Subnet1 192.168.1.0 192.168.7.10 LINK2 Router1 192.168.1.1 192.168.7.20 Figure 4 Two router intranet 192.168.2.1 Router2 Subnet2 192.168.2.0

Q: 2. Given a network address of 118.0.0.0, 126 needed subnets and 131,070 needed usable host per…

A: Given: Given a network address of 118.0.0.0. , 126 needed subnets and 131070 needed usable host per…

Q: This is Networking subject, Fixed length subnet mask (FLSM) Subnetting in IPv4 Network design…

A: Suppose an IPv4 network 172.30.0.0/16.Subnet Mask : 255.255.0.0 because /16 is given IP Address =…

Q: Question: 2) Learn the following graph and answer the following questions PCA Switch Z Switch Y A.…

A: A. PC1 IP address: 192.168.1.1/24 PC2 IP address: 192.168.1.2/24 PC3 IP address: 192.168.1.3/24 If…

Q: Question: Now that you have gained some expertise in creating addressing schemes, demonstrate how…

A: The answer as given below:

Q: Assume that Computer A, which is connected through an Ethernet cable to the Switch S1, is just…

A: All the protocols which came into play with reference to TCP model layers are given below. We used…

Q: a. How many host addresses are needed in the largest required subnet? b. What is the minimum number…

A: Note:-As per policy, I can be entitled to answer only the first three questions. Wired network:…

Q: 192.168.30.10o 192.168.70.1 192.168.2.2 192.168.0.2 Question 1: The subnet mask in the following…

A: In the given network 4 routers, 6 switches and each switch is connected to 1 or 2 hots. Based on the…

Q: Question 2: Answer the questions regarding the given topology. Router A and Router B have 50 PCs and…

A: Actually, given IP address  192.168.10.0/25.

Q: 3.5-4 TCP sequence numbers and ACKS (2). Suppose that as shown in the figure below, a TCP sender is…

A: In TCP, the sequence number indicates the starting address of the data packet and the…

Q: A data link layer switch SW1 is connected with four hosts (H1, H2, H3, H4) as shown in figure below:…

A: NOTE: - Since it is a multi-part question, so as per the guidelines only first three parts are…

Q: Refer to the above topology, 6 subnets are required (i.e, three LANs and three WAN links) and the…

A: Subnet: The subdivision is a segment of a Network layer (internet protocol suite), which is a…

Q: Homework: Draw a network with the following specifications: (a) Two ring networks with four hosts…

A:

Q: Use given Figure 1 to configure two-router network. All router a configurations must be assumed and…

A: Actually, IP stands for Internet Protocol.

Q: Problem 4: Given: Host IP Address: 192.168.1.245 New Subnet Mask: 255.255.255.252 Find: Number of…

A:

Q: tate two advantages of dividing a communication system into layers such as e.g. is done in the TCP /…

A: advantages of dividing a communication system into layers: Extensibility: At each layer, you can…

Q: 4. Consider the following two causes of 1-second network delay (assume ACKS return instantaneously):…

A: a.  If we send 1 packet, then in either case we see a 1 sec RTT. If we send a burst of 10 packets,…

Q: This is Networking subject, Fixed length subnet mask (FLSM) Subnetting in IPv4 Network design…

A: Note: As you have posted question with multiple parts, we will solve the first three parts.   The…

Q: (a) Assume that rdt 2.0 is being used and the receiver correctly gets a packet of data from the…

A: a. RDT 2.0 is Reliable Data Transfer protocol work on a reliable data channel. After packet arrival…

Q: Question 2: There are 12 hosts as shown in the following table. You have several (almost unlimited)…

A: A host is a type of network which is used to communicate with the other network devices. A…

Q: Use VLSM to subnet the 128.153.0.0/22 network based on the following requirements shown on the…

A: VLSM happens when an internetwork involves more than one veil for various subnets of a solitary…

Q: Consider the following non-default subnet masks: (a) 255.255.248.0, (b) 255.128.0.0 . To which IP…

A: As per our guidelines only 3 sub parts will be answered. So please repost the remaining questions…

Q: Design a classfull network addressing scheme that will supply the minimum number of hosts per…

A: From the Given problem description we see that the ip address : 172.16.0.0 Below are the steps we…

Q: 3. Consider the following network address: 212.15.6.0/29 a. How many subnets are there in this…

A: Below is the answer to above question. I hope this will be helpful for you...

Q: In this question we consider a router that has to fragment an IP datagram to make it fit into a link…

A: Here, we are going to find out the offset value of second datagram after fragmentation. MTU is…

Q: network

A: Router is a small network device that connect many devices together. We can  say its connects one…

Q: to configure a two-router network. All router Use given Figure 1 configurations must be assumed and…

A: EXPLANATION Below is the program for the given question. Hope you understand it well. If you have…

Q: A) Explore specific packet number let's suppose number 4 and give its source IP and MAC addresses…

A: MAC address is a unique identifier that is assigned to a NIC (Network Interface Controller/ Card).…

Q: Consider the figure below. The IP and MAC addresses are shown for nodes A, B, C and D, as well as…

A: Code:

Q: 1.1 Figure 1 shows part of a network in which two personal computers A and B, are each connected to…

A: Given that, Computer A is connected to switch 1 and computer B is connected switch 2 and both…

Q: A network for a local office requires 4 LAN subnets as follows:      · Subnet A - North Office with…

A:

Q: IV-Refer to the below exhibit. a- Using 172.16.0.0/16 network address, can we allocate IP's using…

A:

Q: 1. Describe the steps involve in a distributed function using a simple carrier sense multiple access…

A: 1.Distributed coordination function (DCF) is a mandatory method used to prevent collisions in IEEE…

Q: How to forward to a border router? Consider the network shown below. Suppose AS1, AS2, AS3, and AS4…

A: According to the information given:- we have to find out the border router in the given network.

Q: Consider the following topology. i. Write commands to configure switch S2, S3 with proper…

A: Device(Hostname)     Interface        IP Address                  Subnet Mask…

Q: A network for a local office requires 4 LAN subnets as follows:      · Subnet A - North Office with…

A: The given address is 192.168.15.0 /24 The subnet mask is /24 which means total number of network…

Q: Consider a subnet 120.128.128.0/17. Suppose an ISP owns the block of addresses of this subnet and…

A: Given that, A subnet 120.128.128.0/17 Suppose an ISP owns the block of addresses of this subnet and…

Q: Use VLSM to subnet the 128.153.0.0/22 network based on the following requirements shown on the…

A: as basic network that we are provided is 128.153.0.0/22   so we have 1024 valid ip addresses…

Q: 1. Define an extended-network-prefix. 2. What is the maximum number of subnets that can be defined?…

A: IP Address: 129.166.15.1 Network Address: 129.166.8.0 Usable Host IP Range: 129.166.8.1 -…

Q: 3) Consider the following network topology. a) How many call legs is needed to provide a two-way…

A: a)  Cell legs :                when you dial number, your phone starts connection with switch and…

Q: 52- A network for a local office requires 4 LAN subnets as follows: · Subnet A - North…

A: You can subnet the given network in two optimal ways. Let's stick to one of the optimal ways.…

Q: In this question we consider a router that has to fragment an IP datagram to make it fit into a link…

A: Here, we are given a datagram of size 4000  bytes and MTU of Size 1500bytes. We are asked the offset…

Q: Q5) 1- Write the routing table for router R1 for the networks N2, N3, and Host B. 2- Define: RIP…

A: Routing table: A routing table is a set of rules, often viewed in table format, that is used to…

Q: How to forward to a border router? Consider the network shown below. Suppose AS1, AS2, AS3, and AS4…

A: In this question we have to answer as the correct statement for forwarding to border router will…

Q: 4.03-1. Network Address Translation (a). Consider the following scenario in which host 10.0.0.1 is…

A: At point A the computer host with the IP 10.0.0.1 wants to communicate with web server…

Q: An ISP Is granted a block of addresses starting with 150.80.0.0/16. The ISP wants to distribute…

A: Q .  150.80.0.0/16 means number of network bits is 16 and number of host bits is 16 Now we have 200…

Q: Consider the following virtual circuit network with three reserved virtual circuits: VC1: H1, A, C,…

A: Virtual circuits is a connection oriented routing protocol. There is a fixed path for data…

Q: Q1: Simple, compare between each of the following? TCP and UDP protocols Network and transport…

A: The basis comparison of the above questions is as follows:

Q: Part 1 A new school network is being installed. There are Three classrooms with 61 computers each.…

A: Subnet 1 : Network Address :  63.92.141.128 Subnet Mask :  /26 First Usable Host Address :…

Q: Suppose Host1 (Shahid) sends a datagram to Host2 (Khalid). What IP and MAC addresses (source and…

A: Here are the IP and MAC addresses(Source and Destination) in IP and Datalink Layer headers…

Q: A network for a local office requires 4 LAN subnets as follows:      · Subnet A - North Office with…

A:

Types Of Protocols

A network protocol is a collection of rules that governs the exchange of data between devices connected to the same network. In other words, network protocols are rules that specify how devices communicate or transfer data over a network. The sender and receiver systems must obey the standards to facilitate communication between them.