I need answer ASAP. Thank you! Given: RD = 2kohm , Rs = 0.51kohm , RG = 1Mohm and VDD = 18V            Gate junction saturation current= 6 mA and VTO = -4 V A.) Find the value of drain current and gate current. B.) What type of JFET DC biasing is this? C.) Find the Drain voltage, Emitter Voltage and Gate Voltage.

Q: Unless given, use the: POLAR FORM for voltage and current, RECTANGULAR FORM for impedance. (30pts)…

A:

Q: What is the radius of a copper cable having resistance of 10 ohm and length of 10 km. Assume the…

A: Given data, R=10 ΩL=10 kmρ=1.7×10-8 Ωm

Q: A capacitor made of 130 plates in parallel is separated by a 0.0297 m thick of insulator with a…

A:

Q: (a) Sketch the graph of the given function. 1, f(t) = = { von 0 < t < 2 e-(-2), t≥2 f(t) 5 √

A: (a) The given function is shown below:  f(t)=1     0≤t&lt;2e-(t-2) t≥2 For 0≤t&lt;2, the function is…

Q: 4. Design equation F(A,B,C,D)=E(1,2,3,6,8,10,12,13,15) using a 4×1 Mux?

A: Given data : Boolean function FA,B,C,D=∑m1,2,3,6,8,10,12,13,15

Q: 7. A dc electric motor consumes 36 MJ when con- nected to a 250 V supply for 1 hour. Find the power…

A:

Q: In the Y-A system shown in figure below, the source is a positive sequence with Van = 24020° V and…

A:

Q: For a H bridge converter with given spesifications find the following by hand Vin = 240V (DC) f =…

A: H bridge is nothing but half bridge which transfer the DC to AC. There are  two switches and 3 wired…

Q: A bandpass filter can be created when a when output of a low pass filter is fed to the input of a…

A: A band pass filter can be formed by simply cascading high pass and low pass filters. The order of…

Q: What is the SOP function for inputs A=1 B=0 C=1?

A: In the given problem three inputs are given so that eight combinations are possible.

Q: (c.) Determine the core loss when the transformer is connected to a 4700 (primary) volt 60 cycle…

A: Given: A 60 kVA 4800/460 volt, 60 cycles, distribution transformer has the following resistance and…

Q: Electrical Engineering Draw waveforms (Vin, Vo, Ig) for single phase full wave controlled rectifier…

A: Rectifier: A rectifier is an electronic and electrical device that converts using a P-N junction…

Q: Exercice: The circuit in the figure shows a symmetrical load connected in a triangle, whose branch…

A:

Q: Three single phase transformers, each rated at 12kVA, 120/240V, 60Hz, are connected to form a…

A: Given data : Each rating of transformer =12 KVA Power factor =0.8 lagging

Q: 4 A capacitor has 0.035 * 0.035 m parallel plates. The distance between the plates is 0.092 m in…

A:

Q: Derive the operating point ,Q-pt.,  of the BJT voltage-divider bias circuit shown using Approximate…

A: It is given that: Required: Q-point or Operating point.

Q: Give the color bands of the following resistors with 10% tolerance:  1. 1k Ohms 2. 220 Ohms 3. 1.5…

A: As per the guidelines of Bartleby we supposed to answer first three subpart only for solution of…

Q: The Thevenin impedance of a source is ZTh = 120+ j 590, while the Thevenin voltage is VTh=327 + j265…

A: Maximum power: It states that maximum power transfer only possible when the load resistance is equal…

Q: Use Norton to solve for the current and voltage at 10 ohm resistor. 1 2012 2 10 52 3 120 V 40 52 3 A…

A:

Q: A 0.4-mF capacitor has a charge of 20 mC. How much is the voltage across it?

A:

Q: Calculate the ripple voltage for a full-wave rectifier @120 Hz with a 45.03 uF filter capacitor…

A: In this question we will find ripple voltage for full wave rectifier....

Q: A pressure measuring device indicates 13 psi which actually has the true value as 11 psi. The…

A: Given, Measured value of pressure, Pm=13 psi True value of pressure, Pt=11 psi

Q: 1. Briefly explain how boundary scan testing can check PCB traces.

A: As per the Bartleby guidelines “Since you have asked multiple question, we will solve the first…

Q: Two point charges of 318 statcoulomb and 414 statcoulomb are 6.8 cm apart. A point between the…

A:

Q: Use Thevenin Theorem to solve for the current and voltage at the 40 ohm resistor. 20 Ω 1 10 ΩΣ 3 2…

A: Given:

Q: Find the values of M and fv so that the response has an overshoot of 17 percent and a settling time…

A: It is given that: %Mp=17%Ts=10 secK=1ft=ut

Q: Find the percent overshoot, settling time, rise time, and peak time for 14.145 T (s):…

A: calculation of percentage overshoot, settling time, rise time, and peak time for the given transfer…

Q: Q3. A 120V, 60Hz, 6-poles, V-connected three-phase induction motor has the following parameters per…

A:

Q: W R₁

A: The given differential op-amp is shown below:  Since the op-amp is ideal, the voltage at the…

Q: Find the inverse Laplace Transform of the following functions:  F(s)=5s/((s+7)(s^2 +4))

A:

Q: Find vo(t) in the circuit of Fig. 16.54 if v (0) = 2 V and i(0) = 1 A. +Vx- 1 F 1 H Vo ¹u(t) A 192…

A:

Q: What type of RCCB's we must use in AC Circuits? Can we use RCCB in DC circuits? Why?

A: RCCB- It is a protection device used in protection of electricity system. It is residual current…

Q: What are the reasons for hotspot and cracks in solar panel. please solve step by step

A: In the face of expensive and rapidly diminishing energy sources, solar panels and their components…

Q: An AC bridge is supplied with a source of 10 kHz as shown in figure 1. If Z, is a parallel…

A:

Q: Find the power supplied and average power absorbed or supplied by each element. Identify if the…

A: Power is delivered by current or voltage source and power is absorbed by resistance  power =…

Q: compare a half wave bridge rectifier with a reversed diode and a non-reversed diode.

A: Given: Half wave bridge rectifier with a reversed diode and non-reversed diode

Q: 3^² Find the current at 41 in the ff circuit. 145 7 564 45 100V a) Use 67 Use MESH Kirchhoff • USC…

A:

Q: Determine the value of the resistances based on band colors: A. Green, Blue, Black, Orange Pink, Red…

A: Determine the value of resistances base on band colors : A.  Green,  Blue, Black , Orange Pink,…

Q: What is the voltage gain of a noninverting op amp with R1 = 1 kΩ and Rf = 10 KΩ if the input voltage…

A:

Q: Find dx/dt for the following signal x(t) = u(t-2) - 3u(t-4)

A:

Q: Diagram of the problem, necessary formulas, clearance and numerical solution. A steady current of…

A:

Q: Using Mesh analysis, find the power consumed by each resistor and the voltages at each resistor. 292…

A: In this question,  We need to determine the voltage across the each resistance and power in it?  We…

Q: A metal bar is 2 m long and 8 mm in diameter. Calculate its resistance if the resistivity of the…

A:

Q: Study the following circuit. X(0) X(1) D Q 11 1 1 0 0 X(2) OO A B Circuit A X X(3) D Q CLK The truth…

A: using given truth table for circuit A and the D flip-flopswe will try to get output for next clock…

Q: For a given inverter with 1.2 pF load, the measured propagation delay times tPLH and tPHL are 9 ns…

A: In a ring oscillator odd number of inverters are connected in series with the positive feedback .…

Q: Determine the total charge On line O < x < 5 m if = 12x 2 mC/m 2 On the cylinder p = 3, 0 < z < 4 m…

A: When an object consists of more protons than other objects then then the object is said to be…

Q: nd the currents and the voltages in the circuit shown below i₁ 8 Ω 13 α V + 30 V + V2 www dis 3Ω Vg…

A:

Q: Show solutins please. 1. In simple circuit, if emf is 24v, internal resistance is 2 ohms, and load…

A:

Q: Question 3 A full load input power is 20 hp, 250V, shunt generator has R₁ 0.12 and R-100 2. This…

A: Given shunt generator full load input power = Pin =  20hp = 20×746 = 14920 = 14.92 kW Armature…

Q: Sketch and label carefully each of the following signals: (a) x[n- 4] (d) x[3n + 1] (b) x[3-n] (e)…

A: Since you have asked multiple questions in a single request, we will be answering only the first…