Minimize the logic function Y(A,B,C,D)= Em(0,1,2,3,5,7,8,9,11,14). Use Karnaugh map. Draw logic circuit for the simplified function. (9)
Q: The period of the voltage 2 cos 4500πt + 7 sin 7500πt is
A:
Q: Current I (amperes), voltage V (volts), and resistance R (ohms) in a cırcuit are related by Ohm's…
A: Given: Current= 'I' Amperes Voltage= 'V' Volts Resistance= 'R' ohms Ohm's law, I=V/R
Q: Q2) Determine the response of the Measuring devices through calculation ?
A: The required parameters can be calculated by using parallel resistance concept and by using mesh…
Q: 3. Determine whether the systems with the following characteristic equations are stable or unstable:…
A:
Q: An apparatus that converts analog data into its digital equivalent is referred to as a digitizer.…
A: Given: Digitizer: Digitizer is an apparatus used to convert the analog data into digital data. It is…
Q: 1. Determine the partial fraction expansion for V(s) and compute the inverse Laplace transform. The…
A:
Q: Que 2.11. Determine V, and the required PIV rating of each diode for the configuration of Fig.…
A: Given: Input voltage, Vi=100V All diodes are ideal. Load resistance, RL=3.3kΩ
Q: Find the damping ratio and natural frequency for each second-order system shown below and show that…
A: Given data, Transfer function is given as, Ts=5s+3s+4=5s2+7s+12
Q: Consider unity feedback system with forward path transfer function 25/s(s+ 5); what are the values…
A: Given: Forward path transfer function, Gs=25ss+5 Unity feedback, Hs=1
Q: Calculate the reverse saturation current of a diode if the current at 0.2V forward bias is 0.1mA at…
A:
Q: Que 1.4. Sketch output voltage (Vo) for the network of Fig. 1.6.1 for the input given. Assume diodes…
A: Given that: A circuit is given as shown below. Diodes are ideal. Sketch the output waveform.
Q: 5. A parallel plate capacitor of value 4.0 µF is charged with a 6.0 V battery. After fully charging…
A:
Q: The current through the load is 50 V ( 1:5 00000 1 ΚΩ
A: Given: Transformer circuit
Q: Simplify the following expression into sum of products using Karnaugh map…
A: Solution !!
Q: 12. The speed of the rotating flux in Fig. 20-16 will be (i) 1500 r.p.m. (iii) 750 r.p.m. (ii) 1000…
A: The term "induction motor" refers to a motor that operates on the electromagnetic induction…
Q: Use any technique you prefer to prove the logic rule: A.(A + B) = A
A: Given, The logic expression is AA+B≡A
Q: 25 3. a) How many nodes are in the following circuit b) Find Vx using the nodal voltage analysis. c)…
A: We are authorized to answer only 3 subparts at a time since you have not mentioned which part you…
Q: 4. A single-loop negative feedback system has the loop transfer equation: L(s) = Ge(s)G(s) = K(s +…
A: GIVEN: L(s)=Gc(s)G(s) =K(s+2)2(s(s2+1)(s+8)) FIND: (1) sketch…
Q: There is no figure with this question. Determine the resistance of a load that draws 400 mA of…
A: Given: Load draws current, I=400 mA Connected across battery voltage, V=12.8 V
Q: Q1. Find the Laplace transform of the following time functions: (a) f(t) = 1 + 2t (b) f(t) = 3 + 7t…
A: We are authorized for answering only three subparts at a time since you have not mentioned which…
Q: An 8-pole lap-connected armature has 40 slots with 12 conductors per slot generating a voltage of…
A: The voltage supplied to the motor by an external power source is known as EMF or electromotive…
Q: Example 20. Calculate the power drawn in a circuit given the following voltage and current…
A:
Q: 12. The speed of the rotating flux in Fig. 20-16 will be ********** (i) 1500 r.p.m. (iii) 750 r.p.m.…
A:
Q: 4. ★★ Two coaxial air-filled solenoids, A and B, of equal length (€ = 20.0 cm) and radii R₁ = 2.50…
A:
Q: (b) The two n-MOSFET's have VT=+1 V, μCox = 20 μA/V2, L= W = 5 μm, while VDD = +5 V and VGG = +4 V.…
A: Given: VT=+1 VμCOX=20 μA/V2L=W= 5μmVDD=5 VVGG=4 VVIN=0 V Find: Operating region of the MOSFET, when…
Q: Find the applied voltage on a forward biased diode if the current is 1mA and reverse saturation…
A: Find the applied voltage on a forward biased diode if the current is 1mA and reverse saturation…
Q: Consider the circuit shown in Figure 1. The capacitors have the same plate area. The capacitance of…
A: We are authorized to answer one question at a time, since you have not mentioned which question you…
Q: Find the decimal equivalent of the binary number (1011.011)2
A:
Q: An npn transistor
A:
Q: For the following circuit, find the -3dB bandwidth in Hz if the unity gain frequency ft is 100,000…
A: Given circuit: Unity gain frequency, ft=100,000 Hz
Q: Minimise the logic function F(A,B,C,D)=IIM (1,2,3,8,9,10,11,14)-d (7,15) Use Kamaugh map. Draw the…
A:
Q: V; -02 V 20 ΚΩ Μ • 10 ΚΩ 200 ΚΩ ΖΙΩ
A: Given: Circuit diagram
Q: Assume that a four-pole de machine has an armature with a radius of 15 cm and an effective length of…
A: We have an 4 pole DC machine with, Radius (r) = 15 cm = 0.15 m Length (l) = 30 cm = 0.30 m Pole…
Q: g) f(t) = 5cos2t + 3e4t h) f(t)et + sin(t-2) + 1²e-²1
A:
Q: 2. The power of a circuit is giving as follow: p(t) = 150e(-10t) Calculate the total energy of the…
A: Given data, Signal is given as, pt=15e-10t
Q: Solve for the equivalent resistance and the total current. 48 V 4Ω 20 Ω 5Ω 24 Ω 8 Ω 15 Ω 15 Ω Μ 15 Ω…
A:
Q: A 300 km 132 kV 3-phase overhead line has a total series impedance of 52 +j20 Ω/phase and a total…
A:
Q: 3. In the ideal transformer circuit shown below, the source V₁ = 70/0° Vms and the load is simply a…
A:
Q: The plots in Figure B1a, below, show a carrier signal modulated by a binary data sequence. Identify…
A: Given question is under digital communications techniques For binary amplitude shift keying…
Q: that has three different positions: a, b, and N. Initially, the switch is in position N (the circuit…
A:
Q: At starting, the windings of a 230 V, 50 Hz, split-phase induction motor have the following…
A: Given, At starting, the winding of a split phase induction motor have the following parameters For…
Q: Example: Sketch the single-sided and double-sided spectra of x(t) = 2 sin (10nt - ²n)
A:
Q: Q₁-- a) The discrete time signal x[n] is defined by Find y[n] = x [2n + 3] Q₂-- x[n] = 1, -1, Sketch…
A: Since you have asked multiple questions, we will solve the first question for you. If you want any…
Q: A 25 MVA, 13.2 kV alternator with solidly grounded neutral has a subtransient reactance of 0.40 p.u.…
A:
Q: Q#05: Apply Gauss's law to the Gaussian surfaces S1. Sz and S, in figure to calculate the electric…
A: The given figure is shown below:
Q: 2-2m. If Vs = 100 volts, find: (use crack diagram) A lossless transmission line having Z-5002,…
A: Given: Z0=50 ΩVS=100 VKr=0.4<45λ=2 Find: 1. Standing wave ratio 2.Voltage standing pattern
Q: The performance of a communication system can be affected by noise from both internal and external…
A:
Q: In the figure shown below, if, R3 = 502, determine v. 10 V R₁ = 20 52 www R₂=. 2012 Ry
A: Given circuit: R3=5 Ω
Q: Solve for the equivalent resistance and the total current. 48 V 4Ω 20 Ω www 5Ω 24 Ω ΑΛΛΑ 8 Ω 15 Ω…
A:
Q: The effective armature resistance of a 3-phase, star connected, 500 kVA, 1100 V alternator is 0.1 £…
A:
Step by step
Solved in 2 steps with 2 images
- Design a logic circuit with four inputs and one output that will produce "l" in the output only if the input patterns have odd number of zeros. a) Write the Boolean equation for the circuit in the simplest SOP form. b) Draw the logic circuit for the above equation in its simplest form. c) Re Design the logic circuit using NANI) gates only?An X-input exclusive-OR gate and a Y-input exclusive-OR gate (where X=3, Y=4 have their outputs connected to a 2-input exclusive-NORgate. Do the following:a) Draw the logic diagram and analyze the logic expression of the output (in standard SOPform).b) List out all essential prime implicants.Consider the given logic equation below. Draw the logic diagram then simplify it using Boolean Algebra. Draw the logic diagram based on the simplified logic equation. X = A'BC' + A'B'C' + AB'C + AB'C' + A'B'C From the given logic diagram, trace the output using all possible input combination. Give it a conclusion upon completion..
- Design the following combinational logic circuit with a four-bit input and a three-bit output. The input represents two unsigned 2-bit numbers: A1 A0 and B1 B0. The output C2 C1.C0 is the result of the integer binary division A1 A0/B1 B0 rounded down to three bits. The 3-bit output has a 2-bit unsigned whole part C2 C1 and a fraction part CO. The weight of the fraction bit CO is 21. Note the quotient should be rounded down, i.e. the division 01/11 should give the outputs 00.0 (1/3 rounded down to 0) not 00.1 (1/3 rounded up to 0.5). A result of infinity should be represented as 11.1. A minimal logic implementation is not required. (Hint: start by producing a truth table of your design).Consider two 8-bit inputs, A = $52 and B = $C3 to the arithmetic and logic unit (ALU). Compute R =A + B. Express R in the hexadecimal form $-- : -61 Express N-Z-V-C bits in the form ----:9. Design a combinational logic circuit: to convert Excess 3 (3-12) to BCD code (0-9). Note: Assume don't cares (X) wherever necessary in the simplification process
- DIGITAL LOGIC DESIGN Are the following addition results Overflow or underflow and why?Design a combinational circuit with the four inputs A,B.C, and D, and three outputs X, Y, and Z. When the binary input is odd number, the binary output is one lesser than the input. When the binary input is even number the binary output is one greate than the input. Implement the function using multiplexers with minimal input and select line.MNO P D For the given logic circuit, find the following: a. Logic Equation or Output b. Simplified logic expression using Boolean Algebra c. Simplified circuit S
- Basic Combinational Logic Circuits 2. Write the output expression for logic circuit: A B B X1. Design a combinational logic circuit that compares two 4-bit numbers A and B. The circuit should output the relation of the two inputs. Use an available TTL IC for the design.6. For the follow logic circuit system, the output f is: 5 (A) ab. (B) a + b. (C) a'+b'. (D) a'b'. a b