Ql: A plate (100 mm) wide and (15 mm) thick is joined with another plate by a singe transverne weld and a double parailei filler weld as shown in figure The maximum tensile and shaar stresses are (75 Naa & 60 Mpa) respectively Find the lengh of each paralel fillet weld. ifthe jeint is subjected to static loading

Ql: A plate (100 mm) wide and (15 mm) thick is joined with another plate by a singe transverne weld and a double parailei filler weld as shown in figure The maximum tensile and shaar stresses are (75 Naa & 60 Mpa) respectively Find the lengh of each paralel fillet weld. ifthe jeint is subjected to static loading

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.9MCQ: Match the following: (i) Hysteresis loss (a) Can be redud by constructing the core with laminated...

See similar textbooks

Similar questions

Match the following: (i) Hysteresis loss (a) Can be redud by constructing the core with laminated sheets of alloy steel (ii) Eddy current loss (b) Can be reduced by the use of special high grades of alloy stl as core material.
The principle operation of LVDT is based on the variation of Select one a. Self inductance b. Reluctance c. Mutual inductance d. Permanence
Please show full work. Thank you
What is the accurate LVDT output voltage when the core is at the centre position? a. 5.22V b. 2.5V c. 0 d. 1.2V
what is the use of DC/DC tension converter DC/DC booster MT3608
Two identical diodes with Is=7 x 10-16 A are connected in series as shown in Figurey. Calculate the voltage across R₁ when I 4mA. 12 --- R₁ = 2K² Ix
the non-inductive resistance of kelvin double bridge are set at 100ON each, the standard resistance is set at 0.10020 and the low resistance 0.0000122 was very low. determine the unknown resistance
Combination circuit What is the current? What voltage across each load ?
The thickness of laminations used in a transformer is usually 0.4 mm to 0.5 mm O 14 mm to 15 mm O 25 mm to 40 mm 4 mm to 5 mm
Step by step solutions please
converter topologies in pv system
Welding is defined as a joining process that produces co- alescence of materials by heating them with or without the application of what?