Q1) A 4 poles de separate excited generator has 56 slots, and each armature coil has 8 turns. Thewire used to wound the armature has a resistivity = 6.2 x 10-8 2.m, and the average length ofeach turn = 1.8 m, the wire cross-section area = 5 mm². If the flux per pole = 0.012 web, findthe load voltage when the generator is wave wound, driven at 110 rad/sec, and supplies 7 A.3+10/50+8/Q2) A series de motor has flux characteristics given by p= web, when I represent the field'scurrent. If the supply voltage = 100 V, the armature resistance = 0.7 £2, and the field resistance= 0.32. The motor takes 25 A when driving a load at 1450 R.P.M. Find load torque, startingtorque, and no-load speed. Draw the required circuit diagram.Q3) Two de generators, A and B, connected in parallel with the following characteristics:GA: P=3 Kw; Vr = 200 V, ra = 192.GB: E=210 V; I, = 20 A, ra = 0.8 2.Find the maximum possible load power, the power supplied to the load at floating conditions.Q4) Answer any four questionsA: Draw the circuit diagram for the shunt generator and give the condition for its voltage build-up?B: If the no-load voltage of the series generator is 12 V. and the load voltage of it at a certainload is 180 V. What will be the voltage regulation?C: The separate excited motor with no-load speed = 150 rad/sec has a speed = 115 rad/sec at atorque = 22 N.M. At what torque will its speed be 1350 R.P.M?D: Why the load voltage at the same conditions for shunt connected generator is less than whenseparate excited?E: The parallel operation of two dc, A and B, generators when EA> EB will cause a circulatingcurrent. What is the direction of this current, and which machine will act as a generator?

To find the load voltage of the generator, we need to calculate the armature resistance and the…

Q1) A 4 poles de separate excited generator has 56 slots, and each armature coil has 8 turns. The wire used to wound the armature has a resistivity = 6.2 x 10-8 22.m, and the average length of each turn = 1.8 m, the wire cross-section area = 5 mm². If the flux per pole = 0.012 web, find the load voltage when the generator is wave wound, driven at 110 rad/sec, and supplies 7 A.

Q1) A 4 poles de separate excited generator has 56 slots, and each armature coil has 8 turns. The wire used to wound the armature has a resistivity = 6.2 x 10-8 22.m, and the average length of each turn = 1.8 m, the wire cross-section area = 5 mm². If the flux per pole = 0.012 web, find the load voltage when the generator is wave wound, driven at 110 rad/sec, and supplies 7 A.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A DC generator has an armature emf of 500 V when useful flux/pole is 20 mWb, and a speed of 625 rpm. The generated emf at a speed of 125 rpm and same flux is
A magnetic ring has reluctance of 1.675 × 10⁰ AT weber. The flux to be produced by the coil is 800 x 10 webers, then the AT required for the m.m.f. will be
AC Machinery Fundamentals A three-phase delta-connected six-pole winding is installed in 36 slots on a stator. There are 150 turns of wire in each slot of the windings. All coils in each phase are connected in series. The flux per pole in the machine is 0.060 Wb, and the speed of rotation of the magnetic field is 1000 r/min. What are the resulting phase and terminal voltages?
3. A group of electromagnets that create flux in a d-c generator (the field circuit) has an inductance of 18 henrys. If the 3.4 amp excitation is interrupted in 0.08 sec by the opening of the field switch, what average voltage is induced in the winding?
There are 144 slots in a 3-phase, 16-pole, 50 Hz., star connected alternator. There are 4 conductors in each slot and all the conductors in a phase are connected in series. Coil span is 1500 electrical and the flux per pole is 0.05 Weber sinusoidallly distributed. Calculate the emf induced per phase.
The armature of a two-pole generator is rotating at 3600 r/min. The armature has a simplex lap winding with a total of 1504 conductors. Determine the generated voltage when the flux per pole is 600,000 x 10-8 Wb. 5.5
The strength of the rotating magnetic field in a three phase induction motor is equal to times the flux produce ...... ....... in one of the phase windings. 1.25 1 O 1.5
A wave wound armature of an eight-pole generator has 06 slots. Each slot contains 16 conductors. The voltage required to be generated is 300 V. What would be the speed of coupled prime mover if flux per pole is 0.05 Wb.If the armature is rewound as duplex lap wound machine and run by same prime mover, what will be the generated voltage.
Magnetic Field of Single Coils / Biot-Savart’s Law
A 4 pole generator with wave wound armature has 51 slots each having 24 conductors. The flux per pole is 0.01Wb. At what speed must the armature rotate to give an induced EMF of 220V. What will be the voltage developed if the winding is lap connected and the armature rotates at the same speed.
A 6-pole, 3-phase, 60-cycle alternator has 12 slots per pole and four conductors per slot. The winding is 5/6 pitch. There are 2,500,000 maxwells (0.025 weber) entering the armature from each north pole, and this flux is sinusoidally distributed along the air gap. The armature coils are all connected in series. The winding is wye-connected. Determine the open circuit emf of the alternator.
A four pole machines generates 250V when operated at 1500 rpm. If the flux per pole is 1.85 x 106 maxwell, the number of armature slots is 45 and the armature winding has two parallel paths. If the speed of the generator is reduced to 1350 rpm, what would be the generated voltage. To what value of flux per pole should the excitation be adjusted if the generated voltage is to remain the same at 250V