Answer questions please In a thermal power plant, the Condenser isused toO a. Increase efficiencyO b. decrease efficiencyO c. constant powerO d. Increase frequency Thermal Power Plant is not good because itproducesa. less smokeO b. Nitrogenc. oxigenO d. Carbon di-oxide

1) Condenser Condenser is used to condense the exhaust steam from that turbine that is called steam…

Answered: In a thermal power plant, the Condenser…

Engineering

Electrical Engineering

In a thermal power plant, the Condenser is used to Increase efficiency

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter26: Three-phase Circuits

Section: Chapter Questions

Problem 3PA: You are an electrician working in an industrial plant. A 30-hp three-phase induction motor has a...

See similar textbooks

Related questions

Q: A two-level brightness intensity lamp circuit was made. A 12 W lamp was the load and the supply is s...

A: Given: A two-level brightness intensity lamp circuit was made. A 12 W lamp was the load and the supp...

Q: A set of 10 identical radiating point elements at d = 0.58 separated by a space if you know that the...

A: Group factor- Group Factor is an assumed value which shows that every element experience the same o...

Q: Determine the size of PV modules, inverter, battery and solar charge controller of a PV systems give...

A: Here, we have given some information about devices present in a house. We will first calculate the ...

Q: A manometer is attached to a water tank (s=1) as shown in the figure. Find the height of the free w...

Q: The diameter of an AWG no.4 conductor is defined to be 0.4600 inch. Stranded conductors of this size...

A: diameter, D=0.46 inchThe total cross sectional area will be accomodated by 19 strand eachof diameter...

Q: A 12 MVA, 132/6.6 kV, transformer having a reactance of 0.15 pu is fed from an infinite bus. The tra...

A: We will replace the components given in the circuit with per unit reactance respectively. The infini...

Q: Example: Find Thévenin's equivalent circuit between a &b for the network in Fig. 2.32. Then find the...

A: Here, we have given a electrical circuit having no. of resistors and a voltage source. One of these...

Q: 9. Concerning equivalent circuits; two 3.3 kOhm resistor are in parallel, in a box with two terminal...

Q: Give an example problem of base resistor biasing with their solution.

A: Method of the Base ResistorAs the name says, a high-resistance resistor RB is connected in the base ...

Q: D1 D2 AC D3 D4 R

A: Draw the waveform

Q: Find the equivalent resistance between terminal a and b in the circuit shown. All resistance has a v...

A: The circuit given is shown below:

Q: 1.Which is an appropriate light source? a. 2. Which device may suit the block for the photodiode? a....

A: Answer 1- Since photo diode absorbed the light emitted by the source ,here in the given options onl...

Q: A discrete-time causal signal x[n] has a z-transform as X(z) = (1+3z-2+ 2z-)sin-1(2). Find x[11]. 巴 ...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: Q4/ Use Source Conversion technique to find the load current IL in the circuit below. 2 IL R1 R2 R3 ...

A: Circuit is given as :

Q: G, R(s) C(s) G2 H2 H, G. (c)

Q: Consider the circuit shown below R Qn clock X S The circuit acts as (A) output remains stable at “O"...

Q: K(s+2) Consider the closed loop transfer function is, T (s) = +K 3 +2K 3 Calculate the value of K su...

A: It is given that: T(s)=Ks+2s2+2s+Ks+13+2K

Q: Answer the following questions What is the difference between an OP-AMP 741 and an LM386 What is...

A: Since you have asked multiple question, we will solve the first question for you. If you want any sp...

Q: You and a fellow engineer are asked to design a controller for an electromechanical system. After so...

A: Given, Engineers are designing a controller. After analysis, system finds to be uncontrollable. Sugg...

Q: The plane y = 3m contains a uniform charge distribution of density ps 108/67 ) C/m² . Determine E at...

A: Gven that uniform charge denisty ρs=10-86πCm2plan y=3cm

Q: Refer to the Graphic B. What is the current through R1? 5.34 mA O 2.73 mA 6.23 mA 3.90 mA None of th...

A: Option a 5.34 mA Ue basic ohms law Current = voltage / resistance Here current through R1 is the tot...

Q: At which cycle will the waveform be cut from the diagram above? a) positive cycle b) negative cycle ...

Q: 21.An echo from the sea-bed is received 2.00 s after an ultrasonic vibration is sent from a sonar on...

A: Given Echo received after t=2 second Speed of sound in water v=1500m/s Depth of sea d=?

Q: Fill in the blanks with the colors of the resistors corresponding to their values

A: The color-coding in the resistor is used to identify the value of the resistor along with the tolera...

Q: Q5. The diode is considered shorted when both anode and cathode has a) Low resistance b) High resist...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: x(t) -7 -6 -5 -3 -1 3 567 (a) calculate the exponential Fourier series of the signal x(t) (b) constr...

Q: 3. Determine Vo for each netuerk for the ilp shawn. Vi 3V Vig - 8v 2:2Ki si

A: Given: Input voltage shown, And a circuit To find: Output voltage

Q: (2) If open-loop differential voltage gain (Aol) = 3500 and the common-mode * gain (Acm) = 0.35, the...

A: Given, Open-loop differential voltage gain, Aol=3500 Common-mode gain, Acm=0.35

Q: (b) What is the voltage gain, Av of the CE stage if the second transistor has a current gain of 150?

A: Since you have asked multiple question ,we will slove the first question for you .If you want any sp...

Q: Consider the circuit in . 12Ω 12 V = 20 Ω 30 Ω

A: 20 ohm and 30 ohm are in parallel. Req= (20*30)/(20+30) =12 ohm The resultant equivalent resi...

Q: 34.A device produces 37.5 Joules per cycle. There is one power stroke per cycle. Calculate the power...

Q: In the figure two objects, 01 and 02, have charges +1.0 µC and -2.0 µC, respectively, and a third ob...

Q: At which voltage value will the axis of the output voltage settle? a) Ov b) -8V c) +8V d) -3V What i...

Q: Derive the expression for the first order system, when subjected to unit ramp input signal.

A: Considering a first order system The transfer function of the first order system is given below, Cs...

Q: Sensor Circuit Light Control Circuit Alam iir Photodiede Source Circult 1. Which device may suit the...

Q: Maxwell's equations

A: Maxwell's equation- ∇·E=ρs/ε Gauss's Law ∇·H=0 Gauss's Law of ma...

Q: 3Ω 42 40V I3 450 64V 22 1.50

Q: 3.48 Determine the current through the 10-kN resistor in the circuit of Fig. 3.93 using mesh analysi...

A: The solution is given below.

Q: In a three - phase balanced delta – delta system, the source has an abc – phase sequence. The line a...

A: The line impedance, Zl = 0.3 + j 0.2 Ω Load Impedance = ZAB...

Q: What are the functions of encoder, Decoder, multiplexers explain with truth table and give applicati...

A: FUNCTION OF ENCODER: It is a circuit that is used to convert the given data from one format to anoth...

Q: across the j16 2 j40 2 ணை j40 2 24 2 100 V/30° ( -jl Q j4 2 =-j82 -j10 2= j10 2 j9 2 10 Ω 32 8 Ω ll ...

A: Assume 100[30°] is a RMS Value.

Q: For the Depletion-type MOSFET network of the figure below: a. Sketch the AC equivalent circuit b. Sk...

Q: What are the functions of encoder, Decoder, multiplexers explain with truth table and give applicati...

A: In a communication process, various process takes place which needs some devices to perform those pr...

Q: D Question 3 Given a Two-Supply Emitter biased amplifier shown below, calculate the value of the ac ...

Q: 8.Determine the maximum shearing stress in a helical steel spring composed of 20 turns of 20mm diame...

Q: The phase b line voltage and phase a line current of a balanced three phase system are V = 220sin(wt...

Q: Give an example problem of base resistor biasing with their solution. w/ illustration

A: BIASING The process of biasing providing DC voltage which helps in the functioning of the circuit. ...

Q: 1. A current of 5 amperes enters a parallel combination of two unequal, unknown resistors (R1 and R2...

A: Given

Q: The voltages across two series-connected circuit elements are e1 = -20 sin (ωt - 2π/7) V and e2 = 12...

A: It is given that: e1=-20 sinωt-2π7 Ve2=12 cosωt+π4 V

Q: 14. what is the current through the 5V line? 5V O 50mA a 100 Ohm 80mA O 30mA 3 V 100 Ohm

Concept explainers

Three-Phase Transformers

Three-segment transformers are a type of transformer used to transform voltages of electrical systems into three ranges. Two type transformers are shell-type transformer and core type transformer. In brief, it could be described because of the exquisite kinds of configurations.

Transformer

Ever since electricity has been created, people have started using it in its entirety. We see many types of Transformers in the neighborhoods. Some are smaller in size and some are very large. They are used according to their requirements. Many of us have seen the electrical transformer but they do not know what work they are engaged in.

Question

Answer questions please

In a thermal power plant, the Condenser is
used to
O a. Increase efficiency
O b. decrease efficiency
O c. constant power
O d. Increase frequency

Thermal Power Plant is not good because it
produces
a. less smoke
O b. Nitrogen
c. oxigen
O d. Carbon di-oxide

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

III. Problem Solving. Compute up to FOUR decimal places. BOX your final answers (with units). 1. What is the equation of the waveform in figure 1? 2. A coil takes 15A from a 250V source. When a 20 Ohm resistor is connected across the coil. The combination draws a total current of 25A. Determine the resistance and inductive reactance of the coil. 3. In the single-phase power system in figure 2, determine the voltage, Vab, and current, I b, being received by the load, 10 +j15 N. V, volts 10 ms AV 100 V Figure 1 250 V 0, deg t, msec CS Scanned with CamScanner j8n 120280°V 12 j3N 252 M €150 121 j45 1 1.250 /150 2.5.2 b Figure 2 j6n j12A
Can V curve be plotted for an alternator. If yes then what is the difference between V curve of an alternator and V curve of a motor.
3- In a PWM, what should be the duty cycle to get a voltage output of 4.5 V?
You are an electrician working in an industrial plant. A 30-hp three-phase induction motor has a current draw of 36 amperes at full load. The motor is connected to a 480-volt line. A three-phase wattmeter indicates a true power of 22 kW. Determine the power factor of the motor and the amount of capacitance needed to correct the power factor to 95. Also determine the minimum voltage rating of the capacitors. The capacitors are to be connected in wye.
In electrodynamometer type wattmeter, to.............. in moving coil, a high resistance R is connected in series with it.
A single phase AC motor draws 4.5 A from 220 V electricity. Three various power of the motor from the mains is 720 W. a) Calculation of the power factor of the engine. b) Calculating the Capacitance (C) and Power of the capacitor required to make the power coefficient of the motor 0,95
The electro-dynamometer type wattmeter is shown below and assuming the diode to be ideal, the reading of the wattmeter is D₁ 200 V 401 AC, 50 Hz D₁₂ P.C elle C.C ieetieeee 2 A
In the three-phase alternator, explain why the voltage increases less rapidly as the DC current increases. please show your answer clean or readable. Thank you.
The maximum power that can be generated by a wind turbine is called Select one: O lock-in Power O Cut-in Power Rated Power O Cut-out Power
Question 4 a) B M Figure 4 Figure 4 shows the graph of the ripple current. Answer the following i. Describe the function of A. ii. iii. Describe the function of B. Identify the ideal paramater to get the good power supply.
1. Determine the peak voltage and the peak power delivered to R, in the following figure: 2:1 115 Vrms eeeee 00000 www RL 220 2
A 300 kw alternator has an efficiency of 90 % at full load . Calculate the power losses.