R 4. A resistor and a capacitor are connected in series across a supply of 250V. Where supply frequency is 50HZ the current in the circuit is 5A. When the supply frequency is 60HZ, the current is 5.8A. Find the value of the capacitance.

R 4. A resistor and a capacitor are connected in series across a supply of 250V. Where supply frequency is 50HZ the current in the circuit is 5A. When the supply frequency is 60HZ, the current is 5.8A. Find the value of the capacitance.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: 3. A series circuit composed of a 0.2 henry inductor and a 74 micro farad capacitor is connected to ...

A: This question belongs to circuit theory . It is based on the relation between voltage , current and ...

Q: 13.7 Find the poles and zeros of the impedance seen looking into the terminals a,b of the circuit sh...

Q: Question-1: The induced magnetic force, given by Find = i (L x B), is called motor action and the in...

A: a. This induced forces in generator is there to counter the input forces applied by prime mover. Thi...

Q: A universal series motor, when operating on 220 Vdc draws 10A and runs at 1400 rpm. Find the new spe...

A: Universal Motor The Universal motor can operate either in a single-phase AC supply or DC supply. To ...

Q: 3.84.2 In the circuit shown in the image below, if V1 = 12.1 mV and R1 determine current lo in µA. =...

Q: A 50 ohms transmission line of length L=λ/2 in Figure Q.1 is to be used in RF testing. Determine the...

Q: 6 UTM 5 UTM 8 U the accelerator is pressed occurs Q.2 A car locking system is to be designed with fo...

A: The truth table can be designed based on the given condition and the design can be obtained by using...

Q: A depletion MOSFET has IDSS = 10 mA and VP = – 4.5 V. Calculate the drain current at a gate-source v...

Q: 15. A factory takes a load of 2,400 kva at 0.6 lagging power factor. A synchronous motor having an i...

Q: -. Consider resistances 1002 and 200 2 are connected in parallel. What resistance x in parallel with...

A: This question belongs to circuit theory . It is based on the parallel combination of resistances . H...

Q: An ac supply of 220 V is applied to a Half wave rectifier circuit through a transformer of turn rati...

Q: 1. Find the ABCD constants of a network consisting of a 500-ohm resistor shunted across its sending ...

A: In this question we will find ABCD constants of given circuit.... Note:- as per our guidelines , I w...

Q: A 5hp, 220V, 24.08A, 60 Hz, single-phase induction motor with power factor 0.8 lagging. What capacit...

A: To operate induction motor at unity power factor, the capacitor should supply reactive power requir...

Q: 16. Which of the following are part of Total Filtration (Select 5) a. Dielectric Oil b. Half V...

A: Filtration- It is a process of filtering anything which means the mixture of anything go through wi...

Q: A PMMC instrument with a 200 turn coil has magnetic flux density in its air gaps of B=1.2T. The coil...

Q: Here x = 3 model and parameter when operating in region A? e model and parameter when operating in r...

A: The current(I)-Voltage(V) curve of a hypothetical piecewise linear device is shown below,

Q: 49. Which of the following is true for first-generation wireless systems? a) Low rate b) Efficient c...

Q: A hand written solution is needed for each of the following problem/circuit below. You may submit yo...

Q: 3 Given the information appearing in the figure Give the information below. Determine: below, determ...

Q: 6.7 In cylindrical coordinates, V = 0 at p = 2 m and V = 60 V at p = 5 m due to charge 10 distributi...

A: GIVEN: (1) V=0 at p=2m V=60V at p=5m ρr=10...

Q: Q2. A single phase half wave ac/de converter has a resistance of 252 and input ac voltage of 50V. Ca...

Q: The maximum collector current that a transistor can carry is 500mA. If β = 300 what is the maximum a...

A: Given Transistor with Maximum collector current IC(max)=500 mACurrent gain β=300

Q: A coil has a resistance of 14 Q at 50°C. If the temperature coefficient of resistance at 0°C is 0.00...

Q: Suppose that 0(t) = wot + t/2 and i«(t) = v2cosw,t i,(t) = v2sinwot i,(t) = -VZcosw,t Note that the ...

A: given and

Q: In the magnetic circuit of Fig. 6.49, the core is composed of annealed sheet steel for which a stack...

A: Given stacking factor =0.9 core thickness =5 cm core width = 3 cm

Q: A 100 µA ammeter has an internal resistance of 100N. For extending its range to measure 500µA, the s...

A: Given: Meter resistance, Rm=100 Ω Current through ammeter, Im=100 μA Extended current, I=500 μA

Q: 12V Re 102 RL Fig.2 Fig-1

A: Let the voltage drop during forward biased condition of the practical diode be 0.7 V. The diode is f...

Q: 20: Given Ldc=0.98 , determine Bodc: Pdc O Given Pdc=120 , determine the cormesponding value of d. ©...

Q: (a) Figure Q.4.1 shows a negative edge triggered T and JK flip-flops connected in complete the timin...

A: We will draw output waveform for given flip flop circuit

Q: Ordinary Differential Equations M- 06. Solve the following initial value problem over the interval f...

A: GIVEN: dydt=yt3-1.5y y(0)=1 FIND: midpoint method with h=0.5

Q: The voltage v(t) across a device and the current i(t) through it are: v(t) = 25cos(2t) V, i(t) = 15...

A: The solution is given below

Q: p-flops (b) Design a 3-bit counter for the sequence given in Figure Q.4.3 using D flip-flops and bas...

A: We need to design the given counter by using of D flip flop

Q: +16 V 3.6 kN 270 kQ ovc Ic IB B = 120 1.2 k2 FIG. 4.129

A: (27) The given circuit diagram is shown below:

Q: A B What is the resulting expression of X? Choices: a) (AB)' b) (A+B)' c) AB' + A'B d) AB + A'B' Y

A: Option d) AB+ A'B' is correct answer.

Q: 44. In Figure E.44 are some descriptions of filters in the form of an impulse response and two frequ...

A: When a dynamic system is faced with a brief input signal, termed an impulse, the impulse response, o...

Q: 1. Find the Fourier Series of f(t) = t² where te[-6,6] and f(x + 12) = f(x). %3D

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: A voltage v (t) = 141.4 sin (314 t+10°) is applied to a circuit and a steady current given by i (t) ...

Q: . Find the Fourier Series of f(t) = t2 where (x + 12) = f(x). t E [-6,6] and %3D

Q: A unit step voltage u(t - 5) is applied to the R-L network below. The current is given by ww R = 10 ...

A: Given circuit,

Q: A What is the resulting expression of Y? Y B.

Q: The A and B constants of a three-phase transmission line are 0.96/_1.0deg and 100/_80deg ohms, respe...

A: The ABCD parameter model in matrix form can be represented as ...

Q: j4 N 33n j2N + 6Ω 4Ω VΑ V.ホ-j20 2VA +1 +1

Q: Write a matrix equation that determines the loop currents For each matrix, let row 1 corenpond to lo...

A: A mesh is defined at a loop which does not contain any other loops within it. To apply mesh ...

Q: Determine the power factor of the system with v(t) = 120 sin( 2wt - 30)V and %3D i(t) = -12 cost(2wt...

A: In this answer we will find the power factor from the voltage and current equations given as explain...

Q: A PMMC instrument with a 200 turn coil has magnetic flux density in its air gaps of B=1.2T. The coil...

A: Given: A PMMC instrument with, Number of turns, N = 200 turns Flux density in the air gap, B = 1.20...

Q: What will be the MMF required to produce a flux density of 0.88 T in an air gap of 8 mm?

Q: 1 Given the information below, determine. Give the information below. Determine: DC Equivalent Circu...

Q: Please answer the two questions, and in the other picture are the drawing we had made. (Which are th...

A: Given: Consider the figure (that shows the schematic symbol(types) of electrical loads, switches, re...

Q: E2.27 Find V, in the circuit in Fig. E2.27. I + 2VA A 4 kN 6 V(+ 8 kN Vo Figure E2.27

Q: Solve for the total impedance of the circuit at 60 Hz. R1=5ohms L1=21.22mH C3=132.63 microF L4=4...

A: This question belongs to circuit theory . It is based on the concept of series and parallel combinat...

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

R
4. A resistor and a capacitor are connected in
series across a supply of 250V. Where supply
frequency is 50HZ the current in the circuit is
5A. When the supply frequency is 60HZ, the current is
5.8A. Find the value of the capacitance.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
A resistor & a capacitor are connected in series across 230V, ac supply. The current taken by the circuit is 4 A for 50 Hz frequency. The current is reduced to 2 A, when the frequency of supply is decreased to 40 Hz. Determine the value of resistor & the capacitor.
A resistor of 20ohms and a capacitance of unknown value when connected. In in parallel across a 100V, 50Hz supply take a current of 6A. The combination is now connected across a 100V supply of unknown frequency and the current falls to 5.5A . What is the frequency?
1. Enumerate five formulas for series-parallel capacitances across Vt source and draw the circuit. 2. Enumerate five formulas for parallel-series capacitances across Vt source and draw the circuit.
A resistor of 20 Ohms and a capacitance of unknown value when connected in in parallel across a 100V, 50Hz supply, take a current of 6A. The combination is now connected across a 100v supply of unknown frequency and the current falls to 5.5A. What is the frequency?
1)The value of the capacitance reactive power in VAR is? /2) The value of the capacitor in micro farad is?
A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
A resistor and a capacitor are connected in series across a 150V AC supply. When the frequency is 40Hz the circuit draws 5A. When the frequency is increased to 50Hz, it draws 6A. Find the values of resistance and capacitance. Also find the power drawn in the second case.
A capacitor C is connected in series with a 400 resistor across a supply of frequency 60 Hz. A current of 3 A flows and the circuit impedance is 500. Calculate: (a) the value of capacitance, C, (b) the supply voltage, (c) the phase angle between the supply voltage and current, (d) the p.d. across the resistor, and (e) the p.d. across the capacitor. Draw the Phasor diagram.
Please explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
C5 What is the correct explanation for the voltage seen at Va in Figure C5? Va 1 Sost We will assume that the Vout Out Vb, capacitor is charged to a value determined by the feedback and the supply voltage +BVsat. Figure C5 A. The waveform on the capacitor looks like a discharge, and then a charging waveform to an equal but opposite magnitude voltage, B. The capacitor simply reverses its charge, with a charging waveform, C. The capacitor simply reverses its charge, with a discharging waveform, D. None of the above.
6. An inductive circuit of 50-2 resistance and 0.08-H inductance is connected in series with a capacitor across a 200-V, 50-Hz supply. The current taken is 3.8 A leading. Find the value of the capacitor.