MCQ- When the lower sideband components of the Double Sideband (DSB) signal whose spectrum is given in the figure are suppressed with a filter, when the signal obtained by suppressing it with a filter is multiplied by cos(ωct) in the time domain, which of the following signals is the

Q: An antenna has a noise temperature Tmt = 4° K . It is connected to a receiver which has an…

A:

Q: 12.45 Given the series RLC circuit in Fig. P12.45, (a) derive the expression for the half-power…

A: Given a series R, L and C circuit in which

Q: Determine the eight-point DFT of the signal x(n) = (1, 1, 1, 1, 1, 1, 0, 0} and sketch its magnitude…

A: 8 point DFT of the signal : x(n)={1,1,1,1,1,1,0,0} to sketch its magnitude and phase

Q: Q7. For each of the following baseband signals: i) m(t) = 2 cos(1000t) + cos(2000t); ii) m(t) =…

A: Solution

Q: c) A subcarrier is a modulated carrier signal at a lower frequency that is combined with the main…

A: Given data, Frequency of the subcarrier fsc=70 kHz Tones, fm1=2.1 kHzfm2=6.8 kHz Carrier frequency…

Q: For the following bandpass filter with component values below the circuit; Choose the correct…

A: In this question, choose the correct options What is transfer function of the given circuit.  H(w) =…

Q: Find the gain of the following circuit and the lower and upper cutoff frequencies. (RS = 1 kΩ, R1 =…

A:

Q: Two 4000 rad/s bandlimited signals such as m1(t) and m2(t) are transmitted simultaneously over a…

A: Two 4000 rad/s bandlimited signals such as m1(t) and m2(t) are transmitted simultaneously over a…

Q: Find the midband gain, lower- and upper-cutoff frequencies, and bandwidth of the amplifier with the…

A: To find the mid-band gain, lower- and upper-cutoff frequencies, and bandwidth of the amplifier with…

Q: Q 2. For a modulating signal m(t) = 2 cos 100t + 18 cos 2000t, (a) Write expressions for Phase…

A: (a) The expression of the phase-modulated signal is given as:…

Q: 1. Show that the transfer function for a prototype narrow bandbandreject filter…

A: A bond reject have the following characteristics . Now to prove it , we assume the series RLC…

Q: Q2/ If the modulating signal given by m(t)=2cos(2n10t)+3cos(2n30t), and the carrier signal given by…

A: Given data, m(t)=2cos(2π10t)+3cos(2π30t)and c(t)=5cos(2π500t)

Q: Two signals with a band limit of 4000 rad/s such as m1(t) and m2(t) are transferred to H(w) as shown…

A: According to the question we have to,  a) Draw the frequency spectrum of the signals at points A, B,…

Q: 12. A power signal x(t) with no signal power outside the frequency range - fe/100 < f < fe/100 is…

A:

Q: Suppose that the modulating signal m (t) is sinusoid of the form m (t) the form C(t) = 4 COS (…

A:

Q: 1. Show that if the low-pass filter circuit illustrated isscaled in both magnitude and frequency,…

A: The low pass filter circuit is shown below: (a) The transfer function of the low pass filter is…

Q: Consider the system shown below. Square-law y(1) device z(1) BPF An FM signal u(t) = 5 cos(210r+sin…

A: Given input is  And  Effective Band width of modulated signal  is  Compare given modulated signal…

Q: 1. Calculate the equation for the transfer function, amplitude response, and phase reponse based on…

A:

Q: 6. If transfer function of the circuit is h(t) = e -2t u(t), determine the transfer function H(w)…

A: The transfer function of the circuit is given below: ht=e-2tut The Laplace transform of the above…

Q: Q4. Answer A) An AM/DSB-LC signal has a power of 140 watt, the maximum frequency of the baseband…

A: As per our company guidelines we are supposed to answer only first question kindly repost other…

Q: Problem 3: An FM signal pem(t) = 5cos(2n × 10ºt + sin(2n × 10*t)), is input to a square law…

A: Given data: vint=5cos2π×106t+sin2π×104tVo=2Vint2f=2 MHz

Q: RC=10 kΩ, RE=5 kΩ, RL=2.2 kΩ, CS=10 µF, CC=1 µF, CE=20 µF, Cbe=20 pF, Cbc=10 pF, VT=26mV, β=100,…

A:

Q: Q10: Determine the magnitude of the - frequency transfer function of the transversal filter, shown…

A:

Q: 12.33 Determine H(jo) for the magnitude characteristic shown in Fig. P12.33. IHI4 20 dB/dec +20…

A: In bode plot ,i If critical frequency is due to pole , then change in slope will be     -20…

Q: 5cos(2n x 10°t + sin(2 × 10*t)), is input to a square law An FM signal ofm(t) = nonlinear device…

A:

Q: A loaded filter circuit is shown in the figure below, where R=5KS2; L=4H; C=4µF; R =20k2. R L a)…

A: Given ; R = 5 kΩL =4HC=4HRL=20kΩSolution (1) Loaded Bandwidth βL We know that βL =R+RLRLx1RC…

Q: The transfer function for the bandreject filter shown in isH(s)=s2+(1LC)s2+(RL)s+(1LC).Show that if…

A: Write the given transfer function. Hs=s2+1LCs2+RLs+1LC

Q: Given an LTI  system with the transfer function H(jΩ)= e-jΩ (2+2cosΩ), the input signal…

A:

Q: Consider the system shown below. z(1) Square-law device BPF signal u(1) = 5 cos(2r10°t+sin 20000zt)…

A: Given input is  And Effective Band width of modulated signal is Compare given modulated signal…

Q: The transfer function H(f) of a filter is represented by the following magnitude and phase plots.…

A:

Q: 17 Determine the eight-point DFT of the signal x(n) (1, 1, 1, 1, 1, 1,0, 0} and sketch its magnitude…

A:

Q: An amplifier has the following low-frequency response AL (s) = 104. 8 (0.01s + 1) (0.18 + 1) (s +…

A: From the above question the given transfer function is as follows:…

Q: 4.2-1 For each of the baseband signals: (i) m(t) = cos 1000t t; (ii) m(t) = 2 cos 1000rt + sin…

A: "According to the Company's policy we will solve for the first signal as each signal is different".…

Q: L + + Vent(t) R Vsal(1)

A: Introduction: In RLC series circuit resonance occurs when inductive reactance and capacitive…

Q: A DSB-modulated signal u(t) = Am(t) cos 21 fet is mixed (multiplied) with a local carrier xL(t) =…

A: Since double sideband (DSB) modulation scheme is used, the expression of the signal obtained at the…

Q: H.W.(7): (a) Show that for a bandpass filter sB H(s) = s2 + sB + w where B = bandwidth of the filter…

A: Band pass filter is a setup device which passes frequency of certain range and rejects frequency…

Q: x(t) = 5+2 cos(20nt) + 3cos(400nt). a) What is the bandwidth of x(t)? Determine the Nyquist sampling…

A:

Q: 1. Show that if the high-pass filter illustrated  is scaled inboth magnitude and frequency, the…

A: 1) The transfer function of the low pass filter is, Hs=-Kωcs+ωc Here, K is gain. ωc is cut-off…

Q: The modulating signal that is the input into an FM modulator is m(t) = 2cos (10nt). a) Express the…

A: The answer as given below steps;

Q: A transmitter provides 32 W to an antenna having 12 dB gain. The receiver antenna has a gain of 3 dB…

A:

Q: Suppose that the modulating signal m (t) is sinusoid of the form m (t) the form C(t) =4 COS ( 2n10ºt…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: True or false? The Nyquist diagram is obtained by evaluating the transfer function G(S for values of…

A: State the given statements are true or false ?

Q: Q10: Determine the magnitude of the – frequency transfer function of the transversal filter, shown…

A:

Q: [Q3] Two baseband signals m1(t) and m2(t) are to be multiplexed using the following system. (a)…

A:

Q: 4 find the transfer function and frequency response function of the zero order LTI measurement…

A: Brief description: In the above givan question they want to know the bode magnitude and phase plot…

Q: given a descrete signal x[n]={...0,10,8,6,4,2,0,...} find even component and odd component

A: In this question we need to find even component and odd component of the given signal.

Q: 3.40 The modulating signal into an FM modulator is m(t): = 10 cos 167t The output of the FM…

A:

Q: SDSB (J) if -f. - f-f. -f,+ fm

A: We need to tell about LSB  of DSB .

Q: (2) Consider a LTI system with the following transfer function H.(s) = N,(s)/D.(*), where D.(s) = +…

A: Dear student you posted a question with multiple subpart.we have limited time to solve your…