One single page energy meter operating on 230 Volt and 5 ampere for 5 hours makes 1940 revolutions. Meter constant is 400 revolution per kWh. The power factor of the load will be?

Q: with Izk=15mA Zz = 20ohm and Vz = 14 V at 45 mA. VIN ā 14.8v 0.57v 21.8v O 13.43v O 14.3v R 560 Ω

A:

Q: O - side. 10au. copper loss is not anocit by way and the 12) Shunt field winding have a large number…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: The transfer function of a series RLC bandstop filter is given b 1 LC H(w) = -0². + R -w² +=jw+ L At…

A:

Q: O √2a The (110) plane - calculate the surface density of atoms using the value of a from Task 2 and…

A:

Q: Find F-T ifs XLt) = 28 (t +27-28 (x-2) - rect ( ++ + vect+1) anso 4 (Sin² (w) - 25/nc (2W)) Hello…

A:

Q: Two impedances Z₁ and Z2 are connected in series to a voltage source with voltage Vs volts. Let V₁…

A: Given that two impedances are connected in series to a voltage source Vs. V1 is the voltage across…

Q: Using voltage divider for the below circuit Find v₂ ? V₁ 10 V + 01 R₁ 8 ΚΩ - O "₁ R₂ 2 ΚΩ + 02

A:

Q: Find F-T it. -X(t) = 28 (+ +27_28 (+-2)_rect (6+1) +rect 8-1 auso 4 (Sin² (w) - 25/uc (ZW)) Hello…

A: Note:  The given answer is incorrect. The correct answer is given below

Q: 7. The primary and secondary induced e.m.fs. El and E2 in a two-winding transformer are…

A:

Q: The reverse current in a diode is of the order of O KA mA O A O μA

A:

Q: 1. If a DC voltage is applied to a DC motor, then, according to Fleming's Left hand Rule, the motor…

A: 1) working principle of DC motor  2) Lost torque in the motor represents

Q: Using voltage divider for the below circuit Find v₂ ? U₁ 10 V + U1 www R₁ 8 ΚΩ O R₂ 2 ΚΩ

A: Given data, Circuit diagram is given as,

Q: Question 1 Is O 1200W Is= 25 A Power absorbed by R₂ will be: O 7500W R₁ O None of the above O 300W…

A: Given circuit, And the parameters are, Is=25 A,R1=3 Ω,R2=12 Ω .

Q: The slip of a 12 pole, 3-phase, 50 Hz induction motor is 10%. Find the speed of the motor ✓ 450 rpm…

A: Given, A 3-phase induction motor having, Number of poles, P=12. Frequency, f = 50 Hz. Slip, s=10%.

Q: The simplified SOP form of the K-map shown below is CD AB 00 01 00 1 11 10 10 1 X 011001 11 0 1 1 0…

A: We need to find out the SOP for given K map

Q: Why would we want to use circuit theory and when can we use it? What are the characteristics of…

A: When the two charges are separated by a small distance, then it forms an electric dipole. The…

Q: There are 180 double wound slots in a 3-phase, 50 Hz., 500 rpm, star connected alternator. Coil span…

A:

Q: Explain how one can distinguish between two circuit elements which are connected in series verses…

A: In networks we can have passive elements like resistor, capacitor and inductor that can connect…

Q: Calculate the number of turns and the cross section of a conductor for a 300 kVA, 66000/400 volts,…

A:

Q: In the circuit shown in Figure 10.17, find the mesh current I₂. R₁ R2 O 3 Ω Vs 2220° Figure 10.17 a.…

A:

Q: i(t) llll i₂(1) с

A:

Q: Determine the main dimensions of 40 kW, 3 phase, 400 V, 50 Hz, 1440 rpm squirrel cage induction…

A:

Q: Calculate the equivalent resistance of the resistor combination in Fig.Q2. 5 V 10 Ohm 30 Ohm 20 Ohm…

A: Given circuit,

Q: A Wheatstone bridge ABCD has the following details; AB-1000 : BC- 100 : CD-4500: DA-50000 A…

A: We have an Wheatstone bridge circuit as shown figure.   We have been asked to find the galvanometer…

Q: A 3-phase, 50 Hz, oil cooled core type transformer has the following dimensions: distance between…

A:

Q: In the circuit shown in Figure 10.30, find the transfer function H(o) = Vo/Vin. R₂ Figure 10.30 b.…

A:

Q: Having the text (AA AB ACBC CBBAAADB B B C D). Find The information content in (C)

A: SOLUTION GIVEN--                              TEXT (A A A B A C B C C B B…

Q: A hydro-electric power station has a reservoir of area 2-4 square kilometres and capacity 5 × 106…

A: We have a hydro-electric power station having, Reservoir area = 2.4 Square killometer Volume or…

Q: In a 132 kV, 3-phase, 50 Hz power system, the line to ground capacitance is 0.03 μF and the…

A:

Q: 7. Find Tp whose transfer function is G(s) = 361 s²+16s+361

A: Given, Transfer function, Gs=361s2+16s+361

Q: 8 In wien's bridge, the output frequency is determined by: a-LC combination. c- RLC combination.…

A: Weins Bridge The Weins bridge was developed by Max Wien in 1891. It contains 4 resistors and 2…

Q: Determine the value of the Current 13. +1 12 V + - ww 892 O A. 0.44 Amps OB. 1.05 Amps O C. 0.15…

A: Please comment if you need any clarification. If you find my answer useful please put thumbs up.…

Q: 27. Two resistors of 100 2 and 200 2 are connected in series across a 4-V cell of negligible…

A:

Q: 9. Find T, whose transfer function is G(s) = 361 s²+16s+361

A: Given: Transfer function, Gs=361s2+16s+361

Q: 35. In Fig. 28, the 10 resistor dissipates 360 W. What is the voltage drop across the 5 resistor?…

A: Note: We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: Two impedances Z₁ and Z2 are connected in series to a voltage source with voltage Vs volts. Let V₁…

A: Please comment if you need any clarification. If you find my answer useful please put thumbs up.…

Q: how to stop a rapid rise in power supply from destroying and malfunctioning your computer

A: Power surge:- A significant increase in the current flowing through your electrical system causes…

Q: Q.3) A synchronous motor operating at rated voltage draws 1.0 pu current at 1.0 power factor. The…

A: Given- Synchronous motor, 1.0 pu current at 1.0 power factor, synchronous reactance 1.0 armature…

Q: A MOSFET has........ Select one: O a. four O b. two O c. three O d. five terminals

A: The MOSFET stands for Metal oxide semiconductor field effect transistor. It is a semiconductor…

Q: *2. Using superposition, determine the current I, for each net- work in Fig. 18.108. XL + E₁ = 20 V…

A: In this question,  We need to determine the current IL  as shown the circuit using the super…

Q: 1. A supemode is situated between... a) Two essential nodes b) Two reference nodes c) Essential node…

A: Q) 1) A supernode is a concept that can be utilized to solve a circuit in circuit theory.  This is…

Q: A 20 ohm resistance is connected across the secondary winding of a single-phase power transformer…

A:

Q: Calculate the actual sag and vertical sag from the following information  Weight of conductor = 0.9…

A:

Q: WHAT IS THE VALUE OF AX MOV [BX],AX USEFUL INFORMATION AX=0022 DX=0033 DS=02B1 ES=0402 SP=0204…

A: Given that MOV [BX], AX Find the content of AX.

Q: A generator connected through 5 cycle CB to a transformer is rated 8000 kVA with the reactances of…

A: A generator is connected through the 5 cycle circuit breaker to a transformer .   It is operating at…

Q: Determine the time of operation of a 1 A, 3 second over current relay having plug setting of 125 per…

A:

Q: Suppose that a system generates a stream of upper case alphabetic characters and that the…

A:

Q: +1 12 V + WW 82 - + 9 V 3,1 - کے W 20 2

A:

Q: A resistance oven uses four coils of resistance 30Ω each. If the supply voltage is 240 V A.C. If so,…

A:

Q: Let R = 20 S2, L = 63 mH, and vs(t) = 90 cos(2760t+30°) V in the circuit shown in Figure 9.23. Use…

A: We need to find out output voltage for given circuit

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.