Suppose an analog meter is used to test a diode. What should the meter read for both connections of the meter leads if the diode is, a good? b. shorted? c. open? Which diode rating if exceeded, causes the avalanche effect?

Q: A matched CMOS inverter has VDD = 2 V, Vtn = 0.5 V, (W/L)n = 1.5 and K'n = 2K'p = 0.4 mA/V2. Find…

A:

Q: A single phase heater absorbs 4 kW on a 240 V line. A capacitor connected in parallel with the…

A:

Q: Q48/ A 3-phase, 6-pole, 50 Hz induction motor develops 3.68 KW at 950 r.p.m. if the stator losses…

A:

Q: draw truth table and waveform, make sure its correct please

A: The state table can be analysed by verifying state of each flipflop after each clock.

Q: Explain through equations what happen if there is a phase error θc between the transmitted ASK…

A: Given that,There is a phase error between the transmitted ASK signal and carrier signal.The phase…

Q: ith a subtransient reactance of 0.1 pu, are connected through a line of reactance 0.1 py on the base…

A: It is given that: Rating= 60 MVA, 15 kVXs''=0.1 p.u.XL=0.1 p.u.p.f.=cosϕ=0.8P=45 MWTerminal…

Q: A control system is represented by the block diagram in Figure A below. The reference input,…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Q4: Compare between Pulse modulation methods?

A: There are 3 types of pulse modulation methods. They are 1) Pulse amplitude modulation ( PAM)  2)…

Q: A 450 kHz carrier signal is modulated with a 15 kHz modulating signal. What are its sideband…

A:

Q: Find the ß Rnction, frequency of B function, frequency escillation and R¢ E the circuit shown below?…

A:

Q: solve for the following: a. Is b. c. tz Rs- 120 !1 Vz=12 V Pa = 1 W Vn - 18 V R_= 400 N

A:

Q: calculate the total resistance. * RI 200 N R2 200 N R3 200 N R4 200 2 RT

A: The solution is given below The four resistance are in parallel.

Q: An SSB transmitter radiates 100 W in a 75 ohms load. The carrier signal is modulated by two tones,…

A: Given information: The SSB transmitter radiates 100 W of power in a load of resistance 75 ohms.  The…

Q: For the following system: s + 2 G(s) 0.5s6 + 3.5s5 + 13.5s4 + 25.3s3 + 26s? + 13.8s1 + 3 1- Is the…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Using Carson's rule. What is the bandwidth (kHz) of an FM signal with 5 kHz maximum frequency…

A: The bandwidth of FM can be calculated by using Carson's general expression for the bandwidth of FM.

Q: Find the inverse z-transform of the function below: z3 + 2z + 1 G(z) (z – 0.1)(z² + z + 0.5)

A: Inverse Z-transform: Inverse Z-transform is a technique that the frequency domain signal into the…

Q: 3.) The heat flow vector H = kVT, where T is the temperature and k is the thermal conductivity.…

A: The solution is given below

Q: .Evaluate the following complex number and write the imaginary part of the resulting number 3260°…

A:

Q: Ql.- The input-output pair {ro[n]. Yo[n]} is produced by a causal and stable LTI system. (-1, n=-l…

A:

Q: Q2: For the following digital sequences sketch the line codes e.g. polar, unipolar, bipolar and…

A: I have provided you the exact and correct solution. Please go through it.

Q: [Q2] Electromagnetic radiation from the sun reach to the earth with intensity of 1500 w/m. If we are…

A:

Q: Fill in the blank : Calculate the value of Rp that will provide an I Don) of 10 mA for V Dp = 15V: +…

A: In this question,  We need to choose the correct options What is drain resistance RD   We know R=…

Q: the gain in dB for the 3rd amplifier?

A: Amplifier An electronic device or we can say circuit arrangement in which for small amplitude signal…

Q: Solve for the following: a. Equivalent capacitance of the combination  b. Charge on each capacitor…

A: Basic capacitor problem

Q: In a boost converter, when the MOSFET is off, the inductor is: O discharging charginng idle…

A: In a boost converter, when the mosfet is off, the inductor is, Select correct answer

Q: Q3: a digital signal has an amplitude of 4V (peak-to- peak) and with T time duration find the filter…

A:

Q: 6 V 10 V 3Ω 4Ω is 10 1Ω 5Ω 6Ω i, i2 8Ω iz 12 V 9 V in

A:

Q: 1. What is the current in a 160V circuit if the resistance is 20? V= |= R

A: Given, V = 160 volt, R = 2 ohm, To calculate the current in the circuit

Q: Using Thevenin's theorem, find the equivalent circuit to the left of the terminals in the circuit.…

A:

Q: EX A.1 Sketch the transfer characteristics defined by Ipss = 10 mA and Vp =-8 V.

A: Given, IDSS = 10 mA VP = -8 V

Q: 2. The power input to a 3-phase, 50-Hz induction motor is 60 kW. The total stator loss is 1000 W.…

A:

Q: 2 Load-Line Analysis 1. a. Using the characteristies of Fig. 152b, determine /p. Vo, and Vg for the…

A:

Q: 1. Given the circuit in Fig. 3.8, find the average power supplied or absorbed by each element. -j42…

A:

Q: receiver connected to an antenna whose resistance is 50Ω has an equivalent noise resistance of 30Ω.…

A: We need to find noise figure .

Q: In the following circuit, the supply voltage is defined as V(t) = 325 sin (314t – 30o) and L = 2.2H.…

A: Given: V(t) = 325 sin (314t – 30°)L = 2.2H

Q: A planar electromagnetic wave is propagating in the +x direction. At a certain point P and at a…

A: Brief description : Here they have mentioned a planar electromagnetic wave which is propagating in…

Q: 6. For a series dc generator with Rs =12, R, = 3 2, and V, = 60 V that delivers 240 W to the load,…

A: In this question we will find armature current ,series field current and will find induced emf for…

Q: sine

A:

Q: Reduce the following block diagrams اختصر المخط ط الكتلي التالي R +. 不十 63 Fant G4

A:

Q: -2 - 1

A:

Q: This is the optical transmission function of a material. 90 80 S 70 60 50 40 30 20 10 0.1 0.2 0.3…

A: The Transmission percentage is an property of  optical materials which helps us to judge the…

Q: *31. Sketch v, for the network of Fig. 175 and determine the de voltage available. Ideal 170 V 2.2…

A: The solution is given below

Q: to bring the process temperature back to the desired value. Once this calculation is complete the…

A: i. To Draw the block diagram that represents the temperature controller mentioned above and label…

Q: 1.7 Figure 1.18 shows a feedback connection of a linear time-invariant system rep- resented by the…

A: A=[0,1;-3,-4]; B=[0;1]; C=[2,0]; D=[0]; sys=ss(A,B,C,D) [num1,den1]=ss2tf(A,B,C,D);…

Q: Q4: Compare between Pulse modulation methods?

A: There are 3 types of pulse modulation methods.  1) Pulse amplitude modulation ( PAM)  2) Pulse width…

Q: A transistor amplifier has a measured S/N power of 25 at its input and 8 at its output. Its noise…

A: Please refer the attached images for the complete answer..

Q: 6. I= . E = 200 V R, = 150 0 R2 = 300 2 %3D

A:

Q: What is the recommended maximum kVA rating of a single motor-driven piece of equipment on a 100-…

A:

Q: if (+jS x+jy, the find the value of xtjy. 2-)

A:

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.