In the parallel connection of the following two port network, which of the following is correct I₂₁ I 16 Y, 120 V20 126

Q: Obtain the transfer function C(s)/R(s) of the block diagram shown in the Fig.(4). G₂ Ge Gr G G₂ OU

A: Given data : The block diagram shown in below,

Q: Simplify the following block diagram. G1 G₁ H₁ H1 G4 GA H₂ H2 G3 G₁ G₂ G2

A: In this question,  We need to simply the given block diagram  We know  Transfer function of the…

Q: Q3/ For the circuit shown find (a) Equations for I and I₂ with respect to V₂ (b) The value of V₂/Vs…

A: Given figure,

Q: 03: (a) For the bandpass filter shown in Fig. Q3, calculate foff ₂ Q and B. (b) in the input voltage…

A:

Q: 2. A balanced 3-phase a-b-c system with line-to-line voltage Vab = 20820⁰ V supplies to a balanced A…

A:

Q: (a) Describe in diagrams the practical Analog filter specifications. (b) Explain the design process…

A: Given  The practical Analog filter specifications and the design process of digital filters are…

Q: tch 1 ++ Switch 2 Switch 3

A:

Q: Suppose that each diode in the circuit shown in figure 2 has a turn-on voltage of Vy= 0.7 volts.…

A: A conventional diode with a significantly greater maximum current rating is called a rectifier or…

Q: A continuous time signal for a duration of 4s is uniformly sampled without aliasing and generating a…

A: Analog signals are transformed into discrete signals by sampling. The sampling theorem states that…

Q: For a single-input, single-output (SISO) system with zero initial conditions, the output for a unit…

A: Transfer function is defined as the ratio of output to input in s domain with zero initial…

Q: Explain why control torque should be equal to deflection torque,happens if the control is more than…

A: The PMMC type instruments and indicating instruments consists 3 types of torque in their operation.…

Q: A three phase, 50 Hz, 8 pole alternator has a star connected winding with 120 slots and 6 conductor…

A: It is given that: f=50Hzp=8slots=120conductor per slot=6ϕpp=0.05for full pitched coil:kp=1

Q: Determine the diffusion constant of electrons and holes of a silicon single crystal at 27oC, if the…

A: It is given that: T=27°C=300Kμn=0.17m2/volt-secμp=0.025m2/volt-seck=1.38×10-23J/°C=Boltzmann's…

Q: Determine the breakdown voltage of air gaps 2mm 15 mm length under uniform field. Also determine the…

A: It is given that: d1=2 mm=0.2 cmd2=15 mm=1.5 cm

Q: Obtain the control word for the following configuration of the ports of 8255 for: Mode 0 operation…

A:

Q: Q4/ Find the input impedance (Zin) for the circuit shown below j252 Voltage source 5002 L₁ j1022 L₂…

A: Given data,

Q: A 480 kW, 50 Hz, 3.3 kV, eight-pole-pad wound-rotor induction motor has the following parameters…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: A separately-excited d.c. motor is supplied via a half-control full-wave single-phase rectifier…

A: Separately excited DC motor:-In this type of motor supply is given to field and armature winding…

Q: sed in saturation. 5) ...T

A:

Q: Problem 26 O 27. (11) Consider three capacitors, of capacitance 3100 pF, 5800 pF, and 0.0100 F. What…

A: This question belongs to circuit theory . It is based on the concept of equivalent capacitance .…

Q: T4. Daily load of an industry is 200 kW for first one hour, 150 kW for next seven hours, 50 kW for…

A: energy consumed = power * time in hours annual bill =cost on energy consumed plus cost on maximum…

Q: 2/ Find the transmission parameters for the two port network 54₁ 1₂ 1₁ 2002 www ww 30 Ω

A: Given data, Circuit diagram is given as,

Q: The Mesh loop for i2 in the S domain * is 4e-2t u(t) V 113 1002 4 H m i₂(1) 2e¹u(t) V

A: We need to find out loop equation for given circuit

Q: In RC circuit if R=2002 and C=50μF, then the time constant T for the circuit is * O 1μs 2μs 2ms 1ms

A: Given data, Resistance R=20 Ω Capacitance C=50 μF

Q: Find the current I if: V₁=2V, V₂=1.5 V, R₁=20 KM2, R₂-10 K and R3=5 KM. V₂ V₁ R₁ R₂ ww R3 R₂ R₁

A: Given data :

Q: Hiw long will it take 500watts motor to raise 1200n hammer of a pile driver 12m

A:

Q: An AM radio station using double side band transmitted carrier system employs a carrier of frequency…

A: Given, In an AM signal Carrier frequency, fc=2.1 MHz Modulating signal frequency, fm=4 kHz

Q: Find the voltage across a 5 µ? capacitor if the current through it is ? ? = 3e − 2000t?? Assume that…

A: Given data, Capacitance C=5 μF Current, i=3e-2000t

Q: tronic components definitions and si units and color coding

A: Electronic components : There are mainly two type of Electronic components one is active Electronic…

Q: What is the skin depth of free space

A:

Q: The variable resistor (R.) in the circuit in Fig. P4.88 is adjusted until it absorbs maximum power…

A: Given circuit diagram:

Q: a 50.9062 Cos (1-√3x) dx = ½ -0-1 a=0.5968 How?

A:

Q: To solve the circuits using Laplace Transform we follow the following procedure Simplify the…

A: We need to select the correct option for Laplace transform

Q: 5.6 The generalized circuit constants of a transmission line are A = 0.93 + j0.016 B = 20 + 140 The…

A: Given data : Parameters values of given transmission line is shown below,…

Q: LXI H 3140 is O Register Addressing Mode O Direct Addressing Mode O Implicit Addressing Mode O…

A: It is the various methods that a microprocessor uses to access data. The programmer must include the…

Q: 41) A logic gate draws 10mA when its output is HIGH and 20mA when its output is LOW. When operating…

A: Given data, When output is high current is 10 mA When output is low current is 20 mA Duty cycle D =…

Q: A balanced 3-phase delta connected load of 160 kW, connected to a balanced line voltage of 1100 V,…

A:

Q: For a filter works with high frequency 150KHz, the Vin is 25V and the resistor is 8.2KQ. Compute the…

A: The passive high pass filter can be with the help of capacitor and resistor. The capacitor will…

Q: Q3. Find the values of controller gain Ke that make the following feedback control system stable.…

A: Feedback control system: In this system, the feedback path is faded from the output to the input of…

Q: 5) The diode current given that n = 2, Is = 40 nA, VD=0.5 V with thermal voltage V₁ = 25.27 mV @ 20…

A: Given, The specification of a diode circuit are η=2Is=40 nAVD=0.5 VVT=25.27 mVT=20°C

Q: Q2/ Find the input impedance for the circuit below Zja 10 Ω j12 Ω j15 Ω 20 Ω j40 Ω -j5 Ω

A: Coupling : Coupling means mutual inductance between a coil  it is mainly of two types : electrical…

Q: point in spherical coordinate is located at (4, 30°, 80°) The distance of this point to a point (48,…

A: We need to find out distance between two points

Q: S.1.) The scalor electric potential V= x²y (2+3). (v) که in empty space is given E find and Pu?

A:

Q: Q1: (A) Compare between closed-loop and open-loop control systems, and give an example for each…

A: Control system is a very important element that is required in everyday life. Applying brakes in car…

Q: In a DC circuit, the inductor can be * replaced with a current source replaced with a voltage source…

A: We need to select correct option

Q: Consider the following T.F of a certain first order system: Gs = 10/(s+10). Drive an expression for…

A:

Q: What is the energy required to build up current of 1A in an inductor of 20 mH?

A: We need to find out energy of given inductor for given current

Q: Two lamps x and y are connected in series. Lamp X is rated 50 W at 100V while Lamp Y is rated 1000W…

A: The energy of light striking a surface of a given unit area per unit time is known as illumination.…

Q: Q1) For the two-port network shown in Figure (1) below, obtain the Y-Parameters and state whether…

A:

Q: Question: What would the pole pass frequency be for a AC induction moor running at 878 RPM? ( assume…

A: