4ec9-8bcf-6aaadbe3521c.jpg

The voltage, V, (in volts) across a circuit is given by Ohm's law: V = IR, where I is the current (in amps) flowing through the circuit and Ris the resistance (in ohms). If we place two circuits, with resistance R1 and R2, in parallel, then their combined resistance, R, is 1 1 given by - Suppose the current is 5 amps and increasing at 10-2 amp/sec and Ry is 6 ohms and increasing at 0.6 %3D R R R2 ohm/sec, while R2 is 7 ohms and decreasing at 0.5 ohm/sec. Calculate the rate at which the voltage is changing. Round your answer to three decimal places. volts/sec

The voltage, V, (in volts) across a circuit is given by Ohm's law: V = IR, where I is the current (in amps) flowing through the circuit and Ris the resistance (in ohms). If we place two circuits, with resistance R1 and R2, in parallel, then their combined resistance, R, is 1 1 given by - Suppose the current is 5 amps and increasing at 10-2 amp/sec and Ry is 6 ohms and increasing at 0.6 %3D R R R2 ohm/sec, while R2 is 7 ohms and decreasing at 0.5 ohm/sec. Calculate the rate at which the voltage is changing. Round your answer to three decimal places. volts/sec

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter16: Electromagnetic Waves

Section: Chapter Questions

Problem 78P: The prefix “mega” (M) and “kilo” (k), when referring to amounts of computer data, refer to factors...

See similar textbooks

Similar questions

If you made a plot of current versus voltage and calculated a slope of (0.00378 ±0.000218) A/N. What is the value of R assuming the data were plotted in MKS units? R = ohms Check
What is the resistance of R1 if the total resistance Rt of the parallel circuit shown is 3.2 ohms?
if the current passes R1 is 25mA and the voltage at R2 is 25 V, what is the value of R2 ?
Part (b): Watts, volts, and ohms are SI units that can be expressed in the 'base' SI units as follows: kg-m² 53 ohm = kg-m² $³.A21 watt = volt= bottle cm kg.m² $3.A' (Recall that 'A' is the abbreviation for an ampere.) Use algebra and the equation at the top of the page (P=V²/R) to show that the base SI units for watts equal the base SI units for volts²/ohms. You do not need any numbers in this algebraic exercise. Instead, treat each of the base SI units (kg, m, s, A) as if it were an algebra variable (like x or y). Start with the following equation and substitute the base SI units for watt, volt, and ohm: watt = volt² ohm
In the experiment, you measured a voltage 3V across a resistor, and a current 527mA through it. What is the resistance in unit of N?
The total voltage in the circuit show in Fig. 1 is 30 V. The resistance of each resistor is:?1 = 2Ω, ?2 = 1Ω , ?3 = 2Ω , ?4 = 2Ω, ?5 = 1Ω, ?6 = 2Ω, ?7 = 1Ω. Calculatethe total current and total resistance in the system. Figure 1: Combination of series and Parallel Circuit (Imge added)
If an appliance has a current of 2.5 amperes and will be used for 8 hours. Whatis the battery capacity needed in terms of mAh?
What is the total resistance of a circuit if 3 resistors, R1 = 91 ohms, R2 = 66 ohms, R3 = 44 ohms, are wired in parallel?
In the next diagram, the voltage through the circuit is 100 V. Determinethe electric charge and voltagein each capacitor.
Calculate the resistance and the current of a 1500-Watt electric hair dryer plugged into a US household outlet (120 V).
If an electrical supply does 25 Joules of work and creates a 2-amp current in a heater through the heaters 10 ohm resistor, how long was that heater on for? 4. For question 3, what is the voltage of the electrical power supply?
An electric circuit has a total of 68.8 Ohms of resistance, and is operated under a voltage of 78 volts. What is the power in this circuit? Your answer should be in Watts, but do not write the unit, just the number.