If the volume used to make 100 mL of std 1 is 2 uL what is the concentration in M used to make std calibration curve ? The standards are going to be used to build calibration curve to analyze caffeine in an energy drink. if 500 mL of the energy drink has target of 400 mg , how will you prepare the sample if you need 10 mL for the analysis ?

Q: d) The following data was obtained from the determination of lead, Pb in a wastewater sample. Four…

A: The solution is attached below-

Q: 7. За. 10 L%3D 8.6000 ml = ml ml

A: Given : We have to convert L to mL, ml to L and L to ml

Q: Table 2. Multiple Extraction of Caffeine Percent Caffeine (%w/w) Trial No. Mass Sample (g) Mass…

A: Percentage by weight %w/w     %w/w=Mass of component Mass of same×100%Then,Trial No.1-…

Q: A. Standardization of Sodium Hydroxide (NaOH) Solution 3 Trial 1 126.2 125.7 512 264mL Trial 2 Trial…

A: #B: analysis of an unknown acid: We have to use the molarity of the standardized NaOH obtained in…

Q: Styles Editi Please calculate the final maltose concentrations for the tubes you created today.…

A: To Calculate the maltose concentration in diluted solution , we would use given equation.

Q: Cu Absorbance 1 Absorbance 2 Absorbance 3 Mean + SD standard (ppm) 0.0522 0.1013 1 0.0521 0.0520…

A: To determine the concentration of metal in unknown sample, we must first plot the mean absorbance (y…

Q: Protocol: You are provided with a suspension of (outdated) human RBCS and 1M NaCl solution.…

A: To calculate the volume of 1 M NaOH and water need to make these six solutions, we would use…

Q: fn control option command MODULE Science 7 in your notebook. GIASU: mulov solution that is 2% boric…

A: Calculation of above questions is given below.

Q: 1000 mL of 0.45% NaCl IV for 6.5 hours Drop factor: 60 gtt/mL Flow rate: ________ gtt/min

A: IV flow rate An IV flow rate is a way of describing the rate of an intravenous infusion based on the…

Q: 1. Replicate water samples are analyzed for water hardness with the following results: 102.2, 102.8,…

A: Q1) # Hardness ppm Deviation from mean Square of deviation 1 102.2 0.4 0.16 2 102.8 0.2 0.04…

Q: A pharmaceutical company produces caffeine pills that are each supposed to contain 200 mg of…

A:

Q: determine the organic material in a dried lake bed, the percent carbon by mass is measured at two…

A: Given that  the percent carbon by mass is measured at two different locations

Q: he concentration of caffeine in an energy soft drink was determined by standard addtion using MPLC…

A:

Q: Table I: Calibration of dropper: UMCO2/drop Trial # of drops Average ml/drop (ml/drop x 10UMCO/ml)…

A: How to find the average no of drops? Average no of drops  = Sum of all no of drops in each…

Q: Table I Char les Law Cras Data Tompirature k Ualumalmill 100 15k 10 Cm 2. 3. 152. 15 k 166-15 K…

A: Charles Law explains the direct relationship between the temperature and volume of a gas. According…

Q: (a) (Apply fractions as (b) (Use the lowest pos (c) (Apply fractions as r

A: According to the question, we need to write the balanced formation equation at standard conditions…

Q: A tank initially holds 100 gal of a brine solution containing 20 Ib of salt. At t=0, fresh water is…

A: ​Let Q be the amount of salt in the tank, dQ/dt ​ be the rate of change of amount in tank.  We get…

Q: In a recrystallization of a mixture of adipic acid and salicylic acid, the melting point of crop G…

A: The equilibrium associated with the phase conversion of liquid to solid along with the liberation of…

Q: 1. Samples that should not be stored should be prepared/analyzed as soon as possible, especially for…

A: 1. Answer - The correct option is (c) Conductivity According to the question -  Samples that should…

Q: Replicate water samples are analyzed for water hardness with the following results: 102.2, 102.8,…

A:

Q: The gravimetric factor used to express CoCBr6·H20 in a sample that is finally weighed as PbClBr is…

A: Gravimetric factor

Q: An analysis of city drinking water for total hardness was done by two students in the laboratory and…

A: We are given data : For student A:  228.3, 226.4, 226.9, 227.1, and 228.6.  And For student B:…

Q: Is this calculation correct? See image below....

A: The calculation is correct.

Q: An analysis of city drinking water for total hardness was done by two students in the laboratory and…

A: Note: Since  you have posted question with multiple parts, we will solve only first part for you. To…

Q: Observations: Burette Reading (ml) Normality of a520 solution (N) Volume of NaSy02 soution (m)…

A: The amount of oxygen present in one liter of water in a dissolved state is called dissolved oxygen.…

Q: tudent needs 25.0 mL of 9.60x10 e No. 6 stock solution to work with, how much of the 2.00 mM…

A: Formula used  M1V1 = M2V2  where M= Molarity and V= volume

Q: Pre-lab: Experiment 6 All Sections 1. Define the following terms: Surface tension Viscosity Freezing…

A:

Q: -). A new procedure for determining cholesterol in blood serum was used with a NIST standard sample…

A:

Q: 1. Standardization of Sodium Hydroxide Primary Standard used: Formula Mass of Primary Standard: %…

A: In the given question we have to do the standardization of NaOH and to calculate the required NaOH…

Q: Univers X Rb Homework Assignments -Fall 20 X Chapter 1 + GA pool is 39.0 X long and 48.0 m X…

A: The depth of pool in terms of meters is calculated as,

Q: Concentration 3006 2901 2892 Absorbance std 0.540 0.540 0.540 Absorbance sx 0.555 0.526 0.540 100.3…

A: Here for calculation of % potency one has to put all required data on that formula and compute .

Q: Volumetric Target concentration Mass of mixture Amount of ammonia flask added required 0.43 gl)…

A:

Q: The student collected the following data he prepared solutions ranging from 0.000 to 0.500 ppm and…

A: We have to find first equation for given points and then we have to find amount of unknown using…

Q: An order was given to initially infuse 10000. units per hour of the anticoagulant heparin for a…

A: As 1 mL solutions contain 100 units and in 1 hour 10000 units are required. Hence, the number of  mL…

Q: by 3. Nicotine is a weak base samples of a nicotine solution are titrated with 0.00526 M…

A: The question is based on the concept of titrations. we are titrating a  nicotinic acid ( weak base)…

Q: Estimate the value of the equilibrium constant Kc for the reaction below from the data in the graph.…

A: Given,[O2] = 0.750M[NO2] = 0.600M[NO] = 0.400M

Q: Please provide a detailed solution for the following question You have constructed a standard curve…

A:

Q: PLEASE ANSWER ALL THE ITEMS. WILL GIVE YOU THUMBS UP AND GOOD RATING TRUE OR FALSE 1. The specific…

A: 1. The specific gravity bottle method can be used for both liquid and solid state. : True 2. The…

Q: Environmental chemistry question. Please answer with steps/details both questions 1) The National…

A: Note: As it is a multiple independent questions ,the solution to only first question is provided.If…

Q: Volume Measurements (procedure) The small white cup is filled to the lid with water. The volume of…

A:

Q: Two methods were used to measure the arsenic level (ppb) in drinking water. Quantity Mean arsenic…

A: First, we need to calculate the F value and T-value, and compare the standard deviations for the two…

Q: A method for the determination of the corticosteroid methylprednisolone acetate in solutions…

A: Given: mean value = 3.7 mg mL-1 standard deviation s = 0.3 mg mL-1  formula to find samples n = Zα2…

Q: Q2: Use any of the following chemicals and equipment's and designs a suitable experimental procedure…

A: Detailed procedure and extraction technique in the below notes. 1) Oxidation of cyclohexanol to form…

Q: Active Raw Materials Actual Yield Formulation Dosage Form Packaging Ingredient Potassium 3 kgs.…

A:

Q: a. Convert 52.6 mM (millimolar) to μM (micromolar) and to M (molar). b. Convert 200.0 μM to mM…

A:

Q: Questions and Problems Q.4 An IV pump delivers the following volume of saline solution over 4 hours.…

A:

Q: 1000 mL of 0.45% NaCl IV for 3 hours Drop factor: 20 gtt/mL Flow rate: ________ gtt/min

A:

Q: Location 2 To determine the organic material in a dried lake bed, the percent carbon by mass is…

A: As per our company guidelines we are supposed to answer first three sub-parts only. Kindly repost…

Q: Q)What is used for heating small amounts of solids at a high temperature? a) Mortar and pestle b)…

A: Q)What is used for heating small amounts of solids at a high temperature? a) Mortar and pestle b)…