In a duct of uniform cross section only the dynamic pressure remain constant static pressure increase along the length the total pressure decrease along the length only static pressure remain constant

In a duct of uniform cross section only the dynamic pressure remain constant static pressure increase along the length the total pressure decrease along the length only static pressure remain constant

Name: bull-screenSnipIn a duct of uniform cross sectiononly the dynamic pre
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: bull-screenSnipIn a duct of uniform cross sectiononly the dynamic pressure remain constantstatic pressure increase along the lengththe total pressure decrease along the lengthonly static pressure remain constant

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The pressure of water flowing through a pipe is measured by the arrangement shown below. For the values given, calculate the pressure in the pipe. Po=30 kPa Air Pipe Waler 15°C Water hy = 50 cm 15°C L=6 cm h = 8 cm 4=6 cm Ciage fluid SG = 24
Water flows through a Venturi meter, as shown in the figure. The pressures of the water at locations a and b in the pipe support columns of water that differ in height by L = 12 in. The atmospheric pressure is 14.7 Ibf/in?, the specific volume of water is 0.01604 ft/lb, and the acceleration of gravity is g = 32.0 ft/s?. Patm = 14.7 Ibr/in.? g = 32.0 ft/s² Water v = 0.01604 ft/lb Determine the difference in pressure between points a and b, in Ibf/in2?. Does the pressure increase or decrease from point a to point b? Sten 1
Water flows through a Venturi meter, as shown in the figure. The pressures of the water at locations a and b in the pipe support columns of water that differ in height by L = 12 in. The atmospheric pressure is 14.7 Ibf/in?, the specific volume of water is 0.01604 ft3/lb, and the acceleration of gravity is g = 32.0 ft/s?. Patm = 14.7 Ibf/in.? g = 32.0 ft/s² Water v = 0.01604 ft³/lb Determine the difference in pressure between points a and b, in Ibf/in?. Does the pressure increase or decrease from point a to point b?
When there are only a few upstream calming distances available, the annular venturi meter is helpful for metering flows in pipe systems. The cylindrical component of the annular venturi meter is installed inside a pipe, as seen in the image. Between the upstream pipe and the area close to the cylindrical portion, the pressure differential is monitored. In the system, air flows under normal circumstances. 10 cm is the pipe's diameter. The interior pipe diameter to the diameter of the cylindrical portion is 0.8. Water pressure is measured to be off by 5 cm. Track down the system's volume flow rate. Assume the flow is constant, incompressible, and viscous, and that the velocity is distributed equally throughout the pipe sections. Utilize typical air conditions at 25 °C and 101 kPa.
A manometer is an accurate pressure measuring device that is used to measure low pressure in the pipes. Select one: O True O False In a flow channel, the density of fluid at entry is equal to the density of fluid at exit for a compressible fluid. Select one: O True O False 10bar = 1MN/m2 Select one: O True O False
(5) Pressure Cooker (6) Carburetor (7) Radiator of an automobile. 2. Convert the following reading of pressure to kPa, assuming that the barometer reads 760mm Hg. (1) 90cm Hg gauge (2) 40cm Hg vacuum (3) 1.2m H20 gauge 3. Five masses in a region where the acceleration due to gravity is 30, 5 ft/s are as follows: m, is-
You are being asked to determine the heights in tubes B and C (relative to z=0) given the following information: The specific weight of Air is Pair = 11.9N/m3 The specific weight of glycerine is Paiye = 12355N/m3 The specific weight of gasoline is Pgas = 6677N/m3 The gauge pressure at A is Pa = 1.6kPa The height of the tank of air is a = 1.7m The height of the tank of gasoline is y = 1.6m The height of the tank of glyercin is k = 0.95m A в с xm Air y m Gasoline k m Glycerin z = 0 As a HINT, you do not need to know the specific elevations of the tubes B and C entering their respective fluids, but you do need to account for this. Input the height the fluid rises in B to 2 decimal places here: (in metres) Input the height the fluid rises in C to 2 decimal places here: (in metres)
4. At the sea level of the standard atmosphere, the conditions are To =288 K. Po =101.3 kPa, and it is said that the air temperature decreases by 6.5 K at 1 km rise. At a height z above sea level, the atmospheric pressure is said to be determined from P=Po (To-alpha z / To )^ g /aR, alpha = 6.5 * 10 ^-3 K / m and R = 287J/kg* K. Find the boiling temperature of the water at the top of Hallasan Mountain, about 2000 m above sea level.
The surface tension of mercury is 480mN/m, the contact angle of mercury at rock surface is 160°. At reservoir condition, the oil-water interfacial tension is 30mN/m, the contact angle of oil-water- rock system is 139°, the density difference between water and oil is 0.4g/cm'.The median pressure on the mercury/air capillary pressure curve is 9.84 atm the threshold pressure for mercury is 2.1l1atm. Calculate: 1) The pressure difference between water phase and oil phase at reservoir conditions at the level where water saturation Sw-50%. 2) The minimum pressure required for water displacing oil at reservoir condition?
... P1 = 50 KPa P2 = 10 KPa 4m OIL 1.6m OIL In the figure, an orifice is locates in the partition wall so that it discharges oil (SG = 0.8) from left to right side of the room. The orifice %3D has a diameter of 100mm and is under the surface of oil, 4m from the surface on the left and 1.6m from the surface on the right. The surface at the left is under 50KPA of pressure and the surface at the right side is under 1OKPA of pressure. Determine the actual discharge in the orifice if C = 0.92 112.03 L/s B 87.63 L/s 95.25 L/s 103.07 L/s No Answer among the choices
Q1/ Why would a soap bubble have a relationship Where P internal pressure? P = while a small spherical droplet has the relationship : 20 2лRo P 40 r pлR² r 2×2лRo pлR²
Q1:-The gate AB as shown in fig.1 has long 1 m and wide 0.9 m.Find the force F on The gate AB and also find the centre of pressure X 8 m 3 m 1 m Oil A 1 m S=0.81 7 m B 50 Fig.1