Suppose three volumes and three times, where the volume is in units cm3 and the time is in units of seconds for each type of flow, so that the results in the table are 1-Laminar Flow 2-Transitional Flow 3- Turbulent Flow data Tube Area=7.854x 10-5 Air Temperature= 34 c water temperature=28 c the tube's diameter=D10cm Kinematic Viscosity water =8.836 x 107 cm² /s Q= V/t v = Q/A Туре of flow | Туре of flo V t Runs Ra = pvD/µ (cm³) (sec) (cm3/sec) (cm/sec) visually from R

Suppose three volumes and three times, where the volume is in units cm3 and the time is in units of seconds for each type of flow, so that the results in the table are 1-Laminar Flow 2-Transitional Flow 3- Turbulent Flow data Tube Area=7.854x 10-5 Air Temperature= 34 c water temperature=28 c the tube's diameter=D10cm Kinematic Viscosity water =8.836 x 107 cm² /s Q= V/t v = Q/A Туре of flow | Туре of flo V t Runs Ra = pvD/µ (cm³) (sec) (cm3/sec) (cm/sec) visually from R

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The Reynolds number is a dimensionless group defined for a fluid flowing in a pipe as Re = Duplu where Dis pipe diameter, u is fluid velocity, p is fluid density, and u is fluid viscosity. When the value of the Reynolds number is less than about 2100, the flow is laminarthat is, the fluid flows in smooth streamlines. For Reynolds numbers above 2100, the flow is turbulent, characterized by a great deal of agitation. Liquid methyl ethylketone (MEK) flows through a pipe with an inner diameter of 2.067 inches at an average velocity of 0.48 ft/s. At the fluid temperature of 20°C the density of liquid MEK is 0.805 g/cm? and the viscosity is 0.43 centipoise [1 cP = 1.00 x 10-³ kg/(m-s)]. Without using a calculator, determine whether the flow is laminar or turbulent. Show your calculations.
valg, (21535mm 1.15 The pressure difference, Ap, across a partial blockage in an artery (called a stenosis) is approximated by the equation μV Ap - K. 4 + K.(A-1) pv² = K₂ A s.r to zogy nish190 32\V as bonb dignol a 3 basiy noft where V is the blood velocity, u the blood viscosity (FL-2T), p the blood density (ML), D the artery diameter, Ao the area of the unobstructed artery, and A, the area of the stenosis. Determine the dimensions of the constants K, and K. Would this equation be valid in any system of units?
Take the density and dynamics viscosity of the water as follows, determine the value of friction factor (f), head loss (h1), pressure drop (dP) and power required to overcome the pressure drop (W) for the cases as shown in the table that follows. Take p= 1000 kg/m³ while u = 1.138 x 103kg/ms. Q2 Cases Pipe Material Water Velocity Pipe Diameter Pipe Length (m/s) (mm) (m) 1 Wrought iron 3.00 35 1000 2 Commercial steel 2.50 10 500
Problems H.pdf > Problems H.W: Lecture No.6 Part 2 Q1-(2.4-4, Holland): A fluid of density (p) and dynamic viscosity (u) flows in s.s in a cylindrical pipe of inside diameter (d) with mean linear velocity (u). Derive an expression for the pressure gradient AP/L in terms of p, u, d & u. By dimensional analysis (Note Lect. No.3). Q2-An oil with a viscosity of u= 0.40 N-s/m and density p= 900 kg/m flows in a pipe of diameter d= 0.20m. (a) What pressure drop, pl-p2, is needed to produce a flowrate of Q=2.0x10-5 m/s if the pipe is horizontal with xl=0 and x2=10 m? (b) How steep a hill, part (a), but with pl=p2? (c) For the conditions of part (b), if pl=200 kPa, what is the pressure at section, x3=5 m, where x is measured along the pipe? „must the pipe be on if the oil is to flow through the pipe at the same rate as in II
A dimensionless expression that is significant quantities in the area of viscous flow through channels is called Reynolds number, Re, defined as pDV/u where is p the fluid density, V the mean fluid velocity, D the pipe diameter, and u the fluid viscosity. A Newtonian fluid having a viscosity of 0.38 N-s/m2 and a specific gravity of 0.91 flows through a 25-mm-diameter pipe with a velocity of 2.6 m/s. Determine the value of the Reynolds number in SI Units.
Mott ." cometer, which we can analyze later in Chap. 7. A small ball of diameter D and density p, falls through a tube of test liquid (p. µ). The fall velocity V is calculated by the time to fall a measured distance. The formula for calculating the viscosity of the fluid is discusses a simple falling-ball vis- (Po – p)gD² 18 V This result is limited by the requirement that the Reynolds number (pVD/u) be less than 1.0. Suppose a steel ball (SG = 7.87) of diameter 2.2 mm falls in SAE 25W oil (SG = 0.88) at 20°C. The measured fall velocity is 8.4 cm/s. (a) What is the viscosity of the oil, in kg/m-s? (b) Is the Reynolds num- ber small enough for a valid estimate?
A- Womersley number (a) of a human aorta is 20 and for the rabbit aorta is 17, the blood density is approximately the same across the species. The values of viscosity were 0.0035 Ns/m² for the human and 0.0040 Ns/m² for the rabbit. The diameter of the aorta is 2.0 cm for the man, and 0.7 cm for the rabbit, estimate the heart rate beats per minute (bpm) for both species
The Stokes-Oseen formula for drag force on a sphere at low speed is given asD = 3dV +916V 2d2, where D is drag, V is velocity, is density, d is the sphere diameter, and is the viscosity coe¢ cient.(a) Using the formula given, Önd the dimensions of the viscosity coe¢ cient. (Donít simply look upthe dimensions; use the formula to show them.) Be sure to show your work. Find the primaryunits of viscosity in SI and British units.(b) Verify that the Stokes-Oseen formula is dimensionally homogeneous.
The Reynolds transport theorem (RTT) is discussed in Chap. 4 of your textbook. For the general case of a moving and/or deforming control volume, we write the RTT as follows: d pb dV + pbV-ñ dA dt dt dB sys where Vr is the relative velocity, i.e., the velocity of the fluid relative to the control surface. Write the primary dimensions of each additive term in the equation and verify that the equation is dimensionally homogeneous. Show all your work. (Hint: Since B can be any property of the flow-scalar, vector, or even tensor—it can have a variety of dimensions. So, just let the dimensions of B be those of B itself, {B}. Also, b is defined as B per unit mass.)
There are many common dimensionless numbers used to describedifferent physical effects. Such dimensionless numbers are usually a ratioof specific properties, for example, the Reynolds number represents theratio of inertial to viscous forces.Choose three of the following dimensionless numbers and describe whatproperties the ratio represents and the context in which these numbers areimportant: Froude Number, Euler Number, Mach Number, Weber Number,Nusselt Number, Prandtl Number.
The laminar flow of a fluid with a constant viscosity, 4, inside a channel is governed by the following boundary value problem (strong form): d'u dp for y E (0, h) "dy dr u = 0 at y = 0 and y = h vhere u is the fluid velocity and is the pressure drop in the direction of the flow. a) Derive the weak form of the boundary value problem described above.
ME360L Fluid Mechanics Lab Lab #2: Analysis of Bernoulli's Equation for Fluid Flow through Venturi SERIES This accessory illustrates the circumstances to which Bernoulli's Theorem may be applied. It also explains why in other circumstances the theorem gives an inadequate description of the fluid behaviour. F1-15: Manometer bank (e rereR APPARATU EGL H&L Woter td, > dz dz da dg df 31 Bernoulli's Equation, P/y + V/2g+z=C