Steam is supplied to a two-stage turbine at 48 bar and 400 °C. It expands in the first turbine until it is just dry saturated, then it is re-heated to 400 °C and expanded through the second-stage turbine. The condenser pressure is 0.04 bar. High-P turbine Low-P turbine Reheater O Boiler -o P = P3 = Pecheat Condenser find thespecific heat inputof the systemin kJ/kg to 2.d.p. ?

Steam is supplied to a two-stage turbine at 48 bar and 400 °C. It expands in the first turbine until it is just dry saturated, then it is re-heated to 400 °C and expanded through the second-stage turbine. The condenser pressure is 0.04 bar. High-P turbine Low-P turbine Reheater O Boiler -o P = P3 = Pecheat Condenser find thespecific heat inputof the systemin kJ/kg to 2.d.p. ?

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter45: Domestic Refrigerators And Freezers

Section: Chapter Questions

Problem 20RQ: Welded ______sealed compressors are normally used in household refrigerators.

See similar textbooks

Similar questions

Welded ______sealed compressors are normally used in household refrigerators.
Steam is supplied to a two-stage turbine at 48 bar and 400 °C. It expands in the firstturbine until it is just dry saturated, then it is re-heated to 400 °C and expandedthroughthe second-stage turbine. The condenser pressure is 0.04 bar. Determine the specific work output of the system to 3 d.p? what is the specific entalphy in kJ/kg for state 2?
Superheated steam at 18 MPa, 560 °C enters the steam turbine. The pressure at the exit of the turbine is 0.06 MPa and saturated liquid water leaves the condenser at 0.06 MPa. Pressure is increased to 18 MPa again after the pump. Find: (a) Sketch the process on a T-s diagram. (b) The net work per unit of steam flow in kJ/kg. (c) Heat transfer to steam passing through the boiler, in kJ/kg.
Saturated steam at 40∘C is to be cooled to saturated liquid in a condenser. The mass flow rate of the steam is 17.3 kg/s . Assume no pressure loss. a)Determine the rate of heat transfer. Q = ? MW
3.) An ammonia compressor operates at evaporator pressure of 316.02 kPa and a condenser pressure of 1557 kPa. A twin-cylinder compressor with bore to stroke ratio of 0.85 is to used at 1200 rpm. The actual volumetric efficiency is 92% and compression and mechanical efficiency is 78% and 80% respectively. For a cooling capacity of 25 TR, (a) the sketch the p-h diagram labeling the evaporating and condensing temperature and pressures (b) define the all properties of ammonia taken from saturation table. Determine (c) the quantity of cooling water in the condenser in kg/min if the increase in temperature is 8°C, (d) the bore and stroke expressed in cm and (e) the size of the driving motor in hp. Given: h2 = h at 1557 kPa and s2 = s1 1695 kJ/kg
A plant using R134a refrigerant has a cooling capacity of 352 kW of refrigeration. It evaporates at 0 Cand condenses at 35 C, with the 5 of superheat at the evaporator outlet and 5 K of sub-cooling at the condenser outlet. Assuming isentropic compression and ignoring pressure drops in the piping, the evaporator and condenser, determi the following; a) The refrigeration effect b) The mass flow rate of refrigerant ) The compressor power d) The rate of heatrejection at the condenser e) The COP 0 The corresponding Carnot COP g) The percentage Carnot-efficiency
Q4//A// Prove for the condenser: + %3D Cpw (Twz-Tw1) when the temperature of cooling water outlet and inlet is equal to saturation temperature of steam and the condensate leaving the condenser respectively; also, the inlet of condenser is dry steam with unity latent heat. m, Twi
TNB steam power plant in Genting Highlandsoperates on reheat Rankine cycleand has power net output of 50MW. Steam enters the turbine at aMPa and b °Cand it is cooled in the condenser at a pressure of ckPa by running cooling water from the Bertam River through the tubesof condenser. Steam enters both stages of the turbine at b°C. If the moisture content of the steam at the exit of the low-pressure turbine is not to exceed 10 percent, show the cycle on a T-s diagram and determine;i.The pressure at which reheating takes place, ii.The thermal efficiency of the cycleandiii.Please justify how does the thermal efficiency of the cycle if the temperature to low turbine is increase to 600°C? a=12 b=500 c=12
A refrigeration system operated on an ideal vapor-compression using R-12 with a vaporizing temperature of -10 degrees Celsius and a condensing temperature of 30 degrees Celsius, it requires 15 hp to drive the motor of the compressor. Find the ff: Enthalpies at each point of the cycle in kJ/kg Refrigerating Capacity in TOR • Mass of the Refrigerant in kg/s Percent Quality in the mixture Heat Rejected in kW Coefficient of Performance • Schematic and P-h Diagram
A refrigeration system is to be used to cool 45,000kg water for 32 Celsius to 19 Celsius in 5 hours. The refrigerant is R-134A and the operating condition are evaporating pressure 810 kPa and 1800 kPa liquefication pressure. Determine COP, quantity of cooling water in the condenser for an increase in temperature of 7 Celsius compressor power, volume of flow rate entering the compressor. With schematic diagram. Using this table https://www.docdroid.net/VkxK8WH/refrigerant-134a-pdf
Question 2 of 4 - / 25 An office building requires a heat transfer rate of 30 kW to maintain theinsidetemperature at 21°Cwhen theoutsidetemperature is O°C. Avapor-compression heat pump with Refrigerant 134a astheworkingfluid isto beused to provide the necessary heating. The compressoroperates adiabatically with an isentropic efficiency of 82%. Determine appropriate evaporator and condenser pressures of a cyclefor this purpose assuming ATcond = ATevap = 10°C, as shown in the T-sdiagram. The refrigerantexitstheevaporator assaturated vapor and exitsthecondenser as saturated liquid at the respective pressures. AT cond Outside air 21°C 0°C Inside air ATent Condenser Evaporator Expansion valve Compressor Step 1 Determinethe mass flow rate of refrigerant, in kg/s. m = kg/s Attempts: unlimited Submit Answer Save for Later Using multiple attempts will impact your score. 5% score reduction after attempt 2 Step 2 The partsof thisquestion must becompleted in order. This partwill be availablewhen…
A vapor compression refrigeration systemhas an enthalpy of saturated liquid at the hightemperature side is 341.769 kJ/kg while at lowtemperature side is 131.27 kJ/kg and a latentheat of vaporization of 1312.63 kJ/kg. If themass flow rate of refrigerant is 0.50 kg/s.compute the tons of refrigeration.