How exactly does Direct Mapping work? It is what?

Q: A line was recorded as 2350.00 meters long. The standard tape weighs 0.65 kg, 30.00m long at 20°C…

A: Given Data The length of the tape is 30 m Weight of the tape is 0.65 kg Pull in the tape is 50 N…

Q: is held at each stake. The stadia intercept at each station of the rod is observed as follows:…

A: GIVEN,  total length of line = 150 m each interval length = 30 m C = 0.3 K to be calculated stadia…

Q: uring a series of tape measurements of a line, following values were determined: 887.57 m, 87.42 m,…

A: During a series of tape measurements of a line, following values determined. S.no Measured length…

Q: Q- Water flows through a pipe having an inner radius of 10 mm at the rate of 36 kg/hr at 25° C. The…

A: given- inner radius R=10 mm=0.01 m, m=36 kg/hr=0.01 kg/s,density =1000 kg/m3,μ=0.001 kg/m.s,

Q: A pulse-jet baghouse is to he designed to filter the air of Problem 6.5. Calculate the number of…

A: Given Data Air to be filtered is given as 20000 cfm Cleaning time is 3 minutes  Filtration time is…

Q: The Resultant of the concurrent forces in the figure below is R = 201 N. pointing up along y-axis.…

A: The components of a force can be seen with horizontal and vertical change when looking at the…

Q: Q/ It is required to install two points A & B, the horizontal distance between them is 1200 meters…

A: Given  Horizontal distance between two points= 1200 m

Q: 2-139. Water in the container is originally at a height of h = 3 ft. If a block having a specific…

A: Given : Height of water in container = 3m specific weight of block = 50 lb/ft3 Base of block = 1 ft…

Q: Q3/The preliminary azimuths and observed lengths for the traverse ABCDEA are listed in the Table…

A: Required :- a) Compute the latitude and departures. b) Determine the linear error of closure and the…

Q: Solve for the reactions and draw the shear and moment diagram. 9.35KN/m 2.00 5.00 116KN 9.35KN/m…

A:

Q: homogeneous disk of mass m= 9 kg rotates at the constant rate w₁ = 12 rad/s with respect to nstant…

A: given:mass of disk m=9kgangular velocity ω=12 rad/sabout y axis angular velocity ω2=4 rad/s

Q: Find D1, D2, D3, D4, DS & D6 using stiffness merhed

A:

Q: 3. The body on the 30° incline is acted upon by a force P inclined at 20° with the horizontal as…

A:

Q: Determine the slope at pe thod of virtual work.

A: degree of static indeterminacy = no. of unknown reactions - no. of equilibrium equations Ds = 2 -2 =…

Q: Compute the value of the following for the beam shown: (EI is constant.) a. Slope A b. Deflection Ap…

A:

Q: e line of action is inclin ss at mid-span and lo

A: we will resolve the force along x any y-axis and then find the bending moment,   to find  maximum…

Q: 2. A sensitive volcanic clay soil was tested in the laboratory and found to have the following…

A:

Q: TWO Parallel t 350 m. DIF the с parallel tang (2) Compute What is

A:

Q: am A. w/r P D Beam B 7777 Ka What is the difference between Beam A and B what are the equations for…

A: The both beams have hinged support on LHS and roller support on RHS.The span of both beam is L.

Q: Provide your answer in terms of symbols (for example, sw or ce). If the soil is poorly-graded, there…

A: Given, Particle size distribution curve LL = 36% PL = 27%

Q: 1. WHAT IS THE AREA OF A REGULAR PENTAGONAL FIELD (IN m^2) IF ONE SIDE OF THE PENTAGON IS 2000 FEET.…

A:

Q: determine the new level h of the water.

A: This question is from buoyancy topic of civil engineering.

Q: A toll road with three toll booths has an average arrival rate of 850 veh/h and drivers take an…

A: We need to consider two cases: Case 1 is that three toll booths are open case 2 is that the fourth…

Q: Solve for the support forces and draw the shear force and bending force Q and M L1 = 4m L2 = 5m a =…

A:

Q: Using Double Integration Method derive an expression for the following: a) Reaction at propped…

A:

Q: 3. THE PACE OF AN ENGINEER IS 0.68m/pace. HE WALKS ALONG THE PERIMETER OF A TRIANGULAR LOT ABC AND…

A: GIVEN: THE PACE OF AN ENGINEER IS 0.68m/pace. HE WALKS ALONG THE PERIMETER OF A TRIANGULAR LOT ABC…

Q: 4 k 30° 8 k A " Ꭰ -6 ft- 4 ft 2 ft 15 k. ft B 5 Assume Pin/Internal Hinge at D ^_^ 12 k 4 8 ft8 ft-8…

A: Given data  Find support reaction and draw shear force and moment diagram.

Q: Calculate the maximum positive moment in the beam in kN.m

A:

Q: oration rates are very high in Palm Springs, it is likely they will need to pump a lot of…

A: Given data,    Area of Pond, A  = 40000 ft2 = 3716.12 m2 average discharge from the creek into the…

Q: Estimate area of a circle with R = 1m using finite element method concept using upper bound approach…

A:

Q: Fx F₁ e I+Y mine the x-component of the resultan low. F1 = 254 KN, 01 560 F2312 = 30°. Write…

A:

Q: Q-A thin walled spherical shell is subjected to an internal pressure. If the radius of the shell is…

A: Given: A thin walled spherical shell is subjected to an internal pressure. The radius of the shell…

Q: Q1) The wall is 12-ft high and consists of 2 x 4 studs. On each side is acoustical fiberboard and…

A: Given, Height of wall =12 ft 2x4 studs on each side 4 in clay brick

Q: A man exerted a force of 60 lbs at B as shown in the figure. 1. Compute the angle, theta in…

A:

Q: The following data were obtained by stadia observations: vertical angle = +7°55’, upper stadia hair…

A:

Q: A propped 6 m long cantilever beam is shown in Figure 3. In addition to a saw-tooth loading as shown…

A: Given  clockwise moment is applied at B = 10 KN-m

Q: Problem 1 Based on the following survey data an angle is measured repeatedly using the same…

A:

Q: Q.21 A shaft is made up of partly solid section and partly hollow section as shown as figure. b b…

A:

Q: An open-ended steel barrel of 1 m height and 1 m diameter is filled with saturated fine sand having…

A: Given data- Height h =1 m, Diameter D = 1 m, Coefficient of permeability- k=10-2 m/s, Drop in water…

Q: Using Double Integration Method derive an expression for the following: a) Reaction at propped…

A:

Q: #1 Draw the shear and moment diagrams for the beam. P₁ P₂ A 6 ft- -4 ft 200 lb B D -4 ft-6 ft- 2 ft…

A: First calculate the reaction forces at A and B using equilibrium equations. Then SFD and BMD can be…

Q: Situation 4. At a certain time during a hurricane, the wind pressure acting on the wall of a…

A:

Q: Using double integration method determine the value of end shears, end moments and mid-span…

A:

Q: (c) Two reservoirs with 20 m difference in their water levels are connected by a 300 mm diameter…

A:

Q: A sewer has a diameter of 300 mm and slope of 1 in 400. While running full it has a mean velocity of…

A: given- dia d=300 mm,slope=1 in 400,running full.v=0.7 m/s,d'=600 mm,slope 1 in 200,half full.

Q: A 0.5 x 0.5m square concrete pile is to be driven in a homogeneous clayey soil having undrained…

A: given- 0.5 m×0.5 m,Cu=50 kPa,g=18 kN/m3,design capacity=500 kN,α=0.75.FOS=2.

Q: 42.56 Not found in the list 20 kN/m W 60 kN/m 306.54 309.51 287.94 332.79 10 kN/m 2.0m Not in the…

A:

Q: Situation 1: A concrete overhang beam with the section shown is to support a 150 mm thick concrete…

A: As per Bartleby's guidelines we are supposed to answer only first question. Kindly repost other…

Q: Select the correct statement about the elevation. Elevation is the same as the ellipsoid height.…

A: leveling:- The purpose of leveling is to verify or measure the height of specified points with…

Q: Determine the correct length of a line 256.32 m long measured using a 50 m steel tape at  30°C. The…

A: Given data  Length of measured line (L) = 256.32 m  Length of steel tape (l) = 50m Temperature at…