Answered: Q4: find the current in 4mf capacitance…

Engineering

Electrical Engineering

Q4: find the current in 4mf capacitance if the source value is 4 sin(100t) Amp: R3 R2 5.52 792 4mF 6H www 2H

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 5PP: Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 -...

See similar textbooks

Related questions

Q: 2- For the network of Fig. 16.44: a. Find the current I₁. b. Calculate the voltage Veusing the…

Q: The 6v zener diode shown in fig below has zero zener resistance and a knee current of 5 mA passing…

A: The voltage across the diode is 6 V. The value of the knee current is 5 mA. The input voltage is 10…

Q: Q2: for figure 1, find IL 380/0° V 380/120° V P for load and S for source? " ▷ a Ia 380-120° V Ib n…

A: In this question, We need to determine the load current IL , active power P, and apparent power of…

Q: A 50-µF and 100-µF capacitors are connected in series and across a 100 sin (wt + 30o) voltage.…

A: In this question we need to choose a correct option

Q: Compute the following values for each item. Write your answers on a clean sheet of paper. <1.…

A: The filter can be designed based on the cutoff frequency and the capacitor value given in the…

Q: (2-2) An ideal germanium diode at a temperature of 125°c has a reveres saturation current of 30μA.…

Q: alculate the critical DC voltage limits, and sketch e VTC for the following inverter. VIN O PL No…

A: Given data: 1. Calculate critical DC voltage limit 2. Sketch the VTC Thr circuit given in the…

Q: Determine the approximate value of Vcc of Figure 52. VDD SV 1.5kO

Q: Example For the system shown in the fig below find the output C(s) R1(s) G1(s) Fon R2(s) G2(s) Fcn2…

A: To find the output C(s) for the given system

Q: An AM transmitter is modulated by two different signals (55% and 75% modulation indices). How much…

A: Given, Modulation indices, m1=55%=0.55m2=75%=0.75 Carrier current, Ic=12 A

Q: What is the total current supplied by the voltage source in the circuit below? 202 402 M m 12 V (+…

Q: For a BJT, Ic = 5 mA, I₂ = 50 μA and ICBO = 0.5 μA, then the value of ß is?

A: Given for a BJT, Collector current, IC=5 mA Base current, IB=50 μA ICBO=0.5 μA

Q: 4. Find Vo using Nodal Analysis

Q: Figure 4.00 Ω . 3.00 AL 2.00 A R &₁ + ww 23.00 Ω 1 of 1 > 6.00 Ω 15.00 A Submit Request Answer Part…

A: Given data, Circuit diagram is given as,

Q: If a signal bandwidth is 1 MHz and the channel signal-to-noise ratio is 30 dB, what is the Shannon…

Q: How do we increase the voltage gain of an inverting and non-inverting op amp amplifier?

Q: Find the total capacitance of the combination of capacitors shown 5.0 μF 1.5 μF 3.5 μF 0.75 μF 15 μF…

A: Given A circuit made of capacitors, we need to find the equivalent capacitance of the circuit.…

Q: Modulator: High level AM Series modulator +Voc Audio modulating signal Qemitter follower RFC Q₁…

A: AM modulator- AM modulator is a modulator which is used used for the superimposition of low…

Q: Q12) The gain of vertical deflection amplifier in CRT is 90. If an input signal of 110mV is applied,…

A: The given data is shown below. The gain =90input signal =110mVE;lectric field =33V/cmVertical…

Q: A parallel-plate capacitor with area 0.400 m² and plate separation of 2.00 mm is connected to a…

A: Given, A parallel plate capacitor Area of plates, A=0.400 m2 Plate separation, d=2.00 mm Supply…

Q: Determine the approximate value of VD of the given circuit below. VDD 13.3 V 11.78 V 12.63 V 115M…

Q: Three Impedances each of (8 - j18) are connected in mesh across a three-phase 410V ac supply.…

A: In this question we need to find a line current , phase current , real power and reactive power of…

Q: How It is required to find the midband gain, the upper and lower -3dB (0707 Au) frequencies of the…

Q: If a signal bandwidth is 1 MHz and the channel signal-to-noise ratio is 30 dB, what is the Shannon…

Q: PROBLEM: Derive the z-transform for f(t) = sin oot u(t).

A: It is Given that: f(t)=sinωtu(t)

Q: Q1] find the voltage of the inductance 1H if the value of the source is: 50 sin( 100 t) volt R3 R1…

Q: 3-phase, 220kV, 200km overhead transmission line has its conductors on the corners of triangle with…

A: In this question we need to find a total inductance and capacitance of transmission line.

Q: Draw Block diagram and transfer function of DC series motors

A: A DC series motor venture is to show the electrical electricity into mechanical one primarily based…

Q: Determine the GMR of the conductor

Q: What is the Baud rate for M-ary digitally modulated carrier if M = 8 and channel capacity = 2.7 kHz…

Q: Consider the following circuit. What is the value of current I in the circuit shown? (a) I A (b) 2 A…

A: Given,

Q: A circular coil of 15 turns and radius 4.0 cm is placed with its plane oriented at 90° to a uniform…

A: Given, Turns in coil, N=15 Radius, r=4 cm Plane orientation with magnetic field is 90 degrees.…

Q: A receiver with a 75-ohms input resistance operates at a temperature of 31°C. The received signal is…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: The message signal m(t) = 2 cos 400t + 4 sin (500t + 3) modulates the carrier signal c(t) = A…

A: Given information: The expression of the message signal is mt=2cos400t+4sin500t+π3 The expression of…

Q: Two units of generation maintain 132 kV and 120 kV (line) at the ends of an interconnector of…

A: Power to be transferred = 22MW, Receiving end voltage VR =120kV, Sending end voltage=132kV,…

Q: (a) A Moore sequential circuit has one input X and one output Z. The output Z = 1 if and only if the…

A: (a) A Moore sequential circuit has one input X and one output Z. The output Z = 1 if and only if the…

Q: - previous 4- If VI 400V and the wattmeter read 800W at no load test then the value of Ro is b)40052…

Q: The reactance X of inductance L =j/wL True False

A: We need to tell about whether the given statement is true or false

Q: Consider the circuit with five resistors and two batteries (with no internal resistance) shown in…

A: The required parameters can be obtained by using the mesh analysis. The equation can be obtained by…

Q: 3- Implement f(a,b,c,d) = m(0,1,5,6,7,9,10,15) by using 4 multiplexer and a,b as a select line.

Q: Current "I" that flows through the resistor 12 2 is 0.5 A, Find the potential difference between…

A: Given circuit: Current through 12 ohm resistor, I=0.5 A

Q: 46-kv 0.8-lagging power factor load is connected to the end of a short transmission line where the…

Q: What is the Baud rate for M-ary digitally modulated carrier if M = 8 and channel capacity = 2.7 kHz…

A: Baud rate is rate at which the data is transmitted that is number of bits transmitted per second.

Q: The frequency f of 12πcos(300t) =300/2πt O True O False

Q: Determine the approximate value of source voltage (Vs) of the given circuit below. VDD 1MQ 20V 1.8kQ…

Q: Q2/ The Nyquist plot of the open-loop transfer function K(T₂S + 1)(T₂S + 1).... (Tms + 1) GH(s) = sn…

A: The Given Data is The Nyquist of the open-loop transfer function. GHS=Kt1S+Lt2S+L-------tmS+LSnis…

Q: Q3) In the Anderson Bridge for the measurement of inductance, drive the equations balance for the…

A: Q3. Anderson Bridge Convert delta to Y

Q: 2.5. Find 11 and 12 in the circuit. 3mA--------> 12--------> ww ww

A: Given circuit,

Q: 2. The positive, negative and zero sequence reactances of a 20 MVA, 13.2 kV synchronous generator…

Q: (a) Describe how TLBs are used to increase paging efficiency.

A: TLB contain entries page table have been most recently used. The processor examines , the frame…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

Q4: find the current in 4mf capacitance if
the source value is 4 sin(100t) Amp:
R3
R2
502
792
:4mF
6H
wwww
2H

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
A resistor of 20ohms and a capacitance of unknown value when connected. In in parallel across a 100V, 50Hz supply take a current of 6A. The combination is now connected across a 100V supply of unknown frequency and the current falls to 5.5A . What is the frequency?
1)The value of the capacitance reactive power in VAR is? /2) The value of the capacitor in micro farad is?
A resistor of 20 Ohms and a capacitance of unknown value when connected in in parallel across a 100V, 50Hz supply, take a current of 6A. The combination is now connected across a 100v supply of unknown frequency and the current falls to 5.5A. What is the frequency?
A capacitor in series with a 20-KO resistance across a 10 V ac source. What size C is needed for equal voltage across R and Xc at frequency of 100 Hz and 100 KHz.
4. The current through a 10-mH inductor is 10e“²A. Find the voltage and the power at t = 3s. Ans.-11.16 mV and -24.89mW
A capacitor C is connected in parallel with a resistance R across a 60-V, 100 Hzsupply. The supply current is 0.6 A at a power factor of 0.8 leading. Calculatethe value of R and C.
A 500 nF capacitor is connected in series with a 100 kohm resistor and the circuit is connected to a 50V, d.c. supply. Calculate the initial value of current flowing, the value of current 150 ms after connection, the value of capacitor voltage 80 ms after connection, and the time after connection when the resistor voltage is 35 V.
An inductance coil consumes 500W of power at 10A and 110V and 60HZ. Determine the resistance and the inductance of the coil
Q2: Find the voltage in all capacitor in figure below where the capacitance in uF C1 300 C4 400v 100 C2 C5 60 100