Show Attempt History Current Attempt in Progress A submarine is modeled as a cylinder with a length of 380 ft, a diameter of 50 ft, and a conning tower, as shown in the figure below. The submarine can dive a distance of 50 ft from the floating position in about 30 s. Diving is accomplished by taking water into the ballast tank so the submarine will sink. When the submarine reaches the desired depth, some of the water in the ballast tank is discharged leaving the submarine in “neutral buoyancy” (i.e., it will neither rise nor sink). 3% of cylinder 7% of cylinder volume volume 25 ft Ballast tank Partially submerged position 3 ft 50 ft Y' water = 64 lb/ft³ Totally submerged position Water For the conditions illustrated, find (a) the weight of the submarine and (b) the volume of the water that must be in the ballast tank when the submarine is in neutral buoyancy. For seawater, S = 1.03. (a) W = x107 lb (b) V= ft³

Show Attempt History Current Attempt in Progress A submarine is modeled as a cylinder with a length of 380 ft, a diameter of 50 ft, and a conning tower, as shown in the figure below. The submarine can dive a distance of 50 ft from the floating position in about 30 s. Diving is accomplished by taking water into the ballast tank so the submarine will sink. When the submarine reaches the desired depth, some of the water in the ballast tank is discharged leaving the submarine in “neutral buoyancy” (i.e., it will neither rise nor sink). 3% of cylinder 7% of cylinder volume volume 25 ft Ballast tank Partially submerged position 3 ft 50 ft Y' water = 64 lb/ft³ Totally submerged position Water For the conditions illustrated, find (a) the weight of the submarine and (b) the volume of the water that must be in the ballast tank when the submarine is in neutral buoyancy. For seawater, S = 1.03. (a) W = x107 lb (b) V= ft³

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

(a) how many pounds of lead weighing 700lb/ft^3 must be fastened to the outside bottom to make the cylinder float vertically with 3ft submerged? (b) how many pounds of lead if placed inside the cylinder? answer in complete , 3 decimals and with diagrams
Determine the dynamic viscosity (Pa-sec) and kinematic viscosity (m2/s) of water with a specific weight of 9.81 kN/m3, if a Falling Sphere Viscosimeter test is conducted using an aluminum sphere that has a diameter of 10 mm and a specific weight of 28.06 kN/m3. The theoretical terminal velocity of the sphere is 0.650 m/s. Round off your answer to 3 decimal places.
An open circular vessel is 1m in diameter and 2m height. It contains water filled to a depth of 1.5m. If the cylinder rotates about its vertical axis, what constant angular velocity can be obtained without spilling? Unit of the Correct Answer: rad/sec Decimal Places required in the final answer: 3 PLS 3 DECIMALS..
You are required to design a barometer that uses water instead of mercury to operate under standard sea-level conditions. Draw a conceptual diagram of your barometer design. Show on your diagram what the pressures will be at all liquid-gas interfaces, and where the barometer reading will be taken.Calculate the minimum height requirement of the barometer tube to measure standard sealevel atmospheric pressure.
A two-liquid double column manometer with enlarged ends is used to measure a high precision pressure difference between two points of a pipeline containing gas under pressure. The basins are partly filled with methyl alcohol of specific gravity 0.78 and the lower portion of the U-tube is filled with mercury of specific gravity 13.6. The specific weight of the gas which is methane is 0.476 kg(f)/m³, find the pressure difference if the U-tube reading is 30 mm and the diameter of the basin is 15 times that of the U-tube.
A 4-N projectile is shot onto a 400-N sand bag as shown. The bag is hanging from rope 2m long. How high will the sand bag swing if the velocity of the projectile is 300 m/s?
Q3: A pitot-static tube is used to measure the flow velocity of turpentine flowing in a pipeline if the manometer reading is 8 cm of mercury, calculate the average velocity, pressure drop, and volumetric flow rate at that point in the pipe line. Also evaluate Reynold number for turpentine and which type of flow in the pipe. Ph J Re Density of turpentine is 850 kg/m³, density of mercury is 13600 kg/m³, cv = 1, D=10 cm, turpentine 0.001375 and 0 = 45°. =
Consider a cylindrical barrel that is 300 lt in volume containing concrete of density 2450 kg/m³ and suspended on a block of foam that weighs 0.2 kN/m³. Calculate the minimum volume of foam that could keep the barrel in fully submerged equilibrium condition and suspended in water (ignore the weight of connecting wire!).
Vernie saw a cockroach chilling on the floor at a horizontal distance of 2.5 meters. Sheprepares to smack the insect with a slipper starting from an angle of 80°. Vernie will let goof the slipper when t = 0 at a vertical height of 1.5 meters. a) What is the final velocity of the slipper before it hits the cockroach if its initialvelocity is 5m/s?b) The highest point of the slipper measured from the floor is:
Figure 1 Pressurized tank Z3 pump Different diameters See figure 3 See figure 2 motor At point 2 Figure 2 V1 Stagnation point At points 4 and 5 Figure 3 D5 D4 y
The tank contains a liquid having a density of 1.22 slug/ ft³ . Determine the weight of the liquid when it is at the level shown. 3 ft
x=71 The minimum pressure on an object moving horizontally in water (Ttemperatu at10 degree centrigrade) at (x + 5) mm/s (where x is the last two digits of your student ID) at a depth of 1 m is 80 kPa (absolute). Calculate the velocity that will initiate cavitation. Assume the atmospheric pressure as 100 kPa (absolute). Scan the solution and upload in VUWS before moving to the next question.