Question 4: Calculate the flow rate of blood through the following system. Assume that the syringe is kept 1 m above the ground level. Ignore minor losses. a. Deriving the pressure balance of the system b. Calculation of blood viscosity c. Calculation of pressure loss through the tubes d. Calculation of flow rate Blood L=1m D= 0.5 cm Plastic tube L=0.1 m D= 1.5 cm Glass tube

Question 4: Calculate the flow rate of blood through the following system. Assume that the syringe is kept 1 m above the ground level. Ignore minor losses. a. Deriving the pressure balance of the system b. Calculation of blood viscosity c. Calculation of pressure loss through the tubes d. Calculation of flow rate Blood L=1m D= 0.5 cm Plastic tube L=0.1 m D= 1.5 cm Glass tube

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter11: Calibrating Instruments

Section: Chapter Questions

Problem 13RQ

See similar textbooks

Similar questions

a. Mention any four primary transducers involved in the measurement of pressure. b. Explain the measurement of pressure using Bourdon tube with neat diagram.
The venturimeter can measure volume flow rate in a flow channel Select one: True False
2. A main pipe GH branched into three pipes; HI, HJ and HK. A liquid flow with a flow rate of 25 liters/minute via piping HI. If the flowrate in the pipe GH is three times greater than the rate of flow in the pipe HJ and HI flow rate is 1.5 times less than the rate of flow in the pipe HJ. a. Calculate the flow rate in the main pipe GH. b. Get diameter pipes HK if the mean velocity in the pipe HK is 2.3 m/s
400mm Kerosene, SG=0.82 Air, SG=0.0012 Benzene, SG= 0.88 100mm 200rim 150mm 90mm Water Hg What is the pressure difference between the pipes of air and benzene?Use SG of mercury as 13.6.
The velocity of the liquid flowing through the divergent portion of a Venturimeter is increases Select one: True False
On average, you inhale approximately 1 L of air every 2 seconds. The pressure difference between the outside air and your chest cavity creates this flow. The air flows through your trachea which has a radius of 0.005m and a length of 0.12m. Do not ignore the viscosity of air in this problem. a. What is the velocity of the air moving through the trachea? b. Is this flow laminar or turbulent? Support your answer with calculations. c. What is the pressure in your chest cavity required to create this flow? Assume the outside air has a pressure of 1 atm.
Write relation of resistance and viscosity with co-efficient of discharge.
TRUE or FALSE Pitot tube is an insertion meter. When this is located at the center, the flow that will be measured will be minimum.
Why must the tube of a flow meter be vertical?
Piezometer can be used to measure the pressure at a single point for a gas flowing through a pipe. (True/False
Find visocisity of whole blood @ 37oC
8. In the regenerative circuit shown below, the pump's flow rate is 10 gpm. If the piston diameter is 7 in and the rod diameter is 5 in (not a 2:1 cylinder), calculate the extension speed in in/min. Also calculate the oil flow rate at points A and B in gpm. (recall 1 gal = 231 in') PF The diagram above does not show a working regenerative circuit. What must be added in order for the circuit to be practical and why?