Question 2The op amp has v₁ = -0.1 V, a random input offset voltage, Vos ≤ 10 mV and input bias currents,IBI IB2 10 μA. R₁ = 5 ks, R2 = 10 k2 and R3 = 2 k. Find the maximum possible positive outputvoltage, vo.ViR₁R₂VoFinal AnswerVo=(V)

Answered: Image /qna-images/answer/33cfe609-2aaf-489e-8724-4435c88e670f.jpg

Answered: Question 2 The op amp has v₁ = -0.1 V,…

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The Op-Amp is configured as shown below, and the input is a sinusoid with frequency = 1kHz, and 1 Vpp. Draw the output voltage waveform and indicate min and max amplitude of it if your biasing voltage of Op-Amp is +- 15V. Vin V out Rf=10 Rg=1 Figure: 1 If input is changed to DC voltage in Figure 1, which goes from 0 V to 5 V, draw the output with respect to input DC voltage.
4. Determine the voltage gain of the non-inverting op-amp with Rf-100k and R1=4.7k02. Calculate the output voltage if the input voltage is 200mV
B. The output of a particular Op-amp increases 8V in 12us. The slew rate is a. 90V/us. b. 0.67V/us c. 1.5V/us. d. None of the above abugem e IMo fert nerll 1ellams obufing sma dw
An inverting op amp has Rf= 600kohm and R1= 6kohm. Determine the op amp circuit voltage gain, input resistance and output resistance. Also Determine the output voltage and input current if the input voltage is 0.1 V. Assume op amp to be ideal one.
An op-amp has a maximum output voltage swing between ± 14 V. The feedback resistors are R1 = 1.5 KQ, R2 = 7.3 k2, and R3 = 7.6 k0. The input voltage (Vin) is Vin = 0.2 V. What is the output voltage (Vout) to within 1% accuracy? o + Vin Vout= M r₁ ww + HI r3 V 0 + Vout Report questi
1. A certain op-amp has an open-loop gain of 80,000. The maximum saturated output levels of this particular device are +12 V when the de supply voltages are +15 V. If a differential voltage of 0.15 mV rms is applied between the inputs, what is the peak-to-peak value of the output?
Consider the following circuit using diode and Op-Amp. Assume ideal Op-Amp with output saturation at +-13V. Assume diode forward drop is 0.7V. a. Find Vo and VA when Vin = 1V and 3V. b. Find V, and VA when Vin = -1V and -3V. R Vin R VA ovo ER₂
2 Figure 3 shows an operational amplifier circuit with two current sources to model its bias currents. The op-amp can be considered as ideal. 1,-10µA Vi Rx Vo R2 I-10µA R1 Figure 3 The gain of the amplifier is 30dB, R1=10KQ, determine the resistance value of R2. Determine the output voltage of the amplifier for Vi=0.1V, Rx=00. Determine the value of Rx so that no bias current error appears at the output of the amplifier
An ideal op-amp circuit is shown above, with dc supply Vcc = -Vcc = 12V.Assume that v1 = 2V, v2 = 2V, R1 = 3Ω, R2 = 3Ω. Please determine Rf (in ohm's) so that the output voltage vo = -10 volts.
From the figure , write note voltage equations, one for each input terminal of the op amp The expression for the load current ( iL) can be written as a function of the input voltage (Vin) and the load voltage (VL) IL =A(Vin) + B(VL) b.1 What is the expression for A? b.2 What should be the condition for R1 R2 R3 R4 so that B is zero? (NB this will make( iL) depend only on Vin and not on RL)
Problem • Find the values of the input and output impedances. Determine the closed-loop voltage gain. The op-amp has the following parameters: Al 50,000, Zin = 4 Mohm, Zout = 50 Ohm Vino R₁ www 1.0 k R₁ www 100 kn
Q6 Calculate the output voltage of a non- inverting op-amp if the feedback resistance Rf is 7.5KQ, input resistance R1 is 2.5KQ and the input *.signal is 100 mV Vin oVout 0.6 V O 1 V 0.8 V 0.4 V O

SEE MORE QUESTIONS

Recommended textbooks for you

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Fundamentals of Electric Circuits

Electrical Engineering

ISBN:

9780078028229

Author:

Charles K Alexander, Matthew Sadiku

Publisher:

McGraw-Hill Education

Electric Circuits. (11th Edition)

Electrical Engineering

ISBN:

9780134746968

Author:

James W. Nilsson, Susan Riedel

Publisher:

PEARSON

Engineering Electromagnetics

Electrical Engineering

ISBN:

9780078028151

Author:

Hayt, William H. (william Hart), Jr, BUCK, John A.

Publisher:

Mcgraw-hill Education,

SEE MORE TEXTBOOKS

Question 2 The op amp has v₁ = -0.1 V, a random input offset voltage, Vos ≤ 10 mV and input bias currents, IBI IB2 10 μA. R₁ = 5 ks, R2 = 10 k2 and R3 = 2 k. Find the maximum possible positive output voltage, vo. Vi R₁ R₂ Vo Final Answer Vo= (V)