ол + V₂ +

Q: For each of the 8 circuits below, draw small signal model and calculate Vout/Vin. Vb1, Vb2 are dc…

A:

Q: The current through the inductor in the circuit below is initially zero and the switch SW is closed…

A: We need to prove the given equation for given circuit .

Q: A 25 kW, 240 V self excited dc shunt generator has a field circuit resistance of 62.5 02, and an…

A:

Q: I= 2 12 १ 2 ( 6-I - 3 - 1) 2 १ ( 2 -1) 2 = २(५+३९ पर) 9 I+8= o

A: Given, Here, need to explain about how the equation is coming from the previous steps.

Q: z (-1) = Z. 2₁ + j2. Tanpl јас там ре Zo + Prove HW 1 (b

A:

Q: Question: 2 Calculate n; for intrinsic Silicon crystal at 32°C? At thermal equilibrium, what will be…

A: Given: T=32° C Required: ni at T=32°C.

Q: a. If ix = 5A, find v₁ and iy; b. If v₁ = 3V, find ix and iy; c. What value of is will lead to v₁ #…

A: The required parameters can be calculated by using the kirchhoff's current law, current division…

Q: 3. Solve Ix and all the mesh currents using mesh analysis. lov ( + 15V (+ 252 1₁ 65 13 Me 75 =102 8…

A:

Q: Problem 4.30 (Node-Voltage Method) Find the power developed by the 20 V source 35 έφ ΖΩ 1Ω Va Va 4Ω…

A:

Q: 1. A 30-ohm resistor is connected in series with a resistor R whose ohmic value is unknown. If the…

A:

Q: x Problem 5. Which of the following corresponds to the periodic signal shown in the plot! not…

A: The signal has an average value .i.e. a0. From the figure, a0=1.

Q: Find the Norton equivalent with respect to the terminals a, b for the circuit in (Figure 1). Suppose…

A: Step 1 Given that: vs=87 V, and R= 14 ohm. The circuit is shown below. Calculate Norton’s…

Q: E₁ + R₁ www I₁ mia Consider the circuit shown above where, + R2 ia www {R3 E₁ =3 V, E₂=5 V, R = 302,…

A:

Q: t is the frequency at which the magnitude of the output becomes 0.707 of the maximum. A) CUT OFF…

A:

Q: Vcc Ja poto 4 3 DIDO 1 5 W x 1 1

A: Given circuit consists of two nand gates with some logic values VCc and ground It also contains LED

Q: Obtain the value of mesh currents I1 and I2.

A: In this question,  We need to determine the mesh current as shown the circuit.  We are solving this…

Q: 2. Determine the (a) total resistance and (b) current at 10-ohm resistor, if the two resistors…

A:

Q: The EMF induced in the armature of a shunt generator is 500 V. The armature resistance is 0.2 2 if…

A: Given: A shunt generator with, Induced emf in the armature, E=500 V. The armature resistance, Ra=0.2…

Q: 4. A 12-ohm resistor is connected in parallel with a series combination of 8-ohm and 16-ohm…

A: In this question,  We need to determine the equivalent resistance, total supply voltage and current.…

Q: Get the equivalent resistance in point a and b b 62 +j85 Q 62+j85 Q a 12 - 109 Q 52-j3 Q 52-13 Q 12-…

A:

Q: b) (3y+-- X x dy TA y²dx +(5x+ 1 y y x =0

A:

Q: Q13) Calculate the current I, in the following circuit

A:

Q: Using mesh analysis with complete solution Determine the current passing through each resistor in…

A: Given circuit,

Q: An 11kV volts three phase wye connected turbo alternator has a synchronous reactance of 6 ohms and a…

A:

Q: Vout Vinº VDD=1.8 V J ID= ERD M₁H 1 Rs mA RG Given: VDD = 1.8 V, RG = 100 kOhm, RD= 3 kOhm, RS = 2…

A:

Q: Resistive load of 84.6 MVA is connected to a bus bar with 9.4kV. If the base of 100MVA and 10kV are…

A:

Q: An AC power Supply is connected to a Capacitor of capacitance 5.5.10-6 F. At time t=0, the power…

A:

Q: A current of 1 A is maintained in a simple circuit with a total resistance of 2.5 20. How much heat…

A: Given data, Current i= 1 A. Resistance R=2.5 Ω. Time t = 4.5 sec.

Q: Subject: Ideal Conductors and Capacitors A conducting sphere of radius a, at potential V0, is…

A:

Q: A person is asked to do pumping of water for 4 hours. Compute the power that can be generated by the…

A: .                           SOLUTION  Given t = 4hours Let Mass of water = m Height of pump from…

Q: A 1200 kVA, 6600 V 3 phase Y connected alternator has an effective resistance of 0.40 ohm and a…

A:

Q: Consider an n-channel metal-oxide-semiconductor field-effect transistor (MOSFET) with a gate-to- W…

A: Given- N-channel MOSFET, Gate to source voltage- VGS=1.8 V, Ratio of width of the gate to channel…

Q: G(s)=35/s(s+5) find: damping ratio natural freq.

A: We need to find out damping ratio and natural frequency for given characteristics equation .

Q: E2.7 Find I, and I, in Fig. E2.7. Figure E2.7 6 mA 1mA 1.51,

A:

Q: 3. Two (2) 30-ohm resistors are connected in series, when a resistor R is connected across one of…

A: We need to find out unknown resistor ,R for given total resistance .

Q: The curve shows the current flowing through a circuit element. Find the net charge q that has…

A: It is given that: i1=4 mA

Q: The magnetic susceptibility of aluminium is 2.1×10-5. The permeability and relative permeability…

A: Given, Magnetic susceptibility of aluminum, Χm=2.1×10-5.

Q: E2.7 Find I, and I, in Fig. E2.7.

A: The required parameters can be calculated by using the kirchhoff's current law at the nodes.

Q: Determine the power dissipated by the element of electric fire of resistance 20 when a current of…

A: Power dissipated by the element = (current I )2 (resistance R ) .  energy E = power (in kilo watts )…

Q: Set the battery voltage to 12 V, and the value of the resistor to 20 ohms. Measure current on the…

A: Given data: The voltage, V=12 V The resistance, R=20 Ω The circuit diagram is shown below,

Q: Compute the power dissipated on the Resistance on the red box. Given R1 = 15 ohms, and R2 = 30 ohms.…

A: To find the power dissipated in the resistance in the red box

Q: Find the power factor 4Ω V Μ κα -j2Ω j5Ω -j2Ω Ans : pf = 0.555 (leading)

A: We need to find out the power factor for given circuit .

Q: A separately excited generator has a no-load voltage of 130V at a field current of 2.1 A when driven…

A: Generated emf of DC machine is directly proportional to product of flux and speed. Take the ratio of…

Q: What is the order of a closed loop control system for a plant with a transfer function equal to G(s)…

A: Given a plant with transfer function, Gs=ks21+Ts. Unity feedback, Hs=1.

Q: Draw the complete logic diagram from the given logic equation, maximum of 2 inputs per gates used.…

A: Given: F=X'YZ+XY'Z+(XZ')' To do: We have to draw the logic diagram from the given logic function.…

Q: A network containing 50 buses in which 10 are the voltage control buses, 6 are the generator buses.…

A:

Q: An ACSR conductor has a diameter of 2 cm has internal inductance of 0.05 mH/Km. If this ACSR is…

A:

Q: Given: R1-6 ohms, R2-4 ohms, R3-8 ohms, R4-7 ohms, R5-9 ohms, R6-1 ohms, R7-8 ohms, and Rg-7 ohms.…

A:

Q: 1. Determine 1₁, 1₂ and 13 using current division. 180V (+ 80 = 11₁ 452 M 62 300 82 M 100 122 |√1₂…

A:

Q: 3. Solve for I and the power delivered to the 3-k resistor using Mesh Analysis and KVL at the outer…

A:

Thevenin Theorem

Any linear circuit, no matter how complex, maybe simplified to an equivalent circuit utilizing only a single voltage source and series resistance coupled to a load, according to Thevenin's Theorem. The superposition principle says that all foundational equations must be linear, and the notion of "linear" is still the same (i.e., there should not be any exponentials or roots). This is particularly the case when operating with passive elements like resistors, inductors, and capacitors. However, some components (particularly some gaseous and semiconductor devices like tunnel diode, Schottky diode, transistors like BJT, MOSFET) are nonlinear, meaning their current resistance fluctuates with voltage and current. As a result, circuits made up of these parts are known as nonlinear circuits.