How can I implement 4035 ic as a parallel input and serial output?

Q: What will be the binary representation of 66 DEC in BCD coding system

A: Given: Decimal number 66

Q: Compare between SUB & CMP instructions

A: “Since you have asked multiple questions, we will solve one question for you. If you want any…

Q: xplain the role of stack register in 8086 microprocessor. Subject is Introduction to Embedded…

A: Use of stack register in 8086 microprocessor :-  A stack register is used to hold the information…

Q: Q2: Explain the role of Stack Register in 8086 Microprocessor.

A: the registers are used to store information in the microprocessor.

Q: Below is an NMOS logic circuit. For all of the MOSFETS assume V = 1 V and k = 50 mA/V². th 5V c.…

A:

Q: Discuss transistor logic in your own words

A:

Q: Question: Q) Interface An 8086 Microprocessor With Total Memory Size 128KB Using RAM Chip .Size...

A: Size of each RAM chip is 4k × 8.

Q: 4. Write assembly instructions for an 8086 processers to add two hexadecimal numbers. Explain how…

A: The above question is related to the Assembly language programming of 8086 microprocessor. 8086 is a…

Q: Q2. Write an 8086 assembly program to exchange data between two memory locations. The first location…

A: Program to exchange data between two memory locations:

Q: Draw the logic diagram and transistor implementation for a (2-2-2) AOI.

A: The logic diagram can be implemented as,

Q: Suppose the waveforms iare those of an ECL gate with VL = −2.6 V andVH = −0.6 V, and t1 = 100 ns, t2…

A: The ∆V is the difference between VH and VL: Thus, the value of V90% and V10% are respectively:

Q: Match the following A B digital instruments amplifier Choose. amplifier Please answer all par…

A: There are two types of instruments available in the market Analog instrument Digital Instrument

Q: Q3) Explain the function of the LOOP instruction and write a small program using it (different from…

A: LOOP instruction is used to perfom repetitive sequence for specific number of times

Q: Include memory elements and combinational circuit Integrated circuit O Sequential network…

A: Given: Combinational circuit

Q: Write an 8088/8086 assembly program that counts the length of a null terminated string that starts…

A: Microprocessor Programming : The "jargon" of directions which a specific microchip chip has is…

Q: :) A (4-bit) binary counter is connected with DAC to generate a Saw tooth Signal with Frequency of…

A: Given data : Number of bit n=4 Saw tooth signal frequency = 10kHz

Q: 4 RESET is an 5- Address lines of 8086/8088 are (input, output) signal for the 8086/8088. type,…

A: Fill in the blanks for questions 4&5 ?

Q: 3. Draw a block diagram of Execution and Bus interface units of 8086 microprocessors.

A:

Q: 1. Provide a block diagram and a function table for the NOR-Gate Latch. 2. Describe, with the aid of…

A:

Q: a. Design 4-bit Parallel in Serial out (PISO) shift register.

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Draw 8259A interfacing connections with 8086 at the address 0744H.

A: The 8259A interfacing connection with 8086 at address 0744h is shown below:

Q: How do I create a 4 input NAND gate?

A: The solution is given below

Q: 4) Design and draw these memory units with their control circuits. Explain operations. a) A single…

A: As per the rules we can answer only one question, please post the remaining questions as the…

Q: Draw the circuit schematic for a three-input CML XOR gate.

A: Given: The three-input CML XOR gate circuit diagram is shown as:

Q: A 5-bit ADC has the following reference values Vref = -2V and 12 V.  What is the voltage represented…

A: GIVEN Vref = -2V and 12 V sequence =01010 n=5 bit

Q: Explain ARM Cortex M4 controller (STM32F407) and compare ARM Cortex processors, e.g. M0,M1,M2,M3,M4…

A: ARM Cortex M4 controller (STM32F407) can be defined based on certain characteristics, these are…

Q: Describe TWO (2) advantages of DIGITAL over to ANALOG in data storage field.

A:

Q: What is direct mapping in Cache. What is cache miss and cache hit condition.

A: Direct Mapping Consider that the direct mapping is the process that is used to assign the memory…

Q: What is the step size for a 32 V range, 5 bit digit?

A: Given, Dynamic range (DR) = 32 V Number of bits for each level (n) = 5 Step size=?

Q: what is the advantages of memory segment.

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: Differentiate between decoding logic for an active-HIGH output and an active-LOW output

A: According to the question we have to explain about,  Differentiate between decoding logic for an…

Q: In IC 74153,the input at pin number 14 is Options A-Connected to ground B-Connected to power/VCC…

A: IC 74153 has two 4-by-1 multiplexers in it. A multiplexer has four inputs for input data, 2 lines…

Q: Explain the program memory structure of 8051 microcontroller.

A: 8051 microcontroller is designed in the year of 1981 by INTEL. It is an 8-bit microcontroller, have…

Q: naamentals Of Digital Electronics / My courses/EETE2270/ SECTION ASSESSMENTS / Theory Quiz-02 (sec…

A: Need to solve for both question

Q: Which one of the following offers CPUS as integrated memory or peripheral interfaces? a)…

A: Microprocessors and microcontrollers are extensively used commercially nowadays.

Q: The instruction queue in the 8086 MPU is of .....*.

A: Given: How many instruction bytes used in MPU 8086 is shown as:

Q: Q: State the differences in transfer operation between 8086 & 8088 MP when executing the instruction…

A:

Q: A memory chip from a digital camera has 25 bistable (ON-OFF) memory elements. What is the total…

A: Given: Find the total number of ON-OFF configuration

Q: ICs 74LS is categorized as O a. Low voltage TTL O b. Low Power CMOS O c. Low power TTL O d. Low…

A: Given IC 74LS belongs to which category

Q: Assume that you have an 8-bit ADC with Vref = 5 Volts. If the input voltage is 3.5 Volts, what is…

A:

Q: For the 8085 microprocessor, the instruction (MVI B, 8-bit data) requires Fetch and Read machine…

A: The solution can be achieved as follows.

Q: CMOS ICS with a prefix 74 series are used for .... O a. security O b. military O c. commercial O d.…

A: The CMOS ICs of 74 series logic family are used for commercial operating temperature range

Q: Compare the maximum conversion times of a 8-bit digital-ram p ADC and a 8-bit successive-…

A:

Q: 1. Draw the programming model of 8086 Microprocessor Note: Please do not handwritten.

A: