In a DPCM system, the number of bits per sample is 7. How many levels are present in the quantizer?
Q: Draw the implementation of decoding of binary state 5, and binary state 3 for a 3- bit synchronous…
A: consider the given question;
Q: 2. How can a serial in/parallel out register be used as a serial in/serial out register?
A:
Q: Q7) Write the assembly language instructions required to convert negative numbers to positive…
A:
Q: Q6: How many bits are represented by each symbol in 64-QAM? Sketch a constellation diagram for 64-…
A: We are authorized to answer one question at a time, since you have not mentioned which question you…
Q: 3. What converts binary numbers to decimal numbers? 1. BCD to 7-segment Decoder 2. Encoder 3.…
A: BCD to 7-segment Decoder converts binary numbers into decimal numbers.
Q: Q- Design using BCD 7 Segment Decoder, the following mathematical set characters if you entered 3,…
A: For Led of that segment to ON we give 1 or +5 volt and for off 0 or ground. Taking all cathode…
Q: 1.If a PCM signal has a maximum PCM decimal code value of +31 and a -31, how many bits were used for…
A: PCM stands for pulse-code modulation. It is a digital representation technique for sampled analogue…
Q: 5 What is the conversion time for a 12-bit ADC with a clock frequency of 1 MHz?
A: The solution can be achieved as follows.
Q: Design a digital logic circuit that detect an error in the representation of an Odd decimal digit.…
A: BCD Binary coded Decimal (0-9)
Q: In a PCM system, the quantizer has 256 equal levels. How many bits per sample is present in the…
A: Given: In a pulse code modulated (PCM) system, the quantizer has 256 equal levels. The number of…
Q: In an M-ary 64-QAM digital system a) How many level does the system support? b) How many bits per…
A: QAM : quadrature amplitude modulation
Q: The size of the data bus of Intel Microprocessors vary between bit to _bit
A: Data bus is a bidirectional bus and it carries data from processor to other components that are…
Q: A special PCM system uses 12 bit word and 32 channels. Date is transmitted serially with no sync…
A: Given, PCM system has Number of bits per word (n) = 12 Number of channels (m) = 32 Time duration of…
Q: What is meant by 4 to 16-line decoder? Draw the block diagram of that decoder (Please don't show the…
A: As per bartleby guidelines we are supposed to answer only question as it is not a subpart, So I have…
Q: 3. Draw the block diagram of an 8255 PPI chip and describe its different programming modes.…
A: block diagram for 8255 PPI is as shown in figure below
Q: Convert given Binary Number to Decimal Number -1010.1011 Convert given Octal Number to Decimal…
A:
Q: TRUE OR FALSE: More than one output of a BCD-to-7 segment decoder/driver can be active at one time.
A: This BCD to seven segment decoder has four input lines (A, B, C, and D) and seven output lines (a,…
Q: What should be the value of the LCDM10 register (in hexadecimal format), if the A1 alphanumeric…
A: That is the embedded system.here we Directly write the value of LCDM10 register if number 6. Below…
Q: On the same fashion, describe the path followed by the value of INTERNAL SIGNAL towards P0.x (see…
A: Port 0 can be used as an input/output or a bidirectional data bus and lower order address for…
Q: How do you differentiate digital modulation from analog modulation?
A: A message signal is transferred from the sender to the receiver end. The signal is transmitted…
Q: In a PCM system, 8 bit uniform quantiser is used. How many quantizing levels will be present if the…
A: Given: In PCM system uniform quantizer is used having number of bits, n=8
Q: 24. a. The serial adder required six clock pulses to add two, three bit binary numbers. (True or…
A: This question is from the digital electronics.
Q: How many bits are needed to count up to 255 in binary?
A: From the counters in digital electronics
Q: What hex address will be decoded by the instruction OUT 6D, AL?
A: AL is the lower 8 bits OUT : Which output data from accumulator with 8 bit addresses Here the…
Q: Convert the given BCD number into decimal BCD 1010101001 Decimal b) Convert the given binary number…
A: 10102 = this will produce an error as it is decimal 1010 and not a valid BCD number BCD valid for…
Q: To convert from binary to an octal numbering systems, we easily group each ___ binary digits (or…
A: The solution is provided in the following section.
Q: What will be the BCD equivalent of decimal 15?
A:
Q: Explain in a few sentences how a 4-bit binary ripple counter works.
A: Let us assume Q3 be the MSB bit and Q0 be LSB bit. And the output is Q3Q2Q1Q0
Q: b) The number of addressed words in a ROM is determined from some fact. 92 × 8 ROM architecture…
A: According to the question, The number of address words in a ROM is determined by some fact. 92 X 8…
Q: Draw the decoder that generates a logic "1" for each of the input shown below
A: A decoder is a digital circuit which detects the presence of a specified combination of bits on…
Q: Load the number of ffh into the 'a' register and write the code that reduces the number in the 'a'…
A: Load the number of ffh into the 'a' register and write the code that reduces the number in the 'a'…
Q: The binary number 1010 0011 is an ?even or odd? number that has ?even or odd? parity?
A: If the number of ones are even then it is a even parity If the number of ones present in the…
Q: Q4. Suppose we receive a bit sequence: 00000 00100 11110 10000, and suppose a repetition code with 5…
A: In the received bit sequence a repetition code with 5 total bits and 1 data bit is used that implies…
Q: A multiplexer combines four 100 kbps channels using a time slot of 2 bits. The bit duration is 2 ms…
A: Multiplexer- It is a combinational circuit that selects several inputs and forwards them to a single…
Q: Convert decimal number 54.3125 to fixed point binary notation. How many bits are needed? Suppose…
A:
Q: The processor has performed the following addition operation: 0x01A0 + 0xC410 ------ 0xC5B0 What…
A: The signed 16-bit number in decimal can have either positive or negative sign. Let us consider for…
Q: true or false ?? an even two bit parity checker will output a parity error if data A=LOW data ,…
A: Given, An even two bit parity checker will output a parity error if data A=LOW, data B=HIGH, parity…
Q: Write verilog code for priority encoder.
A: Multiplexer is combinational Circuit that select one of its input to the output . The select line…
Q: Q.65 (i) How many 128x8 RAM chips are required to provide a memory capacity of 2048 bytes. (ii) How…
A: Solution !!
Q: Represent the BCD number 11101010 in Decimal, then convert the Decimal to Binary, and lastly convert…
A: The given BCD number 11101010 is represented in decimal is,…
Q: How many BCD code bits and how many straight binary bits would be required to represent the decimal…
A: we need to represent 34 into BCD code and straight binary.
Q: Convert the following Gray codes (1000)to binary?
A: In this question we will convert gray code to binary.... Note:- As per our guidelines , I will…
Q: In a multibyte addition program, when must you use the ADD instruction? When must you use the ADC…
A: In this question we will write about ADD and ADC instruction..
Q: In a PCM system, a uniform quantizer is used. It has 256 equal levels. What will be the number of…
A: Given information: The number of levels present in the uniform quantizer is L=256
Q: Q6) What is the smallest value ofn in linear block code with a minimum distance of three and a…
A:
In a DPCM system, the number of bits per sample is 7. How many levels are present in the quantizer?
Trending now
This is a popular solution!
Step by step
Solved in 2 steps
- In a PCM system, a uniform quantizer is used. It has 256 equal levels. What will be the number of bits transmitted per sample?What output does the following multiplexer output? Note: if a line is cut and a number is written, it shows how many bits or how many lines are there. The lines below are 4 bits.5. Which of the following statements is true ? 1.There are only Common Cathode displays. 2.There are only Common Anode displays 3.There are Common Cathode and Common Anode displays 6. What is the output when decimal numbers are converted into BCD switch when No. 6 is pressed ? 1. 1001 2. 0110 3. 1000 7. Construct a 4 -16 decoder using two pieces of IC74138.
- Convert the following numbers: 10101010 binary to hexadecimal Hexadecimal number BEAD to decimal Decimal number 129 to binary. Decimal 47802 to hexadecimal.In a PCM system, 128 levels are present in the uniform quantizer. How many bits per sample are transmitted?Which of the following is true about quantization? a. Actual quantization error is the same all throughout the process.b. The signal to noise ratio is the same all throughout the quantization process.c. The smaller the resolution the less quantization error is introducedd. All of the choices
- Write data flow verilog code for half adder.The numbers from 0-9 and a no characters is the Basic 1 digit seven segment display * .can show False True In a (CA) method of 7 segments, the anodes of all the LED segments are * "connected to the logic "O False True Some times may run out of pins on your Arduino board and need to not extend it * .with shift registers True False19) Consider a 6-bit ADC and full scale voltage measurement range of (0-59).The Resolution will be _________. 0.30 0.06 0.92 1.00
- A multiplexer a. Selects where data should be sent b. Selects one out of several data input lines c. Has a single input and converts it to a binary output d. Has a binary input and converts it to a single outputWrite a program in assembly language to toggle PORTB 400 times. Use BNZ instruction.Q3) A - Convert the Excess-3 to binary number : ( 110001011100.10001010)ex-3 B- convert each Gray code to binary: 1-( 011010001001)G 2-(59)D