Light with a wavelength of 633 nm goes through a narrow slit. The angle between the first minimum on one side of the central maximum and the first minimum on the other side is 1.2o. What is the width of the slit?
Q: Figure 302 22 12 V (Live battery) ww b Travel a ww 40 4V (Dead battery) Part J Find the power…
A: The objective of this question is to find the power dissipated in the 1.2 ohm resistor between…
Q: How much energy is required to change a 43.0-g ice cube from ice at -9.0°C to steam at 113°C?
A: Mass of ice is Initial temperature is Final temperature is Note:Specific heat capacity of ice is…
Q: Light with a wavelength of 511 nm forms a diffraction pattern after passing through a single slit of…
A:
Q: The figure shows a lower leg being exercised. It has a 49-N weight attached to the foot and is…
A:
Q: The uniform solid block in the figure has mass 38.6 kg and edge lengths a = 0.780 m, b = 1.82 m, and…
A: 50.45 kg.m2Explanation:
Q: A particle with a mass of 0.1 kg is initially at rest. It experiences a constant force of 5 N for a…
A: We can find the final velocity of the particle by applying Newton's second law of motion and the…
Q: Given the following system of point charges: a positive point charge +q is placed in the middle,…
A: W=−6.43JExplanation:Step 1: Calculate the potential energy between each charge pair Let us denote…
Q: A 60 gg horizontal metal bar, 14-cmcm-long, is free to slide up and down between two tall, vertical…
A:
Q: . The left end of a long glass rod 8.00 cm in diameter, with an index of refraction of 1.60, is…
A: Part a : The image distance is 14.77 cm. The image height is 0.5769 mm.Part b : The image is…
Q: An electron has de Broglie wavelength 2.78×10-10 m . Part A Determine the magnitude of the…
A: Introduction:We know the de Broglie wavelength is given as:λ=phorp=λh ......(1) Given:λ =…
Q: The automobile is originally at rest, i.e., s (t = 0 s) = 0 m. If it then starts to increase its…
A: Write the expression for the acceleration and substitute the corresponding function for the…
Q: The magnetic field through a circular loop of radius r=15cm varies with time.The direction of the…
A:
Q: The following figure shows a copper wire bent into a circular shape with a radius of 0.50 m. B (into…
A:
Q: Question 4: Energy Analysis + N2L+ Kinematics: Sliding off a dome A person of mass m initially sits…
A: Step 1: Step 2: Step 3: Step 4:
Q: seismograph to the focus of the quake. km Need Help? Read It Watch It
A: Here's how to use a seismograph to measure the distance to an earthquake's focal point…
Q: Two slits with a separation of 8.5 x 10-5 m create an interference pattern on a screen 2.3 m away.…
A:
Q: Ramp Problems: 1. A 10 kg object rests on a 30° ramp which has a coefficient of friction of 0.20. a)…
A: The objective of the question is to determine the behavior of the objects on the ramp. This can be…
Q: A block and a beaker filled with water are placed side-by-side on a scale (case A ). The block is…
A: When comparing the scale readings in these two scenarios, it's essential to understand how buoyancy…
Q: On November 2021, NASA launched a DART impactor with a mass = 610 kg. On 26 September 2022, it…
A:
Q: In an engine, a piston oscillates with simple harmonic motion so that its position varies according…
A: a) Plug in t=0 to the position equation. Note that the angle unit is in…
Q: it is not graded!! the d9 and d10 are just standards!!
A:
Q: A mass attached to a spring in a physics lab is set into oscillations. Over time the oscillations…
A: Option 4 : Overdamped oscillationsExplanation:In Overdamped oscillation, the required damping force…
Q: 1. Drops frequently form above the ocean by the mechanical disruption of waves in strong winds. How…
A:
Q: An atom in an excited state has a mass of 63.332 and then decays to a mass of 63.329 amu by emitting…
A:
Q: How much work is done by the horizontal force Fp of magnitude 100 N when it pushes the 20.0 kg block…
A: First, let's resolve the given force into components parallel and perpendicular to the…
Q: In the figure, a 110 kg uniform log hangs by two steel wires, A and B, both of radius 1.00 mm.…
A:
Q: 4) Calculate the pressure difference between A and B. Ow = 9,806 kN/m³ SGmercury: 13.6 = A+ water 30…
A: The objective of the question is to calculate the pressure difference between two points A and B in…
Q: One end of a uniform 4.10-m-long rod of weight Fg is supported by a cable at an angle of 0 = 37°…
A: Draw the free-body diagram of the system.
Q: 4) Consider the sliding bar AB of length = 1.00 m. If the end B is sliding down at 0.5 m/s at the…
A:
Q: 2. Unpolarized light of intensity 100 mW/m² passes through two filters. The first filter has an…
A: Question 2: The objective of this question is to find the angular alignment of the second filter…
Q: 8. Milky Way The Sun is a star in the Milky Way galaxy. When viewed from the side, the galaxy looks…
A: Diameter is Thickness is Note:Speed of light is Find:(a) The diameter and thickness in (b) The…
Q: There are 4 waves of wavelengths: λ1 = 10m, λ2 = = 620 × 10⁹m, 12 = 450 × 10¯⁹m, λ4 = 30 x 10-10m.…
A: The ticked options are correct.Explanation:Step 1: Consider this image of an electromagnetic…
Q: University Physics 1 - Rotation, Angular momentum, and Torque I need help with this problem and an…
A: The question is asking about the relationship between net force and net torque in a system.…
Q: The body in the figure is pivoted at O, and two forces act on it as shown. If r₁ = 2.15 m, r2 = 3.74…
A: Net torque about the pivot is -3.4 NmExplanation:Consider,Torque is rotational force that can cause…
Q: 12 If a capacitor has the capacitance of 20 uF and has a voltage of 12.2 x 103V, how much energy (J)…
A: Given values:C = 20 uF = 2 x 10-5 FV = 12.2 x 103 V Introduction:We know, energy stored in a…
Q: A mass m is released from rest from the top of a frictionless ramp. The mass slides down and…
A: Step 1: Consider the conservation energy of the system Since the ramp is frictionless, there will be…
Q: Where are the diagrams?
A:
Q: In the figure, block 1 has mass m₁ = 487 g, block 2 has mass m2 = 529 g, and the pulley is on a…
A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…
Q: 6. A 1500 kg satellite is in orbit 250 km above Earth's surface (v = 7756 m/s). Find work needed to…
A:
Q: 6. A particle with charge q = +e (where the value of e = 1.6 × 10-19 C) is at the center of a…
A: (a) The magnitude of electric field is E=3.84×10−7N/C (b) The direction of the electric field will…
Q: FRQ 1 This question is a long free-response question. Show your work for each part of the question.…
A: The question is solved with appropriate assumptions.Please give helpful rating.Explanation:
Q: object a, slding on a frictionless surface at 3.2 m/s hits a 2.0 kg object, which is motionless. The…
A: The objective of the question is to find the mass of object A given that it collides elastically…
Q: Find the optimum tilt angle for a south-facing photovoltaic module at latitude 32.3° at solar noon…
A: The objective of the question is to find the optimum tilt angle for a south-facing photovoltaic…
Q: 2. The atomic nucleus may be a sphere of a positive charge, with a diameter very much less than that…
A: The objective of the question is to discuss the experimental evidence that supports the view that…
Q: NEW General HI Q Q ↓ Close 5. The figure shows a charged dielectric sphere centered at the origin…
A: The objective of the question is to find the magnitude of the electric field at a certain point in…
Q: Q1/5 Sketch the magnetic field produced by a thin circular coil in the horizontal plane that has a…
A: The grey ring represents the coil lying on the horizontal plane.Here the white arrow circulating in…
Q: Mindy, a medical device engineer, is designing an apparatus to monitor the breathing of a patient.…
A: The change in area is The time period is The minimum emf detected is According to Faraday's law, the…
Q: A 740 N bear is standing on a metal plank supported by the cable shown in the figure. At the end of…
A: a)Draw the free-body diagram of the system.
Q: Two capacitors, empty inside, and with a capacitance of 2μF, are arranged in parallel and connected…
A:
Q: A solid cylinder as in the figure has a charge Q distributed uniformly over its volume. Find the…
A: The objective of the question is to find the electric field at a point at a distance d from the…
Light with a wavelength of 633 nm goes through a narrow slit. The angle between the first minimum on one side of the central maximum and the first minimum on the other side is 1.2o. What is the width of the slit?
Trending now
This is a popular solution!
Step by step
Solved in 2 steps
- A monochromatic beam of light of wavelength 500 nm illuminates a double slit having a slit separation of 2.00 105 m. What is the angle of the second-order bright fringe? (a) 0.050 0 rad (b) 0.025 0 rad (c) 0.100 rad (d) 0.250 rad (e) 0.010 0 radTwo point sources of light are separated by 5.5 cm a. As viewed through a 13 μmμm diameter pinhole, what is the maximum distance from which they can be resolved if red light ( λλ = 690 nmnm) is used? b. If violet light ( λλ = 420 nmnm ) is used?An EM wave with wavelength 6.50E-7 m passes through a thin slit and form a diffraction pattern on a screen 3.67 m away. The distance between the central bright fringe and the first dark fringe is measured to be 4.20-3 m. What is the slit width (in meter)?
- The coherence length of an ordinary white light source can be increased if we place a color filter in front of the source, so that the light that passes through the filter is somewhat monochromatic. The minimum wavelength of the emerging light is 546 nm. What is the maximum wavelength in order for the coherence length to be 0.1090 mm?1. A 10 mW beam propagates in a medium with n = 1.5+ (5 × 10-4) i and has a vacuum wavelength of 750 nm. What is the wavelength in the material and how far does it go into the material before its power is reduced to 1 mW?Monochromatic, coherent light is used in a Michelson Interferometer. One of the movable mirrors is shifted by 1.625 10-m. You see 50 pairs of bright and dark fringes passing the observation screen (or detector). What is the wavelength of the light? Please round the result to a whole number. X/nm What color does the used light have? Number
- Light of wavelength 516 nm passes through a slit 7.00 × 10-6 m wide and falls on a screen that is 3.00 m away. What is the distance on the screen from the center of the central bright fringe to the third dark fringe on either side? Number i 1.36 Units mA monochromatic light with 536nm pass through a slit that is 0.240 mm wide. In the resulting diffraction pattern, the intensity at the center of the central maximum is 4.00 *10-5 W/m2. What is the intensity at a point on the screen the corresponding to θ=1.20˚?Light of wavelength 630 nm is incident on a long, narrow slit. a)Determine the angular deflection of the first diffraction minimum if the slit width is 0.020 mm. b)Determine the angular deflection of the first diffraction minimum if the slit width is 0.20 mm. c)Determine the angular deflection of the first diffraction minimum if the slit width is 2.0 mm.
- The central bright fringe in a single-slit diffraction pattern has a width that equals the distance between the screen and the slit. Find the ratio λ / W of the wavelength λ of the light to the width W of the slit.In a large vacuum chamber, monochromatic laser light passes through a narrow slit in a thin aluminum plate and forms a diffraction pattern on a screen that is 0.620 m from the slit. When the aluminum plate has a temperature of 20.0°C, the width of the central maximum in the diffraction pattern is 2.75 mm. What is the change in the width of the central maximum when the temperature of the plate is raised to 520.0°C? Does the width of the central diffraction maximum increase or decrease when the temperature is increased?White light falls at an angle of 45° on a parallel soap film of refractive index 1.33. At what minimum thickness of the film will it appear bright yellow of wavelength 5896 Å in the reflected light ?