Given: RG 1Mega VG OV IG=0A RD 50k Vps oss = 180 μA Vp=-1.6 V GS lo-loss(1-² P VDD 10V

Q: -1500 8012 300 www -200 10 c

A:

Q: Use the routh's criterion to test the stability of the system with the following characteristic…

A:

Q: V(t) sine R1 25 0

A:

Q: 2) What are the salient features of supply voltage control method? Speed control three phase…

A: 2) salient features of supply voltage control method Supply voltage control method is the speed…

Q: For the circuit shown in figure, determine the current and voltage for the resistor R3 using the…

A: We need to find out the current and voltage for given circuit by using of superposition Theorm

Q: A 11 Hp, 4-pole, 60Hz, 3-phase induction motor is taking 10,87 watts from the line. Core loss is 347…

A:

Q: Using Kirchoff's Laws, what is the current flowing at R₁? E1-12 V A) 2 amps B) 4 amps C) 6 amps D) 8…

A: given circuit.

Q: Design a ladder program to run the material mixing system according to the following information: 1-…

A: Given, INPUTS are, I0.0 START PB, I0.1 STOP PB, OUTPUTS are, Q0.0 PUMP1, Q0.1 PUMP2, Q0.2 MIXER…

Q: A 3-phase load consists of three similar inductive coils, each of resistance 50 Ω and inductance 0.3…

A: (i) Star-connected The given load is a three-phase balanced load. When the load is star connected,…

Q: state of charge. The cell has a constant internal resistance of 0.01 0 and reversible (entropic…

A: Formula as, Current: I=dqdt Heat: H = I2Rt

Q: ernal resistance of 0.01 0 and reversible (entropic heating) is assumed to be negligible. H

A: Current: I=dqdt Heat: H = I2Rt

Q: Solve the voltages,currents, and powers.

A: For the given circuit solve for voltages, currents and powers : Didode D1 and D2 are Si diodes,…

Q: Q3) Calculate la, the induced e.m.f., and the output of prime mover for a short - shunt compound…

A: Given, The load current is 50 A The load voltage is 380 V

Q: 0.1 vo 40 92 ww + is 20 Ω 50 µF 100 mH If is= 10cost(30t+20°) A, what is the value of vo(t)? USE…

A:

Q: 2 A sinusoidal Source supplies 35 kvar reactive power to the load 2= 300-500 Determine @ Power…

A:

Q: 2ks2 20V Si Ge Ge Determine the diode current. 2kQ Vo

A:

Q: Determine the approximate value of VDs of Figure 56. 18 V *** -94 6.71 V 5.94 V 4.48 M 3,92 V 750 k…

A:

Q: , what is the total current supplied by the source

A:

Q: Draw the equivalent circuit of long transmission line and derive the equations of sending end…

A: Types of Transmission line Long Transmission line  Medium Transmission line  Short Transmission…

Q: Q10 A 240 v, 4-pole shunt motor running at 1000 r.p.m. gives 15 h.p. with an armature current of 50…

A:

Q: 4. B = 100. Check if approximation can be used. Show calculation proof. If yes, use approximation…

A: Brief description: For the given Bipolar Junction transistor we need to calculate all the DC…

Q: 20 log10|H(0)|, dB Design a circuit that has the asymptotic magnitude Bode plot shown below. Assume…

A:

Q: 3- A: Corona can be affected by some factors, list them stively

A: NOTE- According to the policy we can answer only the first question, kindly post other question as…

Q: i If P; be the iron loss and Pc be the cop- per loss on full-load in a transformer, then which of…

A: Given, At full load, Iron loss = Pi Copper loss = Pc Load factor, x = 3/4 (at maximum efficiency)

Q: Find the current i 30 cos 3t v. the circuit using nodal analysis. V₁ V2 m 0.5H 2012 0.5H in 1. < TI…

A:

Q: a) The graph in Figure 7 shows total current (red) and total voltage (blue) in a series circuit. The…

A: Note: We are authorized to answer one question at a time since you have not mentioned which question…

Q: Find the Laplace Transform of the functions

A: This question belongs to signal and system . It is based on the concept of Laplace transform of the…

Q: Solve for the currents, power and voltages

A: In this question we will find currents , voltage and power....

Q: 2. Using KCL, find the unknown currents (11, 12, 13 and 14 ) for the network shown in the Figure 3.…

A:

Q: Determine the condition on b₁, b2, c₁ and c2, so that the following system is completely…

A:

Q: A 1200 kVA, 6600 volt, 3-phase, Y-connected alternator has an effective resistance of 0.40 ohm and a…

A: Power factor :- It is the ratio of Active power to the Apparent power of the circuit. Power factor=…

Q: Determine the approximate value of lp of Figure 51. 12V $1.5kQ Q1 7.5 mA 4.69 MA 6.12 mA 5.625 mA…

A:

Q: A 10 Hp, 60 Hz, 4 pole, wye connected, 3-phase induction motor at normal operation drawn power from…

A: Induction motor is a self starting motor, doesn't require a external circuit to run that doesn't run…

Q: Q3: 500 kVA is given an open circuit test from which the iron loss is found to be 3.5k W. A short…

A:

Q: b) For kretsen i Figur 3, beregn total resistans (RT). R1 = 4kQ R3 = 8kQ R2 = 1kQ Figur 3. Krets for…

A:

Q: Example 7/ An open wire T-L with G=0.29x 10-6U/Km,L-3.52 mH/Km, C=8.7 nF/Km,R=6.74 KQ/Km at F=1 KHZ,…

A:

Q: Electrical Engineering 4. Solve for Vx 10 3A ↑ 55+Vx 57 20

A: VX calvulated by  first by current division find current in diffrent branch then find vx it js…

Q: Determine the approximate value of VD of the given circuit below.

A: It is given that:

Q: A-Design a two-stage BJT amplifier as shown in the figure with coupling capacitors such that the 3…

A: Frequency response represents a graph drawn between the voltage gain with related to the frequency.…

Q: Bias circuit and line using the VCC RB RC Q1

A:

Q: By using Gauss-Siedal method, the voltage of the bus 2 after two iteration is By using Gauss-Siedal…

A: Initial guess values are:V1=1+j0V2(0)=1+j0V3(0)=1+j0Injected power into the system is:P2=-0.6      ,…

Q: A car is moving at a speed of 10 m/s, so if its speed is doubled due to uniform acceleration within…

A: given linear motion questions

Q: e collector current in

A: BJT (bipolar junction transistor)A transistor having a three terminal made up of semiconductor…

Q: A charge feels a 2.89 x 10-7 N force when it moves 288 m/s perpendicular (90°) to a magnetic field…

A: Given: Force on charge, F=2.89×10-7 N Velocity, v=288 m/s Magnetic field, B=2.77×10-5 T Angle…

Q: 2) Calculate the critical sampling rate for the following signals: i. y(t) = cos(10πt + 20°) +…

A: In this question we need to find a critical sampling rate of the given signal. Critical sampling…

Q: = If (IB = 18μA, Ic = 1.8 mA, VCE = 6v, VBB 8v) design a Base Bias circuit and ensure that the…

A: The required DC bias resistor can be calculated by using DC analysis of the amplifier circuit

Q: An earth electrode consisting of a round section metal pipe of 15 mm diameter is driven in to ground…

A: Earth electrode is a material used for earthing, it can be any conductor buried in the ground.

Q: What is the a+ib form of: - 2+3i Z = (-2-5i)ei 30°

A:

Q: 4s + 12 s² + 8s + 10 4e-4t Option 4 4e¹t+ 4tet O Option 2 +4te-4t 4e4t - 4tet Option 1 None of the…

A:

Q: I need this in 10 mins asap, thank you, I will like your answer

A: