Answered: The steady state stability limit of a…

The steady state stability limit of a synchronous machine connected to infinite bus is 2.2 p.u. infinite bus voltage is 1 p.u. The transfer reactance between generator and infinite bus is?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.48P

See similar textbooks

Related questions

Q: 1. For the circuit shown in Figure 5.56, use superposition to find v

Q: 5. Sketch Vout if Vin (t) = 2sin20t in figure 2.6.2

Q: In how many seconds after t=0 has the current i(t) become one half of its initial value in the given…

Q: List the cause of fault in different equipment in a single system

A: A fault happens when a conductor's insulation fails at one or more points, or when a conducting item…

Q: d) Discuss the procedure for computation of fault current in power system when a double line to…

Q: A DC shunt generator has a field winding resistance of 110 ohms and a load current of 250 amps at…

A: Solution- DC shunt generator, from the diagram- Ia = IL+Ish

Q: An impulse generator has eight stages with each condenser rated for 0.16 µF and 125 kV. The load…

Q: Using the discrete-time signals yı[n] and y₂[n] where: y1 [n] [-1 0 1 3 - 1 3 - 1] and y2[n] = [-2…

Q: a) A 100 HP, 3 phase, 6 pole, 50 Hz induction motor has rotor impedance of (0.02+j0.15) per phase at…

A: a) A 100 HP , 3- phase induction motor (i) Full load speed (ii) Frequency of rotor current at full…

Q: Explain in detail "phase shift in star delta transform" for positive and negative sequence voltages.…

A: Types of phase sequence in unbalanced system Positive phase sequence Negative phase sequence…

Q: Design and construct/draw a low-pass Butterworth filter with a roll-off of rate of -60 dB/decade and…

A: Given: A 3rd order low-pass Butterworth filter whose cutoff frequency is 10 kHz. Required: Design of…

Q: An AC voltage source has an output of v = (220 V) sin 2 T It and connected to a 70 resistor as shown…

A: Current: It is the time rate of the change of the charges. It is also known as the flow of the…

Q: Q1. Using the concepts delivered in Maxwell's equation, develop an explanation of uniform plane wave…

A: All four equations of Maxwell in the phasor form are shown below:…

Q: A 100 KVA transformer is at 80% of full-load with power factor of 0.85 lagging. What KVA of load of…

Q: 5. How many electrons will pass through a conductor in 4 minutes and 30 seconds if the current is 45…

A: Given, Time, t=4 min 30 sec Current, I=450 mA

Q: The Laplace transform of the following function is: f(t)=2*e-3tcos(5t) u(t) O a. F(s)=2*e 3s(s²+25)…

A: Use laplace transform properties and laplace transform table to find laplace transform of the given…

Q: If a finite number of blocks are connected in cascade configuration, then how are the blocks…

Q: (9) A carrier frequency of 105 Hz modulated by a message signal m(t) produced an FM signal expressed…

A: Given here a FM signal and asked to find the modulation index.

Q: For an AM Radio, the message Root Mean Square is 2√2. Plot the AM signal using the following graph…

Q: The maximum value of mutual inductance of two inductively coupled coils with self inductance of L₁ =…

A: Given: Self inductance, L1=36 mH Self inductance, L2=9 mH

Q: A 2-pole, 50 Hz, 11 kV 100 MW alternator has a moment of inertia of 10,000 kg.m². The value of…

A: Given, An alternator has Number of pole, P = 2 Frequency, f = 50 Hz Power rating, S = 100 MW Moment…

Q: 10.36 Compute V, in the circuit of Fig. 10.81 using mesh analysis. ML 4/90° A j4Ω m 2 Ω www 2Ω V₂…

A: Given figure,

Q: An electric circuit contains a 1-H inductor, a 4-$ resistor, and a voltage source of sin t. The…

Q: Two impedances Z & Z are connected in parallel across applied voltage of (100+j200) volts. The total…

A: It is given that: V=100+j200 VI1=16 APT=5 KW=5000 WR=5 Ω

Q: What are the characteristics of an ideal operational amplifier?

A: In the following section, the characteristics of an ideal operational amplifier have been described.…

Q: If the primary line voltage rating is 3.3 kV (Y side) of a 25 KVA, Y-A transformer (the per phase…

A: Given: A Y-∆ transformer has, Line voltage rating at Y side, VL=3.3 kV Power rating, P = 25 kVA…

Q: The transfer function of the following closed-loop system is: O O R(s) O G(s) 1-G(s)H(s) H(s)…

Q: Given points P(4,3,0), Q(2,2,-2), T(4,3,3) forms a triangle. Find the unit vector in the plane of…

A: Given points P4,3,0, Q2,2,-2,T4,3,3 forms a triangle.The given points P4,3,0, Q2,2,-2,T4,3,3 lie in…

Q: remedies

Q: g(t) = 10cos (150xt+) Find the fundamental period and fundamental frequency of g(t). The fundamental…

A: Given data, Function gt=10cos150πt+π4

Q: 7. Calculate the a and ß when the emitter current of BJT is equal to 1 mA and the collector current…

A: Given: In a BJT IE=1 mAIC=0.995 mA

Q: 6.28 If the transistor in the circuit of Fig. 6.29(a) is replaced with another having half the value…

Q: with semiconductor Define the parameter, e (epsilon), as used detectors. How does the numerical…

A: A semiconductor detector is a radiation detector which is based on a semiconductor such as silicon…

Q: What are rotor faults in alternators

A: The rotor of an alternator is directly connected with field winding of the alternator whenever there…

Q: In order to connect a LED to one of the pins: O You need to define that LED as an OUTPUT in the…

A: 1. Answer: you need to define that LED as an OUTPUT in the setup function. Explanation: a. Whenever…

Q: Assume zero initial conditions and no damping and solve for the response of a mass-spring system to…

Q: s²+1 - s(s2+28+8+ Consider the Laplace function F(s) its denominator. How many zeros H(s) has? 02 O…

Q: A continuous-time signal x(t) is sampled at a 10-Hz rate, with the resulting discrete-time signals…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: A single-phase half-controlled rectifier supplies a 220 V, 1200 RPM, 10 A rated DC motor from a 220…

A: Single-phase half-controlled rectifier: It converts AC input to DC output and controlled means that…

Q: For questions 1-4 use the following circuit diagram of two bulbs in parallel to answer the…

A: Given, IB=0.5 AIC=0.05 A

Q: sing Kirchoff's law, calculate each current: 11, 12 and (11-12) in the following electronic ircuit:…

Q: The transfer function of the following closed-loop system is: R(s) H(s) 1-G(s)H(s) G(s) 1+G(s)H(s)…

A: In this question we will find transfer function of given system....

Q: b) Find IB, IC, IE, VB and V. in Figure 1 where ßdc is 50. Assume that the transistor is of silicon…

Q: d) What is meant by directional feature of a directional over current relay? Describe the…

A: (d) The directional over-current relay will function for the flow of the fault current in either…

Q: 13.78 currents in the circuit of Fig. 13.140. 1+ 100/30° V (+ 20 Ω I₁ j80 Ω determine the mesh 40 Ω…

Q: 1. Find the ammeter current in Fig. 2.57 by using loop analysis. 2V 10 ww ww 103

A: Given circuit,

Q: In free space, let Q1 = 10nC be at P1 (0,4,0) and Q2 = 20nC be at P2(0,0,4). Find E at the origin.…

Q: 2) Aşagıdaki voltajlar ve empedans per-unit cinsinden verilmistir. a) Buna gore Ybus'i bulunuz? ell…

Q: What are the characteristics of an ideal operational amplifier?

A: An operational amplifier is a versatile amplifier. In the following section, the characteristics of…

Q: A 'T' type thermocouple has linear calibration between 0 °C and 80°C with voltage at maximum…

Concept explainers

Synchronous Motor

The synchronous motor is an AC electric type motor where at a steady-state the shaft rotation is synchronized with the supply current variable-frequency. To an integral number of AC cycles, the rotation period is exactly equal. The stator of the motor in the synchronous motor contains multi-phase AC electromagnets due to which a magnetic field is created that rotates in time with the oscillation of the line current. The rotor contains a permanent magnet and the rotor rotates in synchronization with the stator field at the same rate and provides the second synchronized magnetic field which is rotating in nature as a result. When the synchronous motor is supplied with independently excited multi-phase AC electromagnets on both the rotor and the stator, it is termed as a doubly-fed machine. The most widely used AC-type motors are the synchronous AC motor and the induction AC motors.

Question

The synchronous machine voltage is 1.1 p.u.

The steady state stability limit of a synchronous machine connected to
infinite bus is 2.2 p.u. infinite bus voltage is 1 p.u. The transfer
reactance between generator and infinite bus is?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Which of the following is true in the phasor diagrams drawn according to the ohmic, inductive and capacitive operating states of the round pole synchronous generator a) Due to the voltage Efd, the excitation current is large in capacitive operation and small in ohmic operation b) Due to the voltage Efd, the excitation current is large in ohmic operation and small in inductive operation c) Due to the voltage Efd, the excitation current is small in capacitive operation and large in inductive operation. d) Due to the voltage Efd, the excitation current is large in capacitive operation and small in inductive operation.
Two shunt generators A and B operate in parallel and their load characteristics maybe taken as straight lines. The voltage falls from 240V at no load to 200V at200A, while that of B falls from 245V at no load to 220V at 150A. Determine the bus bar voltage when supplying 66.9KW load. How is the load divided between two generators?
Suppose that the P-Q load is known at each of the nine buses of a small power system and that synchronous generators are connected to buses 1, 2, 5 & 7. For a power-flow study, identify the number of equations to be solved: Select one: O a. 15 b. 13 c. 11 d. None of these Oe. 9
Under short circuit, the reactance's of the synchronous generator during the steady state condition are following, Leakage reactance(X)= 0.15 ohm and Armature reactance (Xad) = 0.68 ohm The direct axis synchronous (steady state) reactance (Xa) is
Static load flow equation aretype of equations.O QuadraticO Non LinearO RationalO Linear
Two Generators rated 200 MW and 400 MW are operating in parallel. The droop characteristics of their governor are 4 % and 5% respectively fro no load to full load. The speed changers are so set the governor operate at 50 Hz sharing the full load of 600 MW, in the ratio of their ratings. If the load reduces to 400 MW, how will it be shared among the generators and what will the system frequency be? Assume free governor system. The speed changers of the governors are reset so that the load of 400 MW is shared among the generators at 50 Hz in the ratio of their ratings. What are the no-load frequencies of the generators ?
Problem 2 Two shunt generators A and B operate in parallel and their load characteristics maybe taken as straight lines. The voltage falls from 240V at no load to 200V at200A, while that of B falls from 245V at no load to 220V at 150A. Determine the bus bar voltage when supplying 66.9KW load. How is the load divided between two generators?
Under short circuit, the reactance’s of the synchronous generator during the steady state condition are following, Leakage reactance(Xl)= 0.11 ohm and Armature reactance (Xad)= 0.7 ohm The direct axis synchronous (steady state) reactance (Xd) is
Sheet no.5 Q1)two dc shunt generators operating in parallel supply a total load current of (200 A ). The terminal voltage of one generator falls uniformly from ( 240 V) to ( 225 V) when delivering (120A) The terminal voltage of the second generator falls uniformly from (230V) to (215 V ) when delivering (100 A). find the load current shared by each generator and the bus-bars voltage ? U chunt generators running in parallel supply a total load
-The sum of the armature reactance and.............reactance is the reactance of the synchronous generator after the short circuit fault is cleared. -The selection of number of generating sources to meet the expected load is called as economic dispatch. Select one: True False
State True or false a- The DC load flow study is a linear analysis b- In a load frequency control, a generator unit equipped with a governor can be assumed to be a controlled unit.
5- when load current Il in creases of DC Shunt generator. a-armature curkent la de creases because of load demand. does not change when load current I-Lincreases. in creases to supply the load demandde