The following buffered solutions were prepared. To 50.00 ml of the following buffered solutions, 4.00 ml of 0.10 M HCl were added. The pH changed as indicated. pH after addition of capacity 4.00 ml Buffer Identity Identity Initial Acid buffer concentration of acid (М) of the pH base 0.10 M HCl 0.200 НОАС OAc- 5.00 4.93 0.100 НОАС OAc- 5.00 4.85 0.010 НОАС OAc- 5.00 4.71

The following buffered solutions were prepared. To 50.00 ml of the following buffered solutions, 4.00 ml of 0.10 M HCl were added. The pH changed as indicated. pH after addition of capacity 4.00 ml Buffer Identity Identity Initial Acid buffer concentration of acid (М) of the pH base 0.10 M HCl 0.200 НОАС OAc- 5.00 4.93 0.100 НОАС OAc- 5.00 4.85 0.010 НОАС OAc- 5.00 4.71

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter15: Acid-base Equilibria

Section: Chapter Questions

Problem 132IP: A 10.00-g sample of the ionic compound NaA, where A is the anion of a weak acid, was dissolved in...

See similar textbooks

Similar questions

A 10.00-g sample of the ionic compound NaA, where A is the anion of a weak acid, was dissolved in enough water to make 100.0 mL of solution and was then titrated with 0.100 M HCl. After 500.0 mL HCl was added, the pH was 5.00. The experimenter found that 1.00 L of 0.100 M HCl was required to reach the stoichiometric point of the titration. a. What is the molar mass of NaA? b. Calculate the pH of the solution at the stoichiometric point of the titration.
You have a solution of the weak acid HA and add some of the salt NaA to it. What are the major species in the solution? What do you need to know to calculate the pH of the solution, and how would you use this information? How does the pH of the solution of just the HA compare with that of the final mixture? Explain.
Calculate the pH of a buffer solution prepared from 0.155 mol of phosphoric acid, 0.250 mole of KH2PO4, and enough water to make 0.500 L of solution.
Amino acids are an important group of compounds. At low pH, both the carboxylic acid group (CO2H) and the amine group (NHR) are protonated. However, as the pH of the solution increases (say, by adding base), the carboxylic acid proton is removed, usually at a pH between 2 and 3. In a middle range of pHs, therefore, the amine group is protonated, but the carboxylic acid group has lost the proton. (This is called a zwitterion.) At more basic pH values, the amine proton is dissociated. What is the pH of a 0.20 M solution of alanine hydrochloride, [NH3CHCH3CO2H]Cl?
Sketch the titration curve for a weak acid titrated by a strong base. When performing calculations concerning weak acidstrong base titrations, the general two-slep procedure is to solve a stoichiometry problem first, then to solve an equilibrium problem to determine the pH. What reaction takes place in the stoichiometry part of the problem? What is assumed about this reaction? At the various points in your titration curve, list the major species present after the strong base (NaOH, for example) reacts to completion with the weak acid, HA. What equilibrium problem would you solve at the various points in your titration curve to calculate the pH? Why is pH 7.0 at the equivalence point of a weak acid-strong base titration? Does the pH at the halfway point to equivalence have to be less than 7.0? What does the pH at the halfway point equal? Compare and contrast the titration curves for a strong acidstrong base titration and a weak acidstrong base titration.
A solution consisting of 25.00 g NH4Cl in 178 mL of water is titrated with 0.114 M KOH. (a) How many milliliters of KOH are required to reach the equivalence point? (b) Calculate [Cl-], [K+], [NH3], and [OH-] at the equivalence point. (Assume that volumes are additive.) (c) What is the pH at the equivalence point?