Select the correct equation for calculating the average power in a series RLC Circuit.OP = IRMSƐRMS COS(4)P =IRMSERMS COS2OP = Içɛ0 cos(4)Op = cos()IgeoV2P

For an RLC Circuit we have Voltage at time t as V(t)=V0sin ωt Now as current leads the voltage…

Answered: Select the correct equation for…

Select the correct equation for calculating the average power in a series RLC Circuit. OP = IRMSĒRMMS Cos(4) IRMSERMS 2 cos (6) P OP = Içɛ0 cos($) P = cos () V2

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter33: Inductors And Ac Circuits

Section: Chapter Questions

Problem 25PQ: A 2.0-F capacitor is charged to a potential difference of 12.0 V and then connected across a 0.40-mH...

See similar textbooks

Related questions

Q: ohms +f (Hz) The graph of reactance against frequency, shown in the picture is for a

A: The solution is given below

Q: Calculate the impedance and admittance of the Branch AB and CD of the circuit shown in Figure 6.…

A: When the steady current flows through the circuit, the resistance gives the measure of the…

Q: The graph below represents the voltage and current of a series RLC circuit. a) Find R b) Find the…

Q: For the circuit of , what is the resonance frequency in 10 Ω (10 V)cosot 1.0 mH 1.0 μF

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: The voltage-current phasor diagram shown in the picture is for a + AC circuit. Vo wt

A: According to the figure shown, the voltage leads the current.

Q: 1. Draw circuit diagram of full wave rectifier (Bridge rectifier) and in the circuit, Show direction…

A: circuit diagram of full wave rectifier shows direction of current during negative half cycle of AC…

Q: For what value of the phase angle between the voltage output of an ac source and the current is the…

A: As we know that the formula for average power output, Pav = Vrms x Irms x Cos ϕ -------------(1)

Q: Explain the phasor diagram uses in the AC circuit?

Q: 4. Determine the total impedance of the circuit below. R L www m 5.6 km 10 mH f = 100 kHz 470 pF 2

Q: Fill in the blank with correct answers: A B Frequency Series Resonance -Impedance vs. Frequency. The…

A: Impedance of an ac circuit is given by, Z = ( R2 + ( XL - XC ) 2 ) 1/2 R is resistance XL is…

Q: Give any four characteristics of series RLC circuit at resonance.

A: RLC circuit = It is an electric circuit that consists of Resistance(R), Inductor(L), and…

Q: series circuits all elements to conduct. (1 Point) O Require do not require

A: In series current through all resistance are same. So if any one of the electrical element will not…

Q: For the parallel circuits (a ) and (b ) find a series circuit that will have the same total…

Q: Why are effective values needed to describe an AC circuit?

Q: What happens to the circuit voltage when the frequency is increasing in an RC Circuit? Explain.

A: Circuit voltage increases with increase in frequency,here is the detailed solution below.

Q: What is the RMS voltage from a sinusoidal AC source that has an output V = 150 sin(21ft)? (Enter…

A: Output voltage is given by : V = 150Sin(2πft)

Q: For the following series circuit, solve for a) the total, equivalent resistance, b) the total…

A: Given Resistance of the three resistors are given as R1=7 Ω, R2=25 Ω and R3=15 Ω EMF of the battery…

Q: Fill in the blank with correct answers: $B Frequency Series Resonance- Impedance vs. Frequency. The…

A: The impedance of the series LCR circuit is given by : Z=R2+XL-XC2 Where R is resistance XL and XC…

Q: Fill in the blank with correct answers: D В Frequency Series Resonance- Impedance vs. Freque The…

A: Introduction: Current is inversely prapostional to the impedence When impedance high, current is…

Q: 1. Find the instantaneous current when 0 = 30° and 225° for the AC current wave shown in the figure…

Q: Find the required R4 resistance to obtain Vo/Vi= -24 gain in the amplifier circuit in the figure

Q: The figure below shows a circuit with several inductors and capacitors, with both series and…

A: the two capacitors connected in series are C and 2C The two inductors connected in parallel are L…

Q: What icon in Multisim should be clicked to see both the circuit and the waveform produced by the…

A: Multisim is simulator, simulator is a program which enables a computer to execute program which are…

Q: What icon in Multisim should be clicked to see both the circuit and the waveform produced by the…

A: The answer is given below

Q: Current as a function of time in an RLC circuit can be described by damped harmonic motion equation…

Q: The resonance frequency of a series RLC circuit is 9000 Hz . Part A What is the resonance frequency…

A: given, resonance frequency for RLC circuit (f)=9000Hzwe know that ω=1LC…

Q: Fill in the blank with correct answers: ww purely resistive RLC Series purely capacitive purely…

A: For purely resistive circuit , voltage and current are in phase. For purely inductive circuit ,…

Q: If the phase difference between voltage and current is -47', then the circuit will be series RL…

A: This statement is False This will be RC circuit because our phase angle is negative (-47⁰) that is…

Q: The voltage current phasor diagram shown in the picture is fora AC circuit. Vo wt 25

A: For a R-L-C series circuit ,voltage and current are not in same phase . Voltage may lag,lead or be…

Q: The graph of impedance against frequency for an RLC series resonance circuit is shown in the…

A: At resonance impendence is minimum.

Q: How can we improve the quality factor of a tuning circuit?

Q: A coil of 3.50 μH and a capacitor of 47.0 pF are in parallel. The frequency is 9.55 MHz. There is…

A: Inductor "L"= 3.50 μH a capacitor "C= 47.0 pF The frequency "f"= 9.55 MHz.

Q: Solve for the impedance of a series RLC circuit with fr=800 Hz, R= 220 Ohms, L= 25x10^-3 H and C=…

Q: Explain why the current is the same in all parts of a series circuit. Further, de- scribe why the…

A: According to Ohm's law," voltage drop in a resistance is equal to the product of current and the…

Q: What is the RMS voltage from a sinusoidal AC source that has an output V = 875 sin(2ft)? (Enter…

Q: Find the Req for the circuit shown below.

A: We have to find out the equivalent resistance so we will first simplify the diagram

Q: Given the graph below, what can be inferred about the voltage and current in a circuit with an AC…

A: An AC source is as it name says Alternating Current source. It means that the current varies…

Q: Fill in the blank with correct answers: B Frequency Series Resonance-Impedance vs. Frequency. The…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

100%

Select the correct equation for calculating the average power in a series RLC Circuit.
OP = IRMSƐRMS COS(4)
P =
IRMSERMS COS
2
OP = Içɛ0 cos(4)
Op = cos()
Igeo
V2
P

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Explanation

VIEW

Step 2 Conclusion

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Consider the RC high-pass filler circuit shown in Figure P33.53. (a) Find an expression for the ratio of the amplitude of the output volt age to that of the input voltage in terms of R, C, and the AC source frequency . (b) What value does this ratio approach as the frequency decreases toward zero? (c) What value does this ratio approach as the frequency increases without limit?
Calculate the reactance of a 5.0F capacitor at (a) 60 Hz, (b) 600 Hz, and (c) 6000 Hz.
Discuss possible practical applications of RL circuits.
A 2.0-F capacitor is charged to a potential difference of 12.0 V and then connected across a 0.40-mH inductor. What is the current in the circuit when the potential difference across the capacitor is 6.0 V?
The current in the RL circuit shown here increases to 40% of its steady-state value in 2.0 s. What is the time constant of the circuit?
Find the output voltage vo for the op amp circuit given below, where V= 8 V. 2 k2 + 1 mA V The output voltage vo for the given op amp circuit is V.
What is the time constant of a RC circuit with R = 10 k-ohms and C = 500 μF
Given a series circuit with total voltage of 15, R1 = 7 Q, R2 = 4 Q, and R3 = 2 Q. %3D Find the 12.
The voltage phasor diagram for a certain series RLC circuit is shown in Figure below. Find the maximum voltage AVmax (în Volt) if AVL = 147 V, AVC = 95 V and AVR = 137 V. Round your answer to 2 decimal place. AV. max AVR AVc 3
The figure below shows voltage (red) and current (blue) vs time graphs for a series RLC circuit. (a) What is the resistance R? (b) If L = 200μH, what is the resonance frequency in Hz? E 10 V -10 V- 50 2 A 100 μs --2 A
is same acrOSs the circuit in series circuits. O Voltage O current O resistance O none 942f3eb89375d41..jpg P Type here to search hp 米 %24
What is the voltage drop across R in the circuit below if the shown resistances have the following values: R1=10 N R2=10 N R3=10 N and the voltage provided by the voltage source is 13 volts. R1 R2 R3 adap fo V